diff options
Diffstat (limited to 'include/linux/stmmac.h')
| -rw-r--r-- | include/linux/stmmac.h | 111 |
1 files changed, 98 insertions, 13 deletions
diff --git a/include/linux/stmmac.h b/include/linux/stmmac.h index e1035291569..6f27d4f957b 100644 --- a/include/linux/stmmac.h +++ b/include/linux/stmmac.h @@ -26,33 +26,118 @@ #ifndef __STMMAC_PLATFORM_DATA #define __STMMAC_PLATFORM_DATA -/* platfrom data for platfrom device structure's platfrom_data field */ +#include <linux/platform_device.h> + +#define STMMAC_RX_COE_NONE 0 +#define STMMAC_RX_COE_TYPE1 1 +#define STMMAC_RX_COE_TYPE2 2 + +/* Define the macros for CSR clock range parameters to be passed by + * platform code. + * This could also be configured at run time using CPU freq framework. */ + +/* MDC Clock Selection define*/ +#define STMMAC_CSR_60_100M 0x0 /* MDC = clk_scr_i/42 */ +#define STMMAC_CSR_100_150M 0x1 /* MDC = clk_scr_i/62 */ +#define STMMAC_CSR_20_35M 0x2 /* MDC = clk_scr_i/16 */ +#define STMMAC_CSR_35_60M 0x3 /* MDC = clk_scr_i/26 */ +#define STMMAC_CSR_150_250M 0x4 /* MDC = clk_scr_i/102 */ +#define STMMAC_CSR_250_300M 0x5 /* MDC = clk_scr_i/122 */ + +/* The MDC clock could be set higher than the IEEE 802.3 + * specified frequency limit 0f 2.5 MHz, by programming a clock divider + * of value different than the above defined values. The resultant MDIO + * clock frequency of 12.5 MHz is applicable for the interfacing chips + * supporting higher MDC clocks. + * The MDC clock selection macros need to be defined for MDC clock rate + * of 12.5 MHz, corresponding to the following selection. + */ +#define STMMAC_CSR_I_4 0x8 /* clk_csr_i/4 */ +#define STMMAC_CSR_I_6 0x9 /* clk_csr_i/6 */ +#define STMMAC_CSR_I_8 0xA /* clk_csr_i/8 */ +#define STMMAC_CSR_I_10 0xB /* clk_csr_i/10 */ +#define STMMAC_CSR_I_12 0xC /* clk_csr_i/12 */ +#define STMMAC_CSR_I_14 0xD /* clk_csr_i/14 */ +#define STMMAC_CSR_I_16 0xE /* clk_csr_i/16 */ +#define STMMAC_CSR_I_18 0xF /* clk_csr_i/18 */ + +/* AXI DMA Burst length supported */ +#define DMA_AXI_BLEN_4 (1 << 1) +#define DMA_AXI_BLEN_8 (1 << 2) +#define DMA_AXI_BLEN_16 (1 << 3) +#define DMA_AXI_BLEN_32 (1 << 4) +#define DMA_AXI_BLEN_64 (1 << 5) +#define DMA_AXI_BLEN_128 (1 << 6) +#define DMA_AXI_BLEN_256 (1 << 7) +#define DMA_AXI_BLEN_ALL (DMA_AXI_BLEN_4 | DMA_AXI_BLEN_8 | DMA_AXI_BLEN_16 \ + | DMA_AXI_BLEN_32 | DMA_AXI_BLEN_64 \ + | DMA_AXI_BLEN_128 | DMA_AXI_BLEN_256) + +/* Platfrom data for platform device structure's platform_data field */ + +struct stmmac_mdio_bus_data { + int (*phy_reset)(void *priv); + unsigned int phy_mask; + int *irqs; + int probed_phy_irq; +#ifdef CONFIG_OF + int reset_gpio, active_low; + u32 delays[3]; +#endif +}; + +struct stmmac_dma_cfg { + int pbl; + int fixed_burst; + int mixed_burst; + int burst_len; +}; -/* Private data for the STM on-board ethernet driver */ struct plat_stmmacenet_data { + char *phy_bus_name; int bus_id; - int pbl; + int phy_addr; + int interface; + struct stmmac_mdio_bus_data *mdio_bus_data; + struct stmmac_dma_cfg *dma_cfg; int clk_csr; int has_gmac; int enh_desc; int tx_coe; + int rx_coe; int bugged_jumbo; int pmt; + int force_sf_dma_mode; + int force_thresh_dma_mode; + int riwt_off; + int max_speed; + int maxmtu; void (*fix_mac_speed)(void *priv, unsigned int speed); void (*bus_setup)(void __iomem *ioaddr); - int (*init)(struct platform_device *pdev); - void (*exit)(struct platform_device *pdev); + void *(*setup)(struct platform_device *pdev); + void (*free)(struct platform_device *pdev, void *priv); + int (*init)(struct platform_device *pdev, void *priv); + void (*exit)(struct platform_device *pdev, void *priv); void *custom_cfg; + void *custom_data; void *bsp_priv; }; -struct plat_stmmacphy_data { - int bus_id; - int phy_addr; - unsigned int phy_mask; - int interface; - int (*phy_reset)(void *priv); - void *priv; +/* of_data for SoC glue layer device tree bindings */ + +struct stmmac_of_data { + int has_gmac; + int enh_desc; + int tx_coe; + int rx_coe; + int bugged_jumbo; + int pmt; + int riwt_off; + void (*fix_mac_speed)(void *priv, unsigned int speed); + void (*bus_setup)(void __iomem *ioaddr); + void *(*setup)(struct platform_device *pdev); + void (*free)(struct platform_device *pdev, void *priv); + int (*init)(struct platform_device *pdev, void *priv); + void (*exit)(struct platform_device *pdev, void *priv); }; #endif - |