Merge tag 'vt8500/pinctrl' of git://server.prisktech.co.nz/git/linuxwmt into next/drivers

From Tony Prisk <linux@prisktech.co.nz>:

arm: vt8500: Add pinctrl driver for arch-vt8500

This series adds support for the pinctrl/gpio module on all arch-vt8500
supported SoCs.

As part of the review process, some tidy up is also done to
drivers/of/base.c to remove some code that is being constantly duplicated.

Also, a patch for the bcm2835 pinctrl driver is included to take advantage
of the new of/base.c code.

* tag 'vt8500/pinctrl' of git://server.prisktech.co.nz/git/linuxwmt: (606 commits)
  pinctrl: bcm2835: make use of of_property_read_u32_index()
  gpio: vt8500: Remove arch-vt8500 gpio driver
  arm: vt8500: Remove gpio devicetree nodes
  arm: dts: vt8500: Update Wondermedia SoC dtsi files for pinctrl driver
  pinctrl: gpio: vt8500: Add pincontrol driver for arch-vt8500
  arm: vt8500: Increase available GPIOs on arch-vt8500
  of: Remove duplicated code for validating property and value
  of: Add support for reading a u32 from a multi-value property.

Signed-off-by: Arnd Bergmann <arnd@arndb.de>

1 files changed, 14 insertions, 9 deletions

diff --git a/drivers/usb/core/hcd-pci.c b/drivers/usb/core/hcd-pci.c
index 622b4a48e73..2b487d4797b 100644
--- a/drivers/usb/core/hcd-pci.c
+++ b/drivers/usb/core/hcd-pci.c
@@ -173,6 +173,7 @@ int usb_hcd_pci_probe(struct pci_dev *dev, const struct pci_device_id *id)
 	struct hc_driver	*driver;
 	struct usb_hcd		*hcd;
 	int			retval;
+	int			hcd_irq = 0;
 
 	if (usb_disabled())
 		return -ENODEV;
@@ -187,15 +188,19 @@ int usb_hcd_pci_probe(struct pci_dev *dev, const struct pci_device_id *id)
 		return -ENODEV;
 	dev->current_state = PCI_D0;
 
-	/* The xHCI driver supports MSI and MSI-X,
-	 * so don't fail if the BIOS doesn't provide a legacy IRQ.
+	/*
+	 * The xHCI driver has its own irq management
+	 * make sure irq setup is not touched for xhci in generic hcd code
 	 */
-	if (!dev->irq && (driver->flags & HCD_MASK) != HCD_USB3) {
-		dev_err(&dev->dev,
-			"Found HC with no IRQ.  Check BIOS/PCI %s setup!\n",
-			pci_name(dev));
-		retval = -ENODEV;
-		goto disable_pci;
+	if ((driver->flags & HCD_MASK) != HCD_USB3) {
+		if (!dev->irq) {
+			dev_err(&dev->dev,
+			"Found HC with no IRQ. Check BIOS/PCI %s setup!\n",
+				pci_name(dev));
+			retval = -ENODEV;
+			goto disable_pci;
+		}
+		hcd_irq = dev->irq;
 	}
 
 	hcd = usb_create_hcd(driver, &dev->dev, pci_name(dev));
@@ -245,7 +250,7 @@ int usb_hcd_pci_probe(struct pci_dev *dev, const struct pci_device_id *id)
 
 	pci_set_master(dev);
 
-	retval = usb_add_hcd(hcd, dev->irq, IRQF_SHARED);
+	retval = usb_add_hcd(hcd, hcd_irq, IRQF_SHARED);
 	if (retval != 0)
 		goto unmap_registers;
 	set_hs_companion(dev, hcd);