Age | Commit message (Collapse) | Author |
|
instructions.
The Printer will now print instructions with the correct alignment specifier syntax, like
vld1.8 {d16}, [r0:64]
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@175884 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
The new coalescer is better at merging values into unused vector lanes,
improving NEON code.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164794 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164320 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
aligned address. Based on patch by David Peixotto.
Also use vld1.64 / vst1.64 with 128-bit alignment to take advantage of alignment
hints. rdar://12090772, rdar://12238782
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@164089 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
1. Simplify xor/and/or (bitcast(A), bitcast(B)) -> bitcast(op (A,B))
(and also scalar_to_vector).
2. Xor/and/or are indifferent to the swizzle operation (shuffle of one src).
Simplify xor/and/or (shuff(A), shuff(B)) -> shuff(op (A, B))
3. Optimize swizzles of shuffles: shuff(shuff(x, y), undef) -> shuff(x, y).
4. Fix an X86ISelLowering optimization which was very bitcast-sensitive.
Code which was previously compiled to this:
movd (%rsi), %xmm0
movdqa .LCPI0_0(%rip), %xmm2
pshufb %xmm2, %xmm0
movd (%rdi), %xmm1
pshufb %xmm2, %xmm1
pxor %xmm0, %xmm1
pshufb .LCPI0_1(%rip), %xmm1
movd %xmm1, (%rdi)
ret
Now compiles to this:
movl (%rsi), %eax
xorl %eax, (%rdi)
ret
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@153848 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
Canonicallize on the non-suffixed form, but continue to accept assembly that
has any correctly sized type suffix.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@144583 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
As a side effect hex is printed lowercase instead of uppercase now.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@144013 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
to simplify the path towards an auto-generated disassembler.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@135290 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@128680 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
difficult on current ARM implementations for a few reasons.
1. Even though a single vmla has latency that is one cycle shorter than a pair
of vmul + vadd, a RAW hazard during the first (4? on Cortex-a8) can cause
additional pipeline stall. So it's frequently better to single codegen
vmul + vadd.
2. A vmla folowed by a vmul, vmadd, or vsub causes the second fp instruction to
stall for 4 cycles. We need to schedule them apart.
3. A vmla followed vmla is a special case. Obvious issuing back to back RAW
vmla + vmla is very bad. But this isn't ideal either:
vmul
vadd
vmla
Instead, we want to expand the second vmla:
vmla
vmul
vadd
Even with the 4 cycle vmul stall, the second sequence is still 2 cycles
faster.
Up to now, isel simply avoid codegen'ing fp vmla / vmls. This works well enough
but it isn't the optimial solution. This patch attempts to make it possible to
use vmla / vmls in cases where it is profitable.
A. Add missing isel predicates which cause vmla to be codegen'ed.
B. Make sure the fmul in (fadd (fmul)) has a single use. We don't want to
compute a fmul and a fmla.
C. Add additional isel checks for vmla, avoid cases where vmla is feeding into
fp instructions (except for the #3 exceptional case).
D. Add ARM hazard recognizer to model the vmla / vmls hazards.
E. Add a special pre-regalloc case to expand vmla / vmls when it's likely the
vmla / vmls will trigger one of the special hazards.
Work in progress, only A+B are enabled.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@120960 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
1. Fix pre-ra scheduler so it doesn't try to push instructions above calls to
"optimize for latency". Call instructions don't have the right latency and
this is more likely to use introduce spills.
2. Fix if-converter cost function. For ARM, it should use instruction latencies,
not # of micro-ops since multi-latency instructions is completely executed
even when the predicate is false. Also, some instruction will be "slower"
when they are predicated due to the register def becoming implicit input.
rdar://8598427
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@118135 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@116992 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@116987 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
VFP registers.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@116983 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
1. Cortex-A8 load / store multiplies can only issue on ALU0.
2. Eliminate A8_Issue, A8_LSPipe will correctly limit the load / store issues.
3. Correctly model all vld1 and vld2 variants.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@116134 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
callee-saved registers at the end of the lists. Also prefer to avoid using
the low registers that are in register subclasses required by certain
instructions, so that those registers will more likely be available when needed.
This change makes a huge improvement in spilling in some cases. Thanks to
Jakob for helping me realize the problem.
Most of this patch is fixing the testsuite. There are quite a few places
where we're checking for specific registers. I changed those to wildcards
in places where that doesn't weaken the tests. The spill-q.ll and
thumb2-spill-q.ll tests stopped spilling with this change, so I added a bunch
of live values to force spills on those tests.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@116055 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
after regalloc.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@112825 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
Update all the tests using those intrinsics and add support for
auto-upgrading bitcode files with the old versions of the intrinsics.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@112271 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@111696 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
NEON VMOV-immediate instructions. This simplifies some things.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@108275 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
consistency with other instructions that have lists of register operands.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@107944 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
disabled and then never turned back on again. Adjust some tests, one because
this change avoids an unnecessary instruction, and the other to make it
continue testing what it was intended to test.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@107941 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
as many tests as possible.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@106749 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
matches what llvm-gcc and clang now produce.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@106221 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
just return zero.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105061 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
point instructions (and is not using soft float).
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@104307 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
lowering REG_SEQUENCE instructions.
Insert copies for REG_SEQUENCE sources not killed to avoid breaking later passes.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@104146 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
correct register class of the definitions of REG_SEQUENCE.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@104050 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
REG_SEQUENCE instructions.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@103994 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
it with an IMPLICIT_DEF rather than deleting it or else it would be left without a def.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@103984 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@103971 91177308-0d34-0410-b5e6-96231b3b80d8
|
|
Using NEON load / store multiple instructions will no longer create gobs of vmov of D registers!
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@103960 91177308-0d34-0410-b5e6-96231b3b80d8
|