diff options
Diffstat (limited to 'arch/mips/sibyte/bcm1480')
| -rw-r--r-- | arch/mips/sibyte/bcm1480/irq.c | 22 | ||||
| -rw-r--r-- | arch/mips/sibyte/bcm1480/setup.c | 3 | ||||
| -rw-r--r-- | arch/mips/sibyte/bcm1480/smp.c | 25 |
3 files changed, 15 insertions, 35 deletions
diff --git a/arch/mips/sibyte/bcm1480/irq.c b/arch/mips/sibyte/bcm1480/irq.c index 09740d60e18..373fbbc8425 100644 --- a/arch/mips/sibyte/bcm1480/irq.c +++ b/arch/mips/sibyte/bcm1480/irq.c @@ -27,7 +27,6 @@ #include <asm/errno.h> #include <asm/irq_regs.h> #include <asm/signal.h> -#include <asm/system.h> #include <asm/io.h> #include <asm/sibyte/bcm1480_regs.h> @@ -96,7 +95,7 @@ static int bcm1480_set_affinity(struct irq_data *d, const struct cpumask *mask, u64 cur_ints; unsigned long flags; - i = cpumask_first(mask); + i = cpumask_first_and(mask, cpu_online_mask); /* Convert logical CPU to physical CPU */ cpu = cpu_logical_map(i); @@ -284,10 +283,10 @@ void __init arch_init_irq(void) for (cpu = 0; cpu < 4; cpu++) { __raw_writeq(IMR_IP3_VAL, IOADDR(A_BCM1480_IMR_REGISTER(cpu, R_BCM1480_IMR_INTERRUPT_MAP_BASE_H) + (K_BCM1480_INT_MBOX_0_0 << 3))); - } + } - /* Clear the mailboxes. The firmware may leave them dirty */ + /* Clear the mailboxes. The firmware may leave them dirty */ for (cpu = 0; cpu < 4; cpu++) { __raw_writeq(0xffffffffffffffffULL, IOADDR(A_BCM1480_IMR_REGISTER(cpu, R_BCM1480_IMR_MAILBOX_0_CLR_CPU))); @@ -308,7 +307,7 @@ void __init arch_init_irq(void) /* * Note that the timer interrupts are also mapped, but this is - * done in bcm1480_time_init(). Also, the profiling driver + * done in bcm1480_time_init(). Also, the profiling driver * does its own management of IP7. */ @@ -326,7 +325,7 @@ static inline void dispatch_ip2(void) /* * Default...we've hit an IP[2] interrupt, which means we've got to - * check the 1480 interrupt registers to figure out what to do. Need + * check the 1480 interrupt registers to figure out what to do. Need * to detect which CPU we're on, now that smp_affinity is supported. */ base = A_BCM1480_IMR_MAPPER(cpu); @@ -348,19 +347,8 @@ asmlinkage void plat_irq_dispatch(void) unsigned int cpu = smp_processor_id(); unsigned int pending; -#ifdef CONFIG_SIBYTE_BCM1480_PROF - /* Set compare to count to silence count/compare timer interrupts */ - write_c0_compare(read_c0_count()); -#endif - pending = read_c0_cause() & read_c0_status(); -#ifdef CONFIG_SIBYTE_BCM1480_PROF - if (pending & CAUSEF_IP7) /* Cpu performance counter interrupt */ - sbprof_cpu_intr(); - else -#endif - if (pending & CAUSEF_IP4) do_IRQ(K_BCM1480_INT_TIMER_0 + cpu); #ifdef CONFIG_SMP diff --git a/arch/mips/sibyte/bcm1480/setup.c b/arch/mips/sibyte/bcm1480/setup.c index 05ed92c92b6..8e2e04f7787 100644 --- a/arch/mips/sibyte/bcm1480/setup.c +++ b/arch/mips/sibyte/bcm1480/setup.c @@ -22,6 +22,7 @@ #include <linux/string.h> #include <asm/bootinfo.h> +#include <asm/cpu.h> #include <asm/mipsregs.h> #include <asm/io.h> #include <asm/sibyte/sb1250.h> @@ -119,7 +120,7 @@ void __init bcm1480_setup(void) uint64_t sys_rev; int plldiv; - sb1_pass = read_c0_prid() & 0xff; + sb1_pass = read_c0_prid() & PRID_REV_MASK; sys_rev = __raw_readq(IOADDR(A_SCD_SYSTEM_REVISION)); soc_type = SYS_SOC_TYPE(sys_rev); part_type = G_SYS_PART(sys_rev); diff --git a/arch/mips/sibyte/bcm1480/smp.c b/arch/mips/sibyte/bcm1480/smp.c index d667875be56..af7d44edd9a 100644 --- a/arch/mips/sibyte/bcm1480/smp.c +++ b/arch/mips/sibyte/bcm1480/smp.c @@ -60,7 +60,7 @@ static void *mailbox_0_regs[] = { /* * SMP init and finish on secondary CPUs */ -void __cpuinit bcm1480_smp_init(void) +void bcm1480_smp_init(void) { unsigned int imask = STATUSF_IP4 | STATUSF_IP3 | STATUSF_IP2 | STATUSF_IP1 | STATUSF_IP0; @@ -95,7 +95,7 @@ static void bcm1480_send_ipi_mask(const struct cpumask *mask, /* * Code to run on secondary just after probing the CPU */ -static void __cpuinit bcm1480_init_secondary(void) +static void bcm1480_init_secondary(void) { extern void bcm1480_smp_init(void); @@ -106,7 +106,7 @@ static void __cpuinit bcm1480_init_secondary(void) * Do any tidying up before marking online and running the idle * loop */ -static void __cpuinit bcm1480_smp_finish(void) +static void bcm1480_smp_finish(void) { extern void sb1480_clockevent_init(void); @@ -115,17 +115,10 @@ static void __cpuinit bcm1480_smp_finish(void) } /* - * Final cleanup after all secondaries booted - */ -static void bcm1480_cpus_done(void) -{ -} - -/* * Setup the PC, SP, and GP of a secondary processor and start it * running! */ -static void __cpuinit bcm1480_boot_secondary(int cpu, struct task_struct *idle) +static void bcm1480_boot_secondary(int cpu, struct task_struct *idle) { int retval; @@ -138,7 +131,7 @@ static void __cpuinit bcm1480_boot_secondary(int cpu, struct task_struct *idle) /* * Use CFE to find out how many CPUs are available, setting up - * cpu_possible_map and the logical/physical mappings. + * cpu_possible_mask and the logical/physical mappings. * XXXKW will the boot CPU ever not be physical 0? * * Common setup before any secondaries are started @@ -147,14 +140,13 @@ static void __init bcm1480_smp_setup(void) { int i, num; - cpus_clear(cpu_possible_map); - cpu_set(0, cpu_possible_map); + init_cpu_possible(cpumask_of(0)); __cpu_number_map[0] = 0; __cpu_logical_map[0] = 0; for (i = 1, num = 0; i < NR_CPUS; i++) { if (cfe_cpu_stop(i) == 0) { - cpu_set(i, cpu_possible_map); + set_cpu_possible(i, true); __cpu_number_map[i] = ++num; __cpu_logical_map[num] = i; } @@ -171,7 +163,6 @@ struct plat_smp_ops bcm1480_smp_ops = { .send_ipi_mask = bcm1480_send_ipi_mask, .init_secondary = bcm1480_init_secondary, .smp_finish = bcm1480_smp_finish, - .cpus_done = bcm1480_cpus_done, .boot_secondary = bcm1480_boot_secondary, .smp_setup = bcm1480_smp_setup, .prepare_cpus = bcm1480_prepare_cpus, @@ -183,7 +174,7 @@ void bcm1480_mailbox_interrupt(void) int irq = K_BCM1480_INT_MBOX_0_0; unsigned int action; - kstat_incr_irqs_this_cpu(irq, irq_to_desc(irq)); + kstat_incr_irq_this_cpu(irq); /* Load the mailbox register to figure out what we're supposed to do */ action = (__raw_readq(mailbox_0_regs[cpu]) >> 48) & 0xffff; |