diff options
Diffstat (limited to 'drivers/net/wireless/iwlwifi/iwl-csr.h')
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-csr.h | 69 |
1 files changed, 62 insertions, 7 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-csr.h b/drivers/net/wireless/iwlwifi/iwl-csr.h index 20e845d4da0..fe129c94ae3 100644 --- a/drivers/net/wireless/iwlwifi/iwl-csr.h +++ b/drivers/net/wireless/iwlwifi/iwl-csr.h @@ -5,7 +5,7 @@ * * GPL LICENSE SUMMARY * - * Copyright(c) 2005 - 2013 Intel Corporation. All rights reserved. + * Copyright(c) 2005 - 2014 Intel Corporation. All rights reserved. * * This program is free software; you can redistribute it and/or modify * it under the terms of version 2 of the GNU General Public License as @@ -30,7 +30,7 @@ * * BSD LICENSE * - * Copyright(c) 2005 - 2013 Intel Corporation. All rights reserved. + * Copyright(c) 2005 - 2014 Intel Corporation. All rights reserved. * All rights reserved. * * Redistribution and use in source and binary forms, with or without @@ -139,6 +139,13 @@ #define CSR_ANA_PLL_CFG (CSR_BASE+0x20c) /* + * CSR HW resources monitor registers + */ +#define CSR_MONITOR_CFG_REG (CSR_BASE+0x214) +#define CSR_MONITOR_STATUS_REG (CSR_BASE+0x228) +#define CSR_MONITOR_XTAL_RESOURCES (0x00000010) + +/* * CSR Hardware Revision Workaround Register. Indicates hardware rev; * "step" determines CCK backoff for txpower calculation. Used for 4965 only. * See also CSR_HW_REV register. @@ -173,6 +180,7 @@ #define CSR_HW_IF_CONFIG_REG_BIT_NIC_READY (0x00400000) /* PCI_OWN_SEM */ #define CSR_HW_IF_CONFIG_REG_BIT_NIC_PREPARE_DONE (0x02000000) /* ME_OWN */ #define CSR_HW_IF_CONFIG_REG_PREPARE (0x08000000) /* WAKE_ME */ +#define CSR_HW_IF_CONFIG_REG_PERSIST_MODE (0x40000000) /* PERSISTENCE */ #define CSR_INT_PERIODIC_DIS (0x00) /* disable periodic int*/ #define CSR_INT_PERIODIC_ENA (0xFF) /* 255*32 usec ~ 8 msec*/ @@ -198,7 +206,8 @@ CSR_INT_BIT_RF_KILL | \ CSR_INT_BIT_SW_RX | \ CSR_INT_BIT_WAKEUP | \ - CSR_INT_BIT_ALIVE) + CSR_INT_BIT_ALIVE | \ + CSR_INT_BIT_RX_PERIODIC) /* interrupt flags in FH (flow handler) (PCI busmaster DMA) */ #define CSR_FH_INT_BIT_ERR (1 << 31) /* Error */ @@ -239,6 +248,7 @@ * 001 -- MAC power-down * 010 -- PHY (radio) power-down * 011 -- Error + * 10: XTAL ON request * 9-6: SYS_CONFIG * Indicates current system configuration, reflecting pins on chip * as forced high/low by device circuit board. @@ -270,6 +280,7 @@ #define CSR_GP_CNTRL_REG_FLAG_INIT_DONE (0x00000004) #define CSR_GP_CNTRL_REG_FLAG_MAC_ACCESS_REQ (0x00000008) #define CSR_GP_CNTRL_REG_FLAG_GOING_TO_SLEEP (0x00000010) +#define CSR_GP_CNTRL_REG_FLAG_XTAL_ON (0x00000400) #define CSR_GP_CNTRL_REG_VAL_MAC_ACCESS_EN (0x00000001) @@ -395,6 +406,34 @@ #define CSR_DRAM_INIT_TBL_WRAP_CHECK (1 << 27) /* + * SHR target access (Shared block memory space) + * + * Shared internal registers can be accessed directly from PCI bus through SHR + * arbiter without need for the MAC HW to be powered up. This is possible due to + * indirect read/write via HEEP_CTRL_WRD_PCIEX_CTRL (0xEC) and + * HEEP_CTRL_WRD_PCIEX_DATA (0xF4) registers. + * + * Use iwl_write32()/iwl_read32() family to access these registers. The MAC HW + * need not be powered up so no "grab inc access" is required. + */ + +/* + * Registers for accessing shared registers (e.g. SHR_APMG_GP1, + * SHR_APMG_XTAL_CFG). For example, to read from SHR_APMG_GP1 register (0x1DC), + * first, write to the control register: + * HEEP_CTRL_WRD_PCIEX_CTRL[15:0] = 0x1DC (offset of the SHR_APMG_GP1 register) + * HEEP_CTRL_WRD_PCIEX_CTRL[29:28] = 2 (read access) + * second, read from the data register HEEP_CTRL_WRD_PCIEX_DATA[31:0]. + * + * To write the register, first, write to the data register + * HEEP_CTRL_WRD_PCIEX_DATA[31:0] and then: + * HEEP_CTRL_WRD_PCIEX_CTRL[15:0] = 0x1DC (offset of the SHR_APMG_GP1 register) + * HEEP_CTRL_WRD_PCIEX_CTRL[29:28] = 3 (write access) + */ +#define HEEP_CTRL_WRD_PCIEX_CTRL_REG (CSR_BASE+0x0ec) +#define HEEP_CTRL_WRD_PCIEX_DATA_REG (CSR_BASE+0x0f4) + +/* * HBUS (Host-side Bus) * * HBUS registers are mapped directly into PCI bus space, but are used @@ -463,13 +502,29 @@ * the CSR_INT_COALESCING is an 8 bit register in 32-usec unit * * default interrupt coalescing timer is 64 x 32 = 2048 usecs - * default interrupt coalescing calibration timer is 16 x 32 = 512 usecs */ #define IWL_HOST_INT_TIMEOUT_MAX (0xFF) #define IWL_HOST_INT_TIMEOUT_DEF (0x40) #define IWL_HOST_INT_TIMEOUT_MIN (0x0) -#define IWL_HOST_INT_CALIB_TIMEOUT_MAX (0xFF) -#define IWL_HOST_INT_CALIB_TIMEOUT_DEF (0x10) -#define IWL_HOST_INT_CALIB_TIMEOUT_MIN (0x0) +#define IWL_HOST_INT_OPER_MODE BIT(31) + +/***************************************************************************** + * 7000/3000 series SHR DTS addresses * + *****************************************************************************/ + +/* Diode Results Register Structure: */ +enum dtd_diode_reg { + DTS_DIODE_REG_DIG_VAL = 0x000000FF, /* bits [7:0] */ + DTS_DIODE_REG_VREF_LOW = 0x0000FF00, /* bits [15:8] */ + DTS_DIODE_REG_VREF_HIGH = 0x00FF0000, /* bits [23:16] */ + DTS_DIODE_REG_VREF_ID = 0x03000000, /* bits [25:24] */ + DTS_DIODE_REG_PASS_ONCE = 0x80000000, /* bits [31:31] */ + DTS_DIODE_REG_FLAGS_MSK = 0xFF000000, /* bits [31:24] */ +/* Those are the masks INSIDE the flags bit-field: */ + DTS_DIODE_REG_FLAGS_VREFS_ID_POS = 0, + DTS_DIODE_REG_FLAGS_VREFS_ID = 0x00000003, /* bits [1:0] */ + DTS_DIODE_REG_FLAGS_PASS_ONCE_POS = 7, + DTS_DIODE_REG_FLAGS_PASS_ONCE = 0x00000080, /* bits [7:7] */ +}; #endif /* !__iwl_csr_h__ */ |