blob: a0643f74ae6965a8cd1b4eee111151a59b9afc2b (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
|
source [find target/c100.cfg]
# basic register defintion for C100
source [find target/c100regs.tcl]
# board-config info
source [find target/c100config.tcl]
# C100 helper functions
source [find target/c100helper.tcl]
# Telo board & C100 support trst and srst
# however openocd does not support
# 1. setting srst reset pulse width
# 2. setting delay between srst pulse and JTAG access
# This really makes the srst useless for now.
reset_config trst_and_srst separate
# issue telnet: reset init
# issue gdb: monitor reset init
$_TARGETNAME configure -event reset-init {
jtag_khz 100
# setup GPIO used as control signals for C100
setupGPIO
# This will allow acces to lower 8MB or NOR
lowGPIO5
# setup NOR size,timing,etc.
setupNOR
# setup internals + PLL + DDR2
initC100
#turn up the JTAG speed
jtag_khz 3000
puts "JTAG speek now 3MHz"
puts "type helpC100 to get help on C100"
}
$_TARGETNAME configure -event reset-deassert-post {
# Force target into ARM state.
# soft_reset_halt # not implemented on ARM11
puts "Detected SRSRT asserted on C100.CPU"
}
proc power_restore {} { puts "Sensed power restore. No action." }
proc srst_deasserted {} { puts "Sensed nSRST deasserted. No action." }
# boots from NOR on CS0: 8 MBytes CFI flash, 16-bit bus
# it's really 16MB but the upper 8mb is controller via gpio
# openocd does not support 'complex reads/writes' to NOR
flash bank cfi 0x20000000 0x01000000 2 2 $_TARGETNAME
# writing data to memory does not work without this
memwrite burst disable
|