diff options
Diffstat (limited to 'drivers/usb/storage/Kconfig')
| -rw-r--r-- | drivers/usb/storage/Kconfig | 25 |
1 files changed, 6 insertions, 19 deletions
diff --git a/drivers/usb/storage/Kconfig b/drivers/usb/storage/Kconfig index 7691c866637..13b5bfbaf95 100644 --- a/drivers/usb/storage/Kconfig +++ b/drivers/usb/storage/Kconfig @@ -4,11 +4,10 @@ comment "NOTE: USB_STORAGE depends on SCSI but BLK_DEV_SD may" comment "also be needed; see USB_STORAGE Help for more info" - depends on USB config USB_STORAGE tristate "USB Mass Storage support" - depends on USB && SCSI + depends on SCSI ---help--- Say Y here if you want to connect USB mass storage devices to your computer's USB port. This is the driver you need for USB @@ -19,7 +18,9 @@ config USB_STORAGE This option depends on 'SCSI' support being enabled, but you probably also need 'SCSI device support: SCSI disk support' - (BLK_DEV_SD) for most USB storage devices. + (BLK_DEV_SD) for most USB storage devices. Some devices also + will require 'Probe all LUNs on each SCSI device' + (SCSI_MULTI_LUN). To compile this driver as a module, choose M here: the module will be called usb-storage. @@ -188,7 +189,7 @@ config USB_STORAGE_CYPRESS_ATACB config USB_STORAGE_ENE_UB6250 tristate "USB ENE card reader support" - depends on USB && SCSI + depends on SCSI depends on USB_STORAGE ---help--- Say Y here if you wish to control a ENE SD/MS Card reader. @@ -203,7 +204,7 @@ config USB_STORAGE_ENE_UB6250 config USB_UAS tristate "USB Attached SCSI" - depends on USB && SCSI + depends on SCSI && USB_STORAGE help The USB Attached SCSI protocol is supported by some USB storage devices. It permits higher performance by supporting @@ -213,17 +214,3 @@ config USB_UAS say 'Y' or 'M' here and the kernel will use the right driver. If you compile this driver as a module, it will be named uas. - -config USB_LIBUSUAL - bool "The shared table of common (or usual) storage devices" - depends on USB - help - This module contains a table of common (or usual) devices - for usb-storage and ub drivers, and allows to switch binding - of these devices without rebuilding modules. - - Typical syntax of /etc/modprobe.d/*conf is: - - options libusual bias="ub" - - If unsure, say N. |