aboutsummaryrefslogtreecommitdiff
path: root/net/dccp/ccids/Kconfig
diff options
context:
space:
mode:
Diffstat (limited to 'net/dccp/ccids/Kconfig')
-rw-r--r--net/dccp/ccids/Kconfig36
1 files changed, 2 insertions, 34 deletions
diff --git a/net/dccp/ccids/Kconfig b/net/dccp/ccids/Kconfig
index 4b5db44970a..8ba3fc9d6d1 100644
--- a/net/dccp/ccids/Kconfig
+++ b/net/dccp/ccids/Kconfig
@@ -1,5 +1,4 @@
-menu "DCCP CCIDs Configuration (EXPERIMENTAL)"
- depends on EXPERIMENTAL
+menu "DCCP CCIDs Configuration"
config IP_DCCP_CCID2_DEBUG
bool "CCID-2 debugging messages"
@@ -12,7 +11,7 @@ config IP_DCCP_CCID2_DEBUG
If in doubt, say N.
config IP_DCCP_CCID3
- bool "CCID-3 (TCP-Friendly) (EXPERIMENTAL)"
+ bool "CCID-3 (TCP-Friendly)"
def_bool y if (IP_DCCP = y || IP_DCCP = m)
---help---
CCID-3 denotes TCP-Friendly Rate Control (TFRC), an equation-based
@@ -47,37 +46,6 @@ config IP_DCCP_CCID3_DEBUG
If in doubt, say N.
-config IP_DCCP_CCID3_RTO
- int "Use higher bound for nofeedback timer"
- default 100
- depends on IP_DCCP_CCID3 && EXPERIMENTAL
- ---help---
- Use higher lower bound for nofeedback timer expiration.
-
- The TFRC nofeedback timer normally expires after the maximum of 4
- RTTs and twice the current send interval (RFC 3448, 4.3). On LANs
- with a small RTT this can mean a high processing load and reduced
- performance, since then the nofeedback timer is triggered very
- frequently.
-
- This option enables to set a higher lower bound for the nofeedback
- value. Values in units of milliseconds can be set here.
-
- A value of 0 disables this feature by enforcing the value specified
- in RFC 3448. The following values have been suggested as bounds for
- experimental use:
- * 16-20ms to match the typical multimedia inter-frame interval
- * 100ms as a reasonable compromise [default]
- * 1000ms corresponds to the lower TCP RTO bound (RFC 2988, 2.4)
-
- The default of 100ms is a compromise between a large value for
- efficient DCCP implementations, and a small value to avoid disrupting
- the network in times of congestion.
-
- The purpose of the nofeedback timer is to slow DCCP down when there
- is serious network congestion: experimenting with larger values should
- therefore not be performed on WANs.
-
config IP_DCCP_TFRC_LIB
def_bool y if IP_DCCP_CCID3