diff options
Diffstat (limited to 'include/media/rc-core.h')
| -rw-r--r-- | include/media/rc-core.h | 84 |
1 files changed, 79 insertions, 5 deletions
diff --git a/include/media/rc-core.h b/include/media/rc-core.h index 2f6f1f78d95..fde142e5f25 100644 --- a/include/media/rc-core.h +++ b/include/media/rc-core.h @@ -1,7 +1,7 @@ /* * Remote Controller core header * - * Copyright (C) 2009-2010 by Mauro Carvalho Chehab <mchehab@redhat.com> + * Copyright (C) 2009-2010 by Mauro Carvalho Chehab * * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License as published by @@ -35,8 +35,32 @@ enum rc_driver_type { }; /** + * struct rc_scancode_filter - Filter scan codes. + * @data: Scancode data to match. + * @mask: Mask of bits of scancode to compare. + */ +struct rc_scancode_filter { + u32 data; + u32 mask; +}; + +/** + * enum rc_filter_type - Filter type constants. + * @RC_FILTER_NORMAL: Filter for normal operation. + * @RC_FILTER_WAKEUP: Filter for waking from suspend. + * @RC_FILTER_MAX: Number of filter types. + */ +enum rc_filter_type { + RC_FILTER_NORMAL = 0, + RC_FILTER_WAKEUP, + + RC_FILTER_MAX +}; + +/** * struct rc_dev - represents a remote control device * @dev: driver model's view of this device + * @sysfs_groups: sysfs attribute groups * @input_name: name of the input child device * @input_phys: physical path to the input child device * @input_id: id of the input child device (struct input_id) @@ -50,8 +74,10 @@ enum rc_driver_type { * @input_dev: the input child device used to communicate events to userspace * @driver_type: specifies if protocol decoding is done in hardware or software * @idle: used to keep track of RX state - * @allowed_protos: bitmask with the supported RC_BIT_* protocols - * @enabled_protocols: bitmask with the enabled RC_BIT_* protocols + * @allowed_protocols: bitmask with the supported RC_BIT_* protocols for each + * filter type + * @enabled_protocols: bitmask with the enabled RC_BIT_* protocols for each + * filter type * @scanmask: some hardware decoders are not capable of providing the full * scancode to the application. As this is a hardware limit, we can't do * anything with it. Yet, as the same keycode table can be used with other @@ -70,7 +96,10 @@ enum rc_driver_type { * @max_timeout: maximum timeout supported by device * @rx_resolution : resolution (in ns) of input sampler * @tx_resolution: resolution (in ns) of output sampler + * @scancode_filters: scancode filters (indexed by enum rc_filter_type) * @change_protocol: allow changing the protocol used on hardware decoders + * @change_wakeup_protocol: allow changing the protocol used for wakeup + * filtering * @open: callback to allow drivers to enable polling/irq when IR input device * is opened. * @close: callback to allow drivers to disable polling/irq when IR input device @@ -84,9 +113,12 @@ enum rc_driver_type { * device doesn't interrupt host until it sees IR pulses * @s_learning_mode: enable wide band receiver used for learning * @s_carrier_report: enable carrier reports + * @s_filter: set the scancode filter + * @s_wakeup_filter: set the wakeup scancode filter */ struct rc_dev { struct device dev; + const struct attribute_group *sysfs_groups[5]; const char *input_name; const char *input_phys; struct input_id input_id; @@ -99,8 +131,8 @@ struct rc_dev { struct input_dev *input_dev; enum rc_driver_type driver_type; bool idle; - u64 allowed_protos; - u64 enabled_protocols; + u64 allowed_protocols[RC_FILTER_MAX]; + u64 enabled_protocols[RC_FILTER_MAX]; u32 users; u32 scanmask; void *priv; @@ -116,7 +148,9 @@ struct rc_dev { u32 max_timeout; u32 rx_resolution; u32 tx_resolution; + struct rc_scancode_filter scancode_filters[RC_FILTER_MAX]; int (*change_protocol)(struct rc_dev *dev, u64 *rc_type); + int (*change_wakeup_protocol)(struct rc_dev *dev, u64 *rc_type); int (*open)(struct rc_dev *dev); void (*close)(struct rc_dev *dev); int (*s_tx_mask)(struct rc_dev *dev, u32 mask); @@ -127,10 +161,50 @@ struct rc_dev { void (*s_idle)(struct rc_dev *dev, bool enable); int (*s_learning_mode)(struct rc_dev *dev, int enable); int (*s_carrier_report) (struct rc_dev *dev, int enable); + int (*s_filter)(struct rc_dev *dev, + struct rc_scancode_filter *filter); + int (*s_wakeup_filter)(struct rc_dev *dev, + struct rc_scancode_filter *filter); }; #define to_rc_dev(d) container_of(d, struct rc_dev, dev) +static inline bool rc_protocols_allowed(struct rc_dev *rdev, u64 protos) +{ + return rdev->allowed_protocols[RC_FILTER_NORMAL] & protos; +} + +/* should be called prior to registration or with mutex held */ +static inline void rc_set_allowed_protocols(struct rc_dev *rdev, u64 protos) +{ + rdev->allowed_protocols[RC_FILTER_NORMAL] = protos; +} + +static inline bool rc_protocols_enabled(struct rc_dev *rdev, u64 protos) +{ + return rdev->enabled_protocols[RC_FILTER_NORMAL] & protos; +} + +/* should be called prior to registration or with mutex held */ +static inline void rc_set_enabled_protocols(struct rc_dev *rdev, u64 protos) +{ + rdev->enabled_protocols[RC_FILTER_NORMAL] = protos; +} + +/* should be called prior to registration or with mutex held */ +static inline void rc_set_allowed_wakeup_protocols(struct rc_dev *rdev, + u64 protos) +{ + rdev->allowed_protocols[RC_FILTER_WAKEUP] = protos; +} + +/* should be called prior to registration or with mutex held */ +static inline void rc_set_enabled_wakeup_protocols(struct rc_dev *rdev, + u64 protos) +{ + rdev->enabled_protocols[RC_FILTER_WAKEUP] = protos; +} + /* * From rc-main.c * Those functions can be used on any type of Remote Controller. They |