diff options
Diffstat (limited to 'Documentation/usb/error-codes.txt')
| -rw-r--r-- | Documentation/usb/error-codes.txt | 22 |
1 files changed, 16 insertions, 6 deletions
diff --git a/Documentation/usb/error-codes.txt b/Documentation/usb/error-codes.txt index 9cf83e8c27b..9c3eb845ebe 100644 --- a/Documentation/usb/error-codes.txt +++ b/Documentation/usb/error-codes.txt @@ -21,6 +21,8 @@ Non-USB-specific: USB-specific: +-EBUSY The URB is already active. + -ENODEV specified USB-device or bus doesn't exist -ENOENT specified interface or endpoint does not exist or @@ -35,14 +37,13 @@ USB-specific: d) ISO: number_of_packets is < 0 e) various other cases --EAGAIN a) specified ISO start frame too early - b) (using ISO-ASAP) too much scheduled for the future - wait some time and try again. +-EXDEV ISO: URB_ISO_ASAP wasn't specified and all the frames + the URB would be scheduled in have already expired. -EFBIG Host controller driver can't schedule that many ISO frames. --EPIPE Specified endpoint is stalled. For non-control endpoints, - reset this status with usb_clear_halt(). +-EPIPE The pipe type specified in the URB doesn't match the + endpoint's actual type. -EMSGSIZE (a) endpoint maxpacket size is zero; it is not usable in the current interface altsetting. @@ -60,6 +61,8 @@ USB-specific: -EHOSTUNREACH URB was rejected because the device is suspended. +-ENOEXEC A control URB doesn't contain a Setup packet. + ************************************************************************** * Error codes returned by in urb->status * @@ -74,6 +77,13 @@ A transfer's actual_length may be positive even when an error has been reported. That's because transfers often involve several packets, so that one or more packets could finish before an error stops further endpoint I/O. +For isochronous URBs, the urb status value is non-zero only if the URB is +unlinked, the device is removed, the host controller is disabled, or the total +transferred length is less than the requested length and the URB_SHORT_NOT_OK +flag is set. Completion handlers for isochronous URBs should only see +urb->status set to zero, -ENOENT, -ECONNRESET, -ESHUTDOWN, or -EREMOTEIO. +Individual frame descriptor status fields may report more status codes. + 0 Transfer completed successfully @@ -130,7 +140,7 @@ one or more packets could finish before an error stops further endpoint I/O. device removal events immediately. -EXDEV ISO transfer only partially completed - look at individual frame status for details + (only set in iso_frame_desc[n].status, not urb->status) -EINVAL ISO madness, if this happens: Log off and go home |