diff options
Diffstat (limited to 'include/linux/mmc/sdhci.h')
| -rw-r--r-- | include/linux/mmc/sdhci.h | 39 |
1 files changed, 30 insertions, 9 deletions
diff --git a/include/linux/mmc/sdhci.h b/include/linux/mmc/sdhci.h index c750f85177d..08abe994188 100644 --- a/include/linux/mmc/sdhci.h +++ b/include/linux/mmc/sdhci.h @@ -57,12 +57,8 @@ struct sdhci_host { #define SDHCI_QUIRK_BROKEN_CARD_DETECTION (1<<15) /* Controller reports inverted write-protect state */ #define SDHCI_QUIRK_INVERTED_WRITE_PROTECT (1<<16) -/* Controller has nonstandard clock management */ -#define SDHCI_QUIRK_NONSTANDARD_CLOCK (1<<17) /* Controller does not like fast PIO transfers */ #define SDHCI_QUIRK_PIO_NEEDS_DELAY (1<<18) -/* Controller losing signal/interrupt enable states after reset */ -#define SDHCI_QUIRK_RESTORE_IRQS_AFTER_RESET (1<<19) /* Controller has to be forced to use block size of 2048 bytes */ #define SDHCI_QUIRK_FORCE_BLK_SZ_2048 (1<<20) /* Controller cannot do multi-block transfers */ @@ -90,12 +86,26 @@ struct sdhci_host { unsigned int quirks2; /* More deviations from spec. */ +#define SDHCI_QUIRK2_HOST_OFF_CARD_ON (1<<0) +#define SDHCI_QUIRK2_HOST_NO_CMD23 (1<<1) +/* The system physically doesn't support 1.8v, even if the host does */ +#define SDHCI_QUIRK2_NO_1_8_V (1<<2) +#define SDHCI_QUIRK2_PRESET_VALUE_BROKEN (1<<3) +#define SDHCI_QUIRK2_CARD_ON_NEEDS_BUS_ON (1<<4) +/* Controller has a non-standard host control register */ +#define SDHCI_QUIRK2_BROKEN_HOST_CONTROL (1<<5) +/* Controller does not support HS200 */ +#define SDHCI_QUIRK2_BROKEN_HS200 (1<<6) +/* Controller does not support DDR50 */ +#define SDHCI_QUIRK2_BROKEN_DDR50 (1<<7) + int irq; /* Device IRQ */ void __iomem *ioaddr; /* Mapped address */ const struct sdhci_ops *ops; /* Low level hw interface */ - struct regulator *vmmc; /* Power regulator */ + struct regulator *vmmc; /* Power regulator (vmmc) */ + struct regulator *vqmmc; /* Signaling regulator (vccq) */ /* Internal data */ struct mmc_host *mmc; /* MMC structure */ @@ -119,7 +129,8 @@ struct sdhci_host { #define SDHCI_AUTO_CMD23 (1<<7) /* Auto CMD23 support */ #define SDHCI_PV_ENABLED (1<<8) /* Preset value enabled */ #define SDHCI_SDIO_IRQ_ENABLED (1<<9) /* SDIO irq enabled */ -#define SDHCI_HS200_NEEDS_TUNING (1<<10) /* HS200 needs tuning */ +#define SDHCI_SDR104_NEEDS_TUNING (1<<10) /* SDR104/HS200 needs tuning */ +#define SDHCI_USING_RETUNING_TIMER (1<<11) /* Host is using a retuning timer for the card */ unsigned int version; /* SDHCI spec. version */ @@ -131,6 +142,8 @@ struct sdhci_host { u8 pwr; /* Current voltage */ bool runtime_suspended; /* Host is runtime suspended */ + bool bus_on; /* Bus power prevents runtime suspend */ + bool preset_enabled; /* Preset is enabled */ struct mmc_request *mrq; /* Current request */ struct mmc_command *cmd; /* Current command */ @@ -148,16 +161,24 @@ struct sdhci_host { dma_addr_t adma_addr; /* Mapped ADMA descr. table */ dma_addr_t align_addr; /* Mapped bounce buffer */ - struct tasklet_struct card_tasklet; /* Tasklet structures */ - struct tasklet_struct finish_tasklet; + struct tasklet_struct finish_tasklet; /* Tasklet structures */ struct timer_list timer; /* Timer for timeouts */ - unsigned int caps; /* Alternative capabilities */ + u32 caps; /* Alternative CAPABILITY_0 */ + u32 caps1; /* Alternative CAPABILITY_1 */ unsigned int ocr_avail_sdio; /* OCR bit masks */ unsigned int ocr_avail_sd; unsigned int ocr_avail_mmc; + u32 ocr_mask; /* available voltages */ + + unsigned timing; /* Current timing */ + + u32 thread_isr; + + /* cached registers */ + u32 ier; wait_queue_head_t buf_ready_int; /* Waitqueue for Buffer Read Ready interrupt */ unsigned int tuning_done; /* Condition flag set when CMD19 succeeds */ |