1 files changed, 0 insertions, 169 deletions
diff --git a/arch/arm/common/gic.c b/arch/arm/common/gic.c
deleted file mode 100644
index c02dc8116a1..00000000000
--- a/arch/arm/common/gic.c
+++ /dev/null
@@ -1,169 +0,0 @@
-/*
- *  linux/arch/arm/common/gic.c
- *
- *  Copyright (C) 2002 ARM Limited, All Rights Reserved.
- *
- * This program is free software; you can redistribute it and/or modify
- * it under the terms of the GNU General Public License version 2 as
- * published by the Free Software Foundation.
- *
- * Interrupt architecture for the GIC:
- *
- * o There is one Interrupt Distributor, which receives interrupts
- *   from system devices and sends them to the Interrupt Controllers.
- *
- * o There is one CPU Interface per CPU, which sends interrupts sent
- *   by the Distributor, and interrupts generated locally, to the
- *   associated CPU.
- *
- * Note that IRQs 0-31 are special - they are local to each CPU.
- * As such, the enable set/clear, pending set/clear and active bit
- * registers are banked per-cpu for these sources.
- */
-#include <linux/init.h>
-#include <linux/kernel.h>
-#include <linux/list.h>
-#include <linux/smp.h>
-#include <linux/cpumask.h>
-
-#include <asm/irq.h>
-#include <asm/io.h>
-#include <asm/mach/irq.h>
-#include <asm/hardware/gic.h>
-
-static void __iomem *gic_dist_base;
-static void __iomem *gic_cpu_base;
-
-/*
- * Routines to acknowledge, disable and enable interrupts
- *
- * Linux assumes that when we're done with an interrupt we need to
- * unmask it, in the same way we need to unmask an interrupt when
- * we first enable it.
- *
- * The GIC has a seperate notion of "end of interrupt" to re-enable
- * an interrupt after handling, in order to support hardware
- * prioritisation.
- *
- * We can make the GIC behave in the way that Linux expects by making
- * our "acknowledge" routine disable the interrupt, then mark it as
- * complete.
- */
-static void gic_ack_irq(unsigned int irq)
-{
-	u32 mask = 1 << (irq % 32);
-	writel(mask, gic_dist_base + GIC_DIST_ENABLE_CLEAR + (irq / 32) * 4);
-	writel(irq, gic_cpu_base + GIC_CPU_EOI);
-}
-
-static void gic_mask_irq(unsigned int irq)
-{
-	u32 mask = 1 << (irq % 32);
-	writel(mask, gic_dist_base + GIC_DIST_ENABLE_CLEAR + (irq / 32) * 4);
-}
-
-static void gic_unmask_irq(unsigned int irq)
-{
-	u32 mask = 1 << (irq % 32);
-	writel(mask, gic_dist_base + GIC_DIST_ENABLE_SET + (irq / 32) * 4);
-}
-
-#ifdef CONFIG_SMP
-static void gic_set_cpu(struct irqdesc *desc, unsigned int irq, unsigned int cpu)
-{
-	void __iomem *reg = gic_dist_base + GIC_DIST_TARGET + (irq & ~3);
-	unsigned int shift = (irq % 4) * 8;
-	u32 val;
-
-	val = readl(reg) & ~(0xff << shift);
-	val |= 1 << (cpu + shift);
-	writel(val, reg);
-}
-#endif
-
-static struct irqchip gic_chip = {
-	.ack		= gic_ack_irq,
-	.mask		= gic_mask_irq,
-	.unmask		= gic_unmask_irq,
-#ifdef CONFIG_SMP
-	.set_cpu	= gic_set_cpu,
-#endif
-};
-
-void __init gic_dist_init(void __iomem *base)
-{
-	unsigned int max_irq, i;
-	u32 cpumask = 1 << smp_processor_id();
-
-	cpumask |= cpumask << 8;
-	cpumask |= cpumask << 16;
-
-	gic_dist_base = base;
-
-	writel(0, base + GIC_DIST_CTRL);
-
-	/*
-	 * Find out how many interrupts are supported.
-	 */
-	max_irq = readl(base + GIC_DIST_CTR) & 0x1f;
-	max_irq = (max_irq + 1) * 32;
-
-	/*
-	 * The GIC only supports up to 1020 interrupt sources.
-	 * Limit this to either the architected maximum, or the
-	 * platform maximum.
-	 */
-	if (max_irq > max(1020, NR_IRQS))
-		max_irq = max(1020, NR_IRQS);
-
-	/*
-	 * Set all global interrupts to be level triggered, active low.
-	 */
-	for (i = 32; i < max_irq; i += 16)
-		writel(0, base + GIC_DIST_CONFIG + i * 4 / 16);
-
-	/*
-	 * Set all global interrupts to this CPU only.
-	 */
-	for (i = 32; i < max_irq; i += 4)
-		writel(cpumask, base + GIC_DIST_TARGET + i * 4 / 4);
-
-	/*
-	 * Set priority on all interrupts.
-	 */
-	for (i = 0; i < max_irq; i += 4)
-		writel(0xa0a0a0a0, base + GIC_DIST_PRI + i * 4 / 4);
-
-	/*
-	 * Disable all interrupts.
-	 */
-	for (i = 0; i < max_irq; i += 32)
-		writel(0xffffffff, base + GIC_DIST_ENABLE_CLEAR + i * 4 / 32);
-
-	/*
-	 * Setup the Linux IRQ subsystem.
-	 */
-	for (i = 29; i < max_irq; i++) {
-		set_irq_chip(i, &gic_chip);
-		set_irq_handler(i, do_level_IRQ);
-		set_irq_flags(i, IRQF_VALID | IRQF_PROBE);
-	}
-
-	writel(1, base + GIC_DIST_CTRL);
-}
-
-void __cpuinit gic_cpu_init(void __iomem *base)
-{
-	gic_cpu_base = base;
-	writel(0xf0, base + GIC_CPU_PRIMASK);
-	writel(1, base + GIC_CPU_CTRL);
-}
-
-#ifdef CONFIG_SMP
-void gic_raise_softirq(cpumask_t cpumask, unsigned int irq)
-{
-	unsigned long map = *cpus_addr(cpumask);
-
-	writel(map << 16 | irq, gic_dist_base + GIC_DIST_SOFTINT);
-}
-#endif