blob: 0d48de94b594e5d36e9390e430ae8afa3c6487bc (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
|
[exit]
CONFIG = $DEFAULTCONFIG
BINARY = gnunet-daemon-exit
# IPv6 address for the TUN interface (must be changed as this
# must be within the global IPv6 range of your system!)
IPV6ADDR = 2001:DB8::1
# Prefix for our IPv6 subnet on the TUN interface.
IPV6PREFIX = 64
# IPv4 address to use on our TUN interface (may need to be
# changed to avoid conflicts with existing addresses on your system).
# Use RFC 3927-style link-local address
IPV4ADDR = 169.254.86.1
# Netmask for the IPv4 subnet on the TUN interface.
IPV4MASK = 255.255.255.0
# Name of the (virtual) tunnel interface the exit daemon will manage
TUN_IFNAME = exit-gnunet
# Name of the "real" interface that IPv4 traffic from this system will
# leave from; this is the name of the interface where we need to
# enable NAT on postrouting (typically something like 'eth0' or 'eth1'
# or 'wlan0'). Not needed if EXIT_IPv4 is disabled AND if all
# offered services run on 'localhost'. In this case, the value
# of the option can instead be set to "%" (to not enable NAT on any
# interface).
EXIT_IFNAME = eth0
# Set this to YES to allow exiting this system via IPv4 to the Internet
EXIT_IPV4 = NO
# Set this to YES to allow exiting this system via IPv6 to the Internet
EXIT_IPV6 = NO
# For IPv4-services offered by this peer, we need to at least enable IPv4
ENABLE_IPV4 = YES
# For IPv6-services offered by this peer, we need to at least enable IPv6
ENABLE_IPV6 = YES
# Maximum number of concurrent connections this exit supports.
MAX_CONNECTIONS = 256
|
