diff options
Diffstat (limited to 'Documentation/filesystems/autofs4-mount-control.txt')
| -rw-r--r-- | Documentation/filesystems/autofs4-mount-control.txt | 8 |
1 files changed, 4 insertions, 4 deletions
diff --git a/Documentation/filesystems/autofs4-mount-control.txt b/Documentation/filesystems/autofs4-mount-control.txt index c6341745df3..aff22113a98 100644 --- a/Documentation/filesystems/autofs4-mount-control.txt +++ b/Documentation/filesystems/autofs4-mount-control.txt @@ -146,7 +146,7 @@ found to be inadequate, in this case. The Generic Netlink system was used for this as raw Netlink would lead to a significant increase in complexity. There's no question that the Generic Netlink system is an elegant solution for common case ioctl functions but it's not a complete -replacement probably because it's primary purpose in life is to be a +replacement probably because its primary purpose in life is to be a message bus implementation rather than specifically an ioctl replacement. While it would be possible to work around this there is one concern that lead to the decision to not use it. This is that the autofs @@ -255,7 +255,7 @@ AUTOFS_DEV_IOCTL_OPENMOUNT and AUTOFS_DEV_IOCTL_CLOSEMOUNT Obtain and release a file descriptor for an autofs managed mount point path. The open call requires an initialized struct autofs_dev_ioctl with -the the path field set and the size field adjusted appropriately as well +the path field set and the size field adjusted appropriately as well as the arg1 field set to the device number of the autofs mount. The device number can be obtained from the mount options shown in /proc/mounts. The close call requires an initialized struct @@ -309,7 +309,7 @@ ioctlfd field set to the descriptor obtained from the open call. AUTOFS_DEV_IOCTL_TIMEOUT_CMD ---------------------------- -Set the expire timeout for mounts withing an autofs mount point. +Set the expire timeout for mounts within an autofs mount point. The call requires an initialized struct autofs_dev_ioctl with the ioctlfd field set to the descriptor obtained from the open call. @@ -369,7 +369,7 @@ The call requires an initialized struct autofs_dev_ioctl. There are two possible variations. Both use the path field set to the path of the mount point to check and the size field adjusted appropriately. One uses the ioctlfd field to identify a specific mount point to check while the other -variation uses the path and optionaly arg1 set to an autofs mount type. +variation uses the path and optionally arg1 set to an autofs mount type. The call returns 1 if this is a mount point and sets arg1 to the device number of the mount and field arg2 to the relevant super block magic number (described below) or 0 if it isn't a mountpoint. In both cases |