From c7384117c66e8f18896ca09ab8095d6da16bb1e5 Mon Sep 17 00:00:00 2001 From: Paul Fertser Date: Sat, 28 Sep 2013 14:23:15 +0400 Subject: Allow transports to override the selected target (hla configs unification) This should allow to share common configs for both regular access and high-level adapters. Use the newly-added functionality in stlink and icdi drivers, amend the configs accordingly. Runtime-tested with a TI tm4c123g board. Change-Id: Ibb88266a4ca25f06f6c073e916c963f017447bad Signed-off-by: Paul Fertser [gus@projectgus.com: context-specific deprecation warnings] Signed-off-by: Angus Gratton [andrew.smirnov@gmail.com: additional nrf51.cfg mods] Signed-off-by: Andrey Smirnov Tested-by: Andrey Skvortsov Reviewed-on: http://openocd.zylin.com/1664 Tested-by: jenkins Reviewed-by: Andreas Fritiofson --- tcl/target/kl25.cfg | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-) (limited to 'tcl/target/kl25.cfg') diff --git a/tcl/target/kl25.cfg b/tcl/target/kl25.cfg index c2126c2c..7b14ecc8 100644 --- a/tcl/target/kl25.cfg +++ b/tcl/target/kl25.cfg @@ -55,9 +55,11 @@ flash bank $_FLASHNAME kinetis 0 0 0 0 $_TARGETNAME # specifies up to 1MHz for VLPR mode. adapter_khz 1000 -# if srst is not fitted use SYSRESETREQ to -# perform a soft reset -cortex_m reset_config sysresetreq +if {![using_hla]} { + # if srst is not fitted use SYSRESETREQ to + # perform a soft reset + cortex_m reset_config sysresetreq +} $_TARGETNAME configure -event reset-init { # Table 5-1. Clock Summary of KL25 Sub-Family Reference Manual -- cgit v1.2.3-18-g5258