diff options
Diffstat (limited to 'arch/arm/mach-nomadik/board-nhk8815.c')
| -rw-r--r-- | arch/arm/mach-nomadik/board-nhk8815.c | 284 |
1 files changed, 0 insertions, 284 deletions
diff --git a/arch/arm/mach-nomadik/board-nhk8815.c b/arch/arm/mach-nomadik/board-nhk8815.c deleted file mode 100644 index 139930350d9..00000000000 --- a/arch/arm/mach-nomadik/board-nhk8815.c +++ /dev/null @@ -1,284 +0,0 @@ -/* - * linux/arch/arm/mach-nomadik/board-8815nhk.c - * - * Copyright (C) STMicroelectronics - * - * This program is free software; you can redistribute it and/or modify - * it under the terms of the GNU General Public License version 2, as - * published by the Free Software Foundation. - * - * NHK15 board specifc driver definition - */ -#include <linux/types.h> -#include <linux/kernel.h> -#include <linux/init.h> -#include <linux/platform_device.h> -#include <linux/amba/bus.h> -#include <linux/interrupt.h> -#include <linux/gpio.h> -#include <linux/mtd/mtd.h> -#include <linux/mtd/nand.h> -#include <linux/mtd/onenand.h> -#include <linux/mtd/partitions.h> -#include <linux/io.h> -#include <asm/sizes.h> -#include <asm/mach-types.h> -#include <asm/mach/arch.h> -#include <asm/mach/irq.h> -#include <asm/mach/flash.h> - -#include <plat/mtu.h> - -#include <mach/setup.h> -#include <mach/nand.h> -#include <mach/fsmc.h> - -/* Initial value for SRC control register: all timers use MXTAL/8 source */ -#define SRC_CR_INIT_MASK 0x00007fff -#define SRC_CR_INIT_VAL 0x2aaa8000 - -/* These addresses span 16MB, so use three individual pages */ -static struct resource nhk8815_nand_resources[] = { - { - .name = "nand_addr", - .start = NAND_IO_ADDR, - .end = NAND_IO_ADDR + 0xfff, - .flags = IORESOURCE_MEM, - }, { - .name = "nand_cmd", - .start = NAND_IO_CMD, - .end = NAND_IO_CMD + 0xfff, - .flags = IORESOURCE_MEM, - }, { - .name = "nand_data", - .start = NAND_IO_DATA, - .end = NAND_IO_DATA + 0xfff, - .flags = IORESOURCE_MEM, - } -}; - -static int nhk8815_nand_init(void) -{ - /* FSMC setup for nand chip select (8-bit nand in 8815NHK) */ - writel(0x0000000E, FSMC_PCR(0)); - writel(0x000D0A00, FSMC_PMEM(0)); - writel(0x00100A00, FSMC_PATT(0)); - - /* enable access to the chip select area */ - writel(readl(FSMC_PCR(0)) | 0x04, FSMC_PCR(0)); - - return 0; -} - -/* - * These partitions are the same as those used in the 2.6.20 release - * shipped by the vendor; the first two partitions are mandated - * by the boot ROM, and the bootloader area is somehow oversized... - */ -static struct mtd_partition nhk8815_partitions[] = { - { - .name = "X-Loader(NAND)", - .offset = 0, - .size = SZ_256K, - }, { - .name = "MemInit(NAND)", - .offset = MTDPART_OFS_APPEND, - .size = SZ_256K, - }, { - .name = "BootLoader(NAND)", - .offset = MTDPART_OFS_APPEND, - .size = SZ_2M, - }, { - .name = "Kernel zImage(NAND)", - .offset = MTDPART_OFS_APPEND, - .size = 3 * SZ_1M, - }, { - .name = "Root Filesystem(NAND)", - .offset = MTDPART_OFS_APPEND, - .size = 22 * SZ_1M, - }, { - .name = "User Filesystem(NAND)", - .offset = MTDPART_OFS_APPEND, - .size = MTDPART_SIZ_FULL, - } -}; - -static struct nomadik_nand_platform_data nhk8815_nand_data = { - .parts = nhk8815_partitions, - .nparts = ARRAY_SIZE(nhk8815_partitions), - .options = NAND_COPYBACK | NAND_CACHEPRG | NAND_NO_PADDING \ - | NAND_NO_READRDY | NAND_NO_AUTOINCR, - .init = nhk8815_nand_init, -}; - -static struct platform_device nhk8815_nand_device = { - .name = "nomadik_nand", - .dev = { - .platform_data = &nhk8815_nand_data, - }, - .resource = nhk8815_nand_resources, - .num_resources = ARRAY_SIZE(nhk8815_nand_resources), -}; - -/* These are the partitions for the OneNand device, different from above */ -static struct mtd_partition nhk8815_onenand_partitions[] = { - { - .name = "X-Loader(OneNAND)", - .offset = 0, - .size = SZ_256K, - }, { - .name = "MemInit(OneNAND)", - .offset = MTDPART_OFS_APPEND, - .size = SZ_256K, - }, { - .name = "BootLoader(OneNAND)", - .offset = MTDPART_OFS_APPEND, - .size = SZ_2M-SZ_256K, - }, { - .name = "SysImage(OneNAND)", - .offset = MTDPART_OFS_APPEND, - .size = 4 * SZ_1M, - }, { - .name = "Root Filesystem(OneNAND)", - .offset = MTDPART_OFS_APPEND, - .size = 22 * SZ_1M, - }, { - .name = "User Filesystem(OneNAND)", - .offset = MTDPART_OFS_APPEND, - .size = MTDPART_SIZ_FULL, - } -}; - -static struct onenand_platform_data nhk8815_onenand_data = { - .parts = nhk8815_onenand_partitions, - .nr_parts = ARRAY_SIZE(nhk8815_onenand_partitions), -}; - -static struct resource nhk8815_onenand_resource[] = { - { - .start = 0x30000000, - .end = 0x30000000 + SZ_128K - 1, - .flags = IORESOURCE_MEM, - }, -}; - -static struct platform_device nhk8815_onenand_device = { - .name = "onenand-flash", - .id = -1, - .dev = { - .platform_data = &nhk8815_onenand_data, - }, - .resource = nhk8815_onenand_resource, - .num_resources = ARRAY_SIZE(nhk8815_onenand_resource), -}; - -static void __init nhk8815_onenand_init(void) -{ -#ifdef CONFIG_MTD_ONENAND - /* Set up SMCS0 for OneNand */ - writel(0x000030db, FSMC_BCR(0)); - writel(0x02100551, FSMC_BTR(0)); -#endif -} - -#define __MEM_4K_RESOURCE(x) \ - .res = {.start = (x), .end = (x) + SZ_4K - 1, .flags = IORESOURCE_MEM} - -static struct amba_device uart0_device = { - .dev = { .init_name = "uart0" }, - __MEM_4K_RESOURCE(NOMADIK_UART0_BASE), - .irq = {IRQ_UART0, NO_IRQ}, -}; - -static struct amba_device uart1_device = { - .dev = { .init_name = "uart1" }, - __MEM_4K_RESOURCE(NOMADIK_UART1_BASE), - .irq = {IRQ_UART1, NO_IRQ}, -}; - -static struct amba_device *amba_devs[] __initdata = { - &uart0_device, - &uart1_device, -}; - -static struct resource nhk8815_eth_resources[] = { - { - .name = "smc91x-regs", - .start = 0x34000000 + 0x300, - .end = 0x34000000 + SZ_64K - 1, - .flags = IORESOURCE_MEM, - }, { - .start = NOMADIK_GPIO_TO_IRQ(115), - .end = NOMADIK_GPIO_TO_IRQ(115), - .flags = IORESOURCE_IRQ | IRQF_TRIGGER_RISING, - } -}; - -static struct platform_device nhk8815_eth_device = { - .name = "smc91x", - .resource = nhk8815_eth_resources, - .num_resources = ARRAY_SIZE(nhk8815_eth_resources), -}; - -static int __init nhk8815_eth_init(void) -{ - int gpio_nr = 115; /* hardwired in the board */ - int err; - - err = gpio_request(gpio_nr, "eth_irq"); - if (!err) err = nmk_gpio_set_mode(gpio_nr, NMK_GPIO_ALT_GPIO); - if (!err) err = gpio_direction_input(gpio_nr); - if (err) - pr_err("Error %i in %s\n", err, __func__); - return err; -} -device_initcall(nhk8815_eth_init); - -static struct platform_device *nhk8815_platform_devices[] __initdata = { - &nhk8815_nand_device, - &nhk8815_onenand_device, - &nhk8815_eth_device, - /* will add more devices */ -}; - -static void __init nomadik_timer_init(void) -{ - u32 src_cr; - - /* Configure timer sources in "system reset controller" ctrl reg */ - src_cr = readl(io_p2v(NOMADIK_SRC_BASE)); - src_cr &= SRC_CR_INIT_MASK; - src_cr |= SRC_CR_INIT_VAL; - writel(src_cr, io_p2v(NOMADIK_SRC_BASE)); - - /* Save global pointer to mtu, used by platform timer code */ - mtu_base = io_p2v(NOMADIK_MTU0_BASE); - - nmdk_timer_init(); -} - -static struct sys_timer nomadik_timer = { - .init = nomadik_timer_init, -}; - -static void __init nhk8815_platform_init(void) -{ - int i; - - cpu8815_platform_init(); - nhk8815_onenand_init(); - platform_add_devices(nhk8815_platform_devices, - ARRAY_SIZE(nhk8815_platform_devices)); - - for (i = 0; i < ARRAY_SIZE(amba_devs); i++) - amba_device_register(amba_devs[i], &iomem_resource); -} - -MACHINE_START(NOMADIK, "NHK8815") - /* Maintainer: ST MicroElectronics */ - .boot_params = 0x100, - .map_io = cpu8815_map_io, - .init_irq = cpu8815_init_irq, - .timer = &nomadik_timer, - .init_machine = nhk8815_platform_init, -MACHINE_END |