diff options
Diffstat (limited to 'Documentation/networking/vortex.txt')
| -rw-r--r-- | Documentation/networking/vortex.txt | 6 |
1 files changed, 3 insertions, 3 deletions
diff --git a/Documentation/networking/vortex.txt b/Documentation/networking/vortex.txt index b4038ffb3bc..97282da82b7 100644 --- a/Documentation/networking/vortex.txt +++ b/Documentation/networking/vortex.txt @@ -68,7 +68,7 @@ Module parameters There are several parameters which may be provided to the driver when its module is loaded. These are usually placed in /etc/modprobe.d/*.conf -configuretion files. Example: +configuration files. Example: options 3c59x debug=3 rx_copybreak=300 @@ -178,7 +178,7 @@ max_interrupt_work=N The driver's interrupt service routine can handle many receive and transmit packets in a single invocation. It does this in a loop. - The value of max_interrupt_work governs how mnay times the interrupt + The value of max_interrupt_work governs how many times the interrupt service routine will loop. The default value is 32 loops. If this is exceeded the interrupt service routine gives up and generates a warning message "eth0: Too much work in interrupt". @@ -359,7 +359,7 @@ steps you should take: - OK, it's a driver problem. You need to generate a report. Typically this is an email to the - maintainer and/or linux-net@vger.kernel.org. The maintainer's + maintainer and/or netdev@vger.kernel.org. The maintainer's email address will be in the driver source or in the MAINTAINERS file. - The contents of your report will vary a lot depending upon the |