diff options
Diffstat (limited to 'arch/avr32/mach-at32ap/include')
| -rw-r--r-- | arch/avr32/mach-at32ap/include/mach/atmel-mci.h | 7 | ||||
| -rw-r--r-- | arch/avr32/mach-at32ap/include/mach/board.h | 31 | ||||
| -rw-r--r-- | arch/avr32/mach-at32ap/include/mach/cpu.h | 11 | ||||
| -rw-r--r-- | arch/avr32/mach-at32ap/include/mach/pm.h | 24 |
4 files changed, 15 insertions, 58 deletions
diff --git a/arch/avr32/mach-at32ap/include/mach/atmel-mci.h b/arch/avr32/mach-at32ap/include/mach/atmel-mci.h index a9b38967f70..4bba58561d5 100644 --- a/arch/avr32/mach-at32ap/include/mach/atmel-mci.h +++ b/arch/avr32/mach-at32ap/include/mach/atmel-mci.h @@ -14,11 +14,4 @@ struct mci_dma_data { #define slave_data_ptr(s) (&(s)->sdata) #define find_slave_dev(s) ((s)->sdata.dma_dev) -#define setup_dma_addr(s, t, r) do { \ - if (s) { \ - (s)->sdata.tx_reg = (t); \ - (s)->sdata.rx_reg = (r); \ - } \ -} while (0) - #endif /* __MACH_ATMEL_MCI_H */ diff --git a/arch/avr32/mach-at32ap/include/mach/board.h b/arch/avr32/mach-at32ap/include/mach/board.h index 679458d9a62..f1a316d52c7 100644 --- a/arch/avr32/mach-at32ap/include/mach/board.h +++ b/arch/avr32/mach-at32ap/include/mach/board.h @@ -6,6 +6,8 @@ #include <linux/types.h> #include <linux/serial.h> +#include <linux/platform_data/macb.h> +#include <linux/platform_data/atmel.h> #define GPIO_PIN_NONE (-1) @@ -24,7 +26,6 @@ static inline void __deprecated at32_add_system_devices(void) } -#define ATMEL_MAX_UART 4 extern struct platform_device *atmel_default_console_device; /* Flags for selecting USART extra pins */ @@ -32,31 +33,20 @@ extern struct platform_device *atmel_default_console_device; #define ATMEL_USART_CTS 0x02 #define ATMEL_USART_CLK 0x04 -struct atmel_uart_data { - int num; /* port num */ - short use_dma_tx; /* use transmit DMA? */ - short use_dma_rx; /* use receive DMA? */ - void __iomem *regs; /* virtual base address, if any */ - struct serial_rs485 rs485; /* rs485 settings */ -}; void at32_map_usart(unsigned int hw_id, unsigned int line, int flags); struct platform_device *at32_add_device_usart(unsigned int id); -struct eth_platform_data { - u32 phy_mask; - u8 is_rmii; -}; struct platform_device * -at32_add_device_eth(unsigned int id, struct eth_platform_data *data); +at32_add_device_eth(unsigned int id, struct macb_platform_data *data); struct spi_board_info; struct platform_device * at32_add_device_spi(unsigned int id, struct spi_board_info *b, unsigned int n); void at32_spi_setup_slaves(unsigned int bus_num, struct spi_board_info *b, unsigned int n); -struct atmel_lcdfb_info; +struct atmel_lcdfb_pdata; struct platform_device * -at32_add_device_lcdc(unsigned int id, struct atmel_lcdfb_info *data, +at32_add_device_lcdc(unsigned int id, struct atmel_lcdfb_pdata *data, unsigned long fbmem_start, unsigned long fbmem_len, u64 pin_mask); @@ -119,17 +109,6 @@ struct platform_device * at32_add_device_cf(unsigned int id, unsigned int extint, struct cf_platform_data *data); -/* NAND / SmartMedia */ -struct atmel_nand_data { - int enable_pin; /* chip enable */ - int det_pin; /* card detect */ - int rdy_pin; /* ready/busy */ - u8 rdy_pin_active_low; /* rdy_pin value is inverted */ - u8 ale; /* address line number connected to ALE */ - u8 cle; /* address line number connected to CLE */ - u8 bus_width_16; /* buswidth is 16 bit */ - struct mtd_partition *(*partition_info)(int size, int *num_partitions); -}; struct platform_device * at32_add_device_nand(unsigned int id, struct atmel_nand_data *data); diff --git a/arch/avr32/mach-at32ap/include/mach/cpu.h b/arch/avr32/mach-at32ap/include/mach/cpu.h index 9c96a130f3a..16a24b14146 100644 --- a/arch/avr32/mach-at32ap/include/mach/cpu.h +++ b/arch/avr32/mach-at32ap/include/mach/cpu.h @@ -30,9 +30,18 @@ #define cpu_is_at91sam9261() (0) #define cpu_is_at91sam9263() (0) #define cpu_is_at91sam9rl() (0) -#define cpu_is_at91cap9() (0) #define cpu_is_at91sam9g10() (0) +#define cpu_is_at91sam9g20() (0) #define cpu_is_at91sam9g45() (0) #define cpu_is_at91sam9g45es() (0) +#define cpu_is_at91sam9m10() (0) +#define cpu_is_at91sam9g46() (0) +#define cpu_is_at91sam9m11() (0) +#define cpu_is_at91sam9x5() (0) +#define cpu_is_at91sam9g15() (0) +#define cpu_is_at91sam9g35() (0) +#define cpu_is_at91sam9x35() (0) +#define cpu_is_at91sam9g25() (0) +#define cpu_is_at91sam9x25() (0) #endif /* __ASM_ARCH_CPU_H */ diff --git a/arch/avr32/mach-at32ap/include/mach/pm.h b/arch/avr32/mach-at32ap/include/mach/pm.h index 979b355b77b..f29ff2cd23d 100644 --- a/arch/avr32/mach-at32ap/include/mach/pm.h +++ b/arch/avr32/mach-at32ap/include/mach/pm.h @@ -21,30 +21,6 @@ extern void cpu_enter_idle(void); extern void cpu_enter_standby(unsigned long sdramc_base); -extern bool disable_idle_sleep; - -static inline void cpu_disable_idle_sleep(void) -{ - disable_idle_sleep = true; -} - -static inline void cpu_enable_idle_sleep(void) -{ - disable_idle_sleep = false; -} - -static inline void cpu_idle_sleep(void) -{ - /* - * If we're using the COUNT and COMPARE registers for - * timekeeping, we can't use the IDLE state. - */ - if (disable_idle_sleep) - cpu_relax(); - else - cpu_enter_idle(); -} - void intc_set_suspend_handler(unsigned long offset); #endif |
