From 38ac08c1c25adf42cf20e48e10e6ddeab6a12d71 Mon Sep 17 00:00:00 2001 From: Antonio Borneo Date: Fri, 23 Aug 2019 15:51:00 +0200 Subject: tcl: replace the deprecated commands with "adapter ..." Avoid annoying "deprecated" messages while running the scripts distributed with OpenOCD code. Change automatically created with commands sed -i 's/adapter_khz/adapter speed/g' $(find tcl/ -type f) sed -i 's/adapter_nsrst_delay/adapter srst delay/g' $(find tcl/ -type f) sed -i 's/adapter_nsrst_assert_width/adapter srst pulse_width/g' $(find tcl/ -type f) Minor indentation issue fixed manually in tcl/board/at91sam9g20-ek.cfg tcl/target/at91sam9260_ext_RAM_ext_flash.cfg Change-Id: I425fd56c0c88cd6b06124621306eeb89166dfe71 Signed-off-by: Antonio Borneo Reviewed-on: http://openocd.zylin.com/5284 Tested-by: jenkins Reviewed-by: Oleksij Rempel --- tcl/target/stm32f7x.cfg | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) (limited to 'tcl/target/stm32f7x.cfg') diff --git a/tcl/target/stm32f7x.cfg b/tcl/target/stm32f7x.cfg index ba1d12ff..db1794c1 100755 --- a/tcl/target/stm32f7x.cfg +++ b/tcl/target/stm32f7x.cfg @@ -65,9 +65,9 @@ flash bank $_CHIPNAME.otp stm32f2x 0x1ff0f000 0 0 0 $_TARGETNAME flash bank $_CHIPNAME.itcm-flash.alias virtual 0x00200000 0 0 0 $_TARGETNAME $_FLASHNAME # adapter speed should be <= F_CPU/6. F_CPU after reset is 16MHz, so use F_JTAG = 2MHz -adapter_khz 2000 +adapter speed 2000 -adapter_nsrst_delay 100 +adapter srst delay 100 if {[using_jtag]} { jtag_ntrst_delay 100 } @@ -162,12 +162,12 @@ $_TARGETNAME configure -event reset-init { if {[using_jtag]} { [[target current] cget -dap] memaccess 16 } { - adapter_khz 8000 + adapter speed 8000 } } $_TARGETNAME configure -event reset-start { # Reduce speed since CPU speed will slow down to 16MHz with the reset - adapter_khz 2000 + adapter speed 2000 } -- cgit v1.2.3-18-g5258