diff options
Diffstat (limited to 'drivers/spi/Kconfig')
| -rw-r--r-- | drivers/spi/Kconfig | 152 |
1 files changed, 115 insertions, 37 deletions
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig index 89cbbabaff4..213b5cbb9dc 100644 --- a/drivers/spi/Kconfig +++ b/drivers/spi/Kconfig @@ -55,7 +55,6 @@ comment "SPI Master Controller Drivers" config SPI_ALTERA tristate "Altera SPI Controller" - depends on GENERIC_HARDIRQS select SPI_BITBANG help This is the driver for the Altera SPI Controller. @@ -70,14 +69,14 @@ config SPI_ATH79 config SPI_ATMEL tristate "Atmel SPI Controller" - depends on (ARCH_AT91 || AVR32) + depends on (ARCH_AT91 || AVR32 || COMPILE_TEST) help This selects a driver for the Atmel SPI Controller, present on many AT32 (AVR32) and AT91 (ARM) chips. config SPI_BCM2835 tristate "BCM2835 SPI controller" - depends on ARCH_BCM2835 + depends on ARCH_BCM2835 || COMPILE_TEST help This selects a driver for the Broadcom BCM2835 SPI master. @@ -88,10 +87,17 @@ config SPI_BCM2835 config SPI_BFIN5XX tristate "SPI controller driver for ADI Blackfin5xx" - depends on BLACKFIN + depends on BLACKFIN && !BF60x help This is the SPI controller master driver for Blackfin 5xx processor. +config SPI_ADI_V3 + tristate "SPI controller v3 for ADI" + depends on BF60x + help + This is the SPI controller v3 master driver + found on Blackfin 60x processor. + config SPI_BFIN_SPORT tristate "SPI bus via Blackfin SPORT" depends on BLACKFIN @@ -112,6 +118,13 @@ config SPI_BCM63XX help Enable support for the SPI controller on the Broadcom BCM63xx SoCs. +config SPI_BCM63XX_HSSPI + tristate "Broadcom BCM63XX HS SPI controller driver" + depends on BCM63XX || COMPILE_TEST + help + This enables support for the High Speed SPI controller present on + newer Broadcom BCM63XX SoCs. + config SPI_BITBANG tristate "Utilities for Bitbanging SPI masters" help @@ -135,9 +148,16 @@ config SPI_BUTTERFLY inexpensive battery powered microcontroller evaluation board. This same cable can be used to flash new firmware. +config SPI_CADENCE + tristate "Cadence SPI controller" + depends on ARM + help + This selects the Cadence SPI controller master driver + used by Xilinx Zynq. + config SPI_CLPS711X tristate "CLPS711X host SPI controller" - depends on ARCH_CLPS711X + depends on ARCH_CLPS711X || COMPILE_TEST help This enables dedicated general purpose SPI/Microwire1-compatible master mode interface (SSI1) for CLPS711X-based CPUs. @@ -151,15 +171,21 @@ config SPI_COLDFIRE_QSPI config SPI_DAVINCI tristate "Texas Instruments DaVinci/DA8x/OMAP-L/AM1x SoC SPI controller" - depends on ARCH_DAVINCI + depends on ARCH_DAVINCI || ARCH_KEYSTONE select SPI_BITBANG - select TI_EDMA help SPI master controller for DaVinci/DA8x/OMAP-L/AM1x SPI modules. +config SPI_EFM32 + tristate "EFM32 SPI controller" + depends on OF && ARM && (ARCH_EFM32 || COMPILE_TEST) + select SPI_BITBANG + help + Driver for the spi controller found on Energy Micro's EFM32 SoCs. + config SPI_EP93XX tristate "Cirrus Logic EP93xx SPI controller" - depends on ARCH_EP93XX + depends on ARCH_EP93XX || COMPILE_TEST help This enables using the Cirrus EP93xx SPI controller in master mode. @@ -191,9 +217,8 @@ config SPI_GPIO config SPI_IMX tristate "Freescale i.MX SPI controllers" - depends on ARCH_MXC + depends on ARCH_MXC || COMPILE_TEST select SPI_BITBANG - default m if IMX_HAVE_PLATFORM_SPI_IMX help This enables using the Freescale i.MX SPI controllers in master mode. @@ -248,6 +273,15 @@ config SPI_FSL_SPI This also enables using the Aeroflex Gaisler GRLIB SPI controller in master mode. +config SPI_FSL_DSPI + tristate "Freescale DSPI controller" + select SPI_BITBANG + select REGMAP_MMIO + depends on SOC_VF610 || COMPILE_TEST + help + This enables support for the Freescale DSPI controller in master + mode. VF610 platform uses the controller. + config SPI_FSL_ESPI bool "Freescale eSPI controller" depends on FSL_SOC @@ -280,20 +314,29 @@ config SPI_OMAP_UWIRE config SPI_OMAP24XX tristate "McSPI driver for OMAP" - depends on ARCH_OMAP2PLUS + depends on ARM || ARM64 || AVR32 || HEXAGON || MIPS || SUPERH + depends on ARCH_OMAP2PLUS || COMPILE_TEST help SPI master controller for OMAP24XX and later Multichannel SPI (McSPI) modules. +config SPI_TI_QSPI + tristate "DRA7xxx QSPI controller support" + depends on ARCH_OMAP2PLUS || COMPILE_TEST + help + QSPI master controller for DRA7xxx used for flash devices. + This device supports single, dual and quad read support, while + it only supports single write mode. + config SPI_OMAP_100K tristate "OMAP SPI 100K" - depends on ARCH_OMAP850 || ARCH_OMAP730 + depends on ARCH_OMAP850 || ARCH_OMAP730 || COMPILE_TEST help OMAP SPI 100K master controller for omap7xx boards. config SPI_ORION tristate "Orion SPI master" - depends on PLAT_ORION + depends on PLAT_ORION || COMPILE_TEST help This enables using the SPI master controller on the Orion chips. @@ -329,7 +372,7 @@ config SPI_PXA2XX_DMA config SPI_PXA2XX tristate "PXA2xx SSP SPI master" - depends on (ARCH_PXA || PCI || ACPI) && GENERIC_HARDIRQS + depends on (ARCH_PXA || PCI || ACPI) select PXA_SSP if ARCH_PXA help This enables using a PXA2xx or Sodaville SSP port as a SPI master @@ -340,10 +383,23 @@ config SPI_PXA2XX_PCI def_tristate SPI_PXA2XX && PCI config SPI_RSPI - tristate "Renesas RSPI controller" - depends on SUPERH + tristate "Renesas RSPI/QSPI controller" + depends on (SUPERH && SH_DMAE_BASE) || ARCH_SHMOBILE help - SPI driver for Renesas RSPI blocks. + SPI driver for Renesas RSPI and QSPI blocks. + +config SPI_QUP + tristate "Qualcomm SPI controller with QUP interface" + depends on ARCH_QCOM || (ARM && COMPILE_TEST) + help + Qualcomm Universal Peripheral (QUP) core is an AHB slave that + provides a common data path (an output FIFO and an input FIFO) + for serial peripheral interface (SPI) mini-core. SPI in master + mode supports up to 50MHz, up to four chip selects, programmable + data path from 4 bits to 32 bits and numerous protocol variants. + + This driver can also be built as a module. If so, the module + will be called spi_qup. config SPI_S3C24XX tristate "Samsung S3C24XX series SPI" @@ -365,8 +421,8 @@ config SPI_S3C24XX_FIQ config SPI_S3C64XX tristate "Samsung S3C64XX series type SPI" - depends on (ARCH_S3C24XX || ARCH_S3C64XX || ARCH_S5P64X0 || ARCH_EXYNOS) - select S3C64XX_DMA if ARCH_S3C64XX + depends on PLAT_SAMSUNG + select S3C64XX_PL080 if ARCH_S3C64XX help SPI driver for Samsung S3C64XX and newer SoCs. @@ -378,14 +434,14 @@ config SPI_SC18IS602 config SPI_SH_MSIOF tristate "SuperH MSIOF SPI controller" - depends on (SUPERH || ARCH_SHMOBILE) && HAVE_CLK - select SPI_BITBANG + depends on HAVE_CLK + depends on SUPERH || ARCH_SHMOBILE || COMPILE_TEST help SPI driver for SuperH and SH Mobile MSIOF blocks. config SPI_SH tristate "SuperH SPI controller" - depends on SUPERH + depends on SUPERH || COMPILE_TEST help SPI driver for SuperH SPI blocks. @@ -398,17 +454,30 @@ config SPI_SH_SCI config SPI_SH_HSPI tristate "SuperH HSPI controller" - depends on ARCH_SHMOBILE + depends on ARCH_SHMOBILE || COMPILE_TEST help SPI driver for SuperH HSPI blocks. config SPI_SIRF tristate "CSR SiRFprimaII SPI controller" - depends on ARCH_SIRF + depends on SIRF_DMA select SPI_BITBANG help SPI driver for CSR SiRFprimaII SoCs +config SPI_SUN4I + tristate "Allwinner A10 SoCs SPI controller" + depends on ARCH_SUNXI || COMPILE_TEST + help + SPI driver for Allwinner sun4i, sun5i and sun7i SoCs + +config SPI_SUN6I + tristate "Allwinner A31 SPI controller" + depends on ARCH_SUNXI || COMPILE_TEST + depends on RESET_CONTROLLER + help + This enables using the SPI controller on the Allwinner A31 SoCs. + config SPI_MXS tristate "Freescale MXS SPI controller" depends on ARCH_MXS @@ -418,7 +487,8 @@ config SPI_MXS config SPI_TEGRA114 tristate "NVIDIA Tegra114 SPI Controller" - depends on ARCH_TEGRA && TEGRA20_APB_DMA + depends on (ARCH_TEGRA && TEGRA20_APB_DMA) || COMPILE_TEST + depends on RESET_CONTROLLER help SPI driver for NVIDIA Tegra114 SPI Controller interface. This controller is different than the older SoCs SPI controller and also register interface @@ -426,7 +496,8 @@ config SPI_TEGRA114 config SPI_TEGRA20_SFLASH tristate "Nvidia Tegra20 Serial flash Controller" - depends on ARCH_TEGRA + depends on ARCH_TEGRA || COMPILE_TEST + depends on RESET_CONTROLLER help SPI driver for Nvidia Tegra20 Serial flash Controller interface. The main usecase of this controller is to use spi flash as boot @@ -434,20 +505,14 @@ config SPI_TEGRA20_SFLASH config SPI_TEGRA20_SLINK tristate "Nvidia Tegra20/Tegra30 SLINK Controller" - depends on ARCH_TEGRA && TEGRA20_APB_DMA + depends on (ARCH_TEGRA && TEGRA20_APB_DMA) || COMPILE_TEST + depends on RESET_CONTROLLER help SPI driver for Nvidia Tegra20/Tegra30 SLINK Controller interface. -config SPI_TI_SSP - tristate "TI Sequencer Serial Port - SPI Support" - depends on MFD_TI_SSP - help - This selects an SPI master implementation using a TI sequencer - serial port. - config SPI_TOPCLIFF_PCH tristate "Intel EG20T PCH/LAPIS Semicon IOH(ML7213/ML7223/ML7831) SPI" - depends on PCI + depends on PCI && (X86_32 || COMPILE_TEST) help SPI driver for the Topcliff PCH (Platform Controller Hub) SPI bus used in some x86 embedded processors. @@ -457,7 +522,7 @@ config SPI_TOPCLIFF_PCH config SPI_TXX9 tristate "Toshiba TXx9 SPI controller" - depends on GPIOLIB && CPU_TX49XX + depends on GPIOLIB && (CPU_TX49XX || COMPILE_TEST) help SPI driver for Toshiba TXx9 MIPS SoCs @@ -480,6 +545,19 @@ config SPI_XILINX Or for the DS570, see "XPS Serial Peripheral Interface (SPI) (v2.00b)" +config SPI_XTENSA_XTFPGA + tristate "Xtensa SPI controller for xtfpga" + depends on (XTENSA && XTENSA_PLATFORM_XTFPGA) || COMPILE_TEST + select SPI_BITBANG + help + SPI driver for xtfpga SPI master controller. + + This simple SPI master controller is built into xtfpga bitstreams + and is used to control daughterboard audio codec. It always transfers + 16 bit words in SPI mode 0, automatically asserting CS on transfer + start and deasserting on end. + + config SPI_NUC900 tristate "Nuvoton NUC900 series SPI" depends on ARCH_W90X900 @@ -506,7 +584,7 @@ config SPI_DW_MID_DMA config SPI_DW_MMIO tristate "Memory-mapped io interface driver for DW SPI core" - depends on SPI_DESIGNWARE && HAVE_CLK + depends on SPI_DESIGNWARE # # There are lots of SPI device types, with sensors and memory |