1 files changed, 0 insertions, 46 deletions
diff --git a/drivers/net/arm/Kconfig b/drivers/net/arm/Kconfig
deleted file mode 100644
index 470364deded..00000000000
--- a/drivers/net/arm/Kconfig
+++ /dev/null
@@ -1,46 +0,0 @@
-#
-# Acorn Network device configuration
-#  These are for Acorn's Expansion card network interfaces
-#
-config ARM_AM79C961A
-	bool "ARM EBSA110 AM79C961A support"
-	depends on NET_ETHERNET && ARM && ARCH_EBSA110
-	select CRC32
-	help
-	  If you wish to compile a kernel for the EBSA-110, then you should
-	  always answer Y to this.
-
-config ARM_ETHER1
-	tristate "Acorn Ether1 support"
-	depends on NET_ETHERNET && ARM && ARCH_ACORN
-	help
-	  If you have an Acorn system with one of these (AKA25) network cards,
-	  you should say Y to this option if you wish to use it with Linux.
-
-config ARM_ETHER3
-	tristate "Acorn/ANT Ether3 support"
-	depends on NET_ETHERNET && ARM && ARCH_ACORN
-	help
-	  If you have an Acorn system with one of these network cards, you
-	  should say Y to this option if you wish to use it with Linux.
-
-config ARM_ETHERH
-	tristate "I-cubed EtherH/ANT EtherM support"
-	depends on NET_ETHERNET && ARM && ARCH_ACORN
-	select CRC32
-	help
-	  If you have an Acorn system with one of these network cards, you
-	  should say Y to this option if you wish to use it with Linux.
-
-config ARM_ETHER00
-	tristate "Altera Ether00 support"
-	depends on NET_ETHERNET && ARM && ARCH_CAMELOT
-	help
-	  This is the driver for Altera's ether00 ethernet mac IP core. Say
-	  Y here if you want to build support for this into the kernel. It
-	  is also available as a module (say M here) that can be inserted/
-	  removed from the kernel at the same time as the PLD is configured.
-	  If this driver is running on an epxa10 development board then it
-	  will generate a suitable hw address based on the board serial
-	  number (MTD support is required for this). Otherwise you will
-	  need to set a suitable hw address using ifconfig.