diff options
Diffstat (limited to 'arch/mips/alchemy/common/setup.c')
| -rw-r--r-- | arch/mips/alchemy/common/setup.c | 26 |
1 files changed, 21 insertions, 5 deletions
diff --git a/arch/mips/alchemy/common/setup.c b/arch/mips/alchemy/common/setup.c index 561e5da2658..8267e3c9772 100644 --- a/arch/mips/alchemy/common/setup.c +++ b/arch/mips/alchemy/common/setup.c @@ -30,6 +30,7 @@ #include <linux/jiffies.h> #include <linux/module.h> +#include <asm/dma-coherence.h> #include <asm/mipsregs.h> #include <asm/time.h> @@ -52,8 +53,6 @@ void __init plat_mem_setup(void) /* this is faster than wasting cycles trying to approximate it */ preset_lpj = (est_freq >> 1) / HZ; - board_setup(); /* board specific setup */ - if (au1xxx_cpu_needs_config_od()) /* Various early Au1xx0 errata corrected by this */ set_c0_config(1 << 19); /* Set Config[OD] */ @@ -61,6 +60,23 @@ void __init plat_mem_setup(void) /* Clear to obtain best system bus performance */ clear_c0_config(1 << 19); /* Clear Config[OD] */ + hw_coherentio = 0; + coherentio = 1; + switch (alchemy_get_cputype()) { + case ALCHEMY_CPU_AU1000: + case ALCHEMY_CPU_AU1500: + case ALCHEMY_CPU_AU1100: + coherentio = 0; + break; + case ALCHEMY_CPU_AU1200: + /* Au1200 AB USB does not support coherent memory */ + if (0 == (read_c0_prid() & PRID_REV_MASK)) + coherentio = 0; + break; + } + + board_setup(); /* board specific setup */ + /* IO/MEM resources. */ set_io_port_base(0); ioport_resource.start = IOPORT_RESOURCE_START; @@ -73,8 +89,8 @@ void __init plat_mem_setup(void) /* This routine should be valid for all Au1x based boards */ phys_t __fixup_bigphys_addr(phys_t phys_addr, phys_t size) { - u32 start = (u32)Au1500_PCI_MEM_START; - u32 end = (u32)Au1500_PCI_MEM_END; + unsigned long start = ALCHEMY_PCI_MEMWIN_START; + unsigned long end = ALCHEMY_PCI_MEMWIN_END; /* Don't fixup 36-bit addresses */ if ((phys_addr >> 32) != 0) @@ -82,7 +98,7 @@ phys_t __fixup_bigphys_addr(phys_t phys_addr, phys_t size) /* Check for PCI memory window */ if (phys_addr >= start && (phys_addr + size - 1) <= end) - return (phys_t)((phys_addr - start) + Au1500_PCI_MEM_START); + return (phys_t)(AU1500_PCI_MEM_PHYS_ADDR + phys_addr); /* default nop */ return phys_addr; |