diff options
Diffstat (limited to 'tcl/board')
| -rw-r--r-- | tcl/board/dptechnics_dpt-board-v1.cfg | 32 |
1 files changed, 32 insertions, 0 deletions
diff --git a/tcl/board/dptechnics_dpt-board-v1.cfg b/tcl/board/dptechnics_dpt-board-v1.cfg new file mode 100644 index 00000000..de31c7c0 --- /dev/null +++ b/tcl/board/dptechnics_dpt-board-v1.cfg @@ -0,0 +1,32 @@ +# Product page: +# https://www.dptechnics.com/en/products/dpt-board-v1.html +# +# JTAG is a 5 pin array located close to main module in following order: +# 1. JTAG TCK +# 2. JTAG TDO +# 3. JTAG TDI +# 4. JTAG TMS +# 5. GND The GND is located near letter G of word JTAG on board. +# +# Two RST pins are connected to: +# 1. GND +# 2. GPIO11 this pin is located near letter R of word RST. +# +# To enable EJTAG mode, GPIO11 (RST[1]) pin should be pulled up. For example +# with 10K resistor connected to V3.3 pin. +# +# This board is powered from micro USB connector. No real reset pin or button, for +# example RESET_L is available. + +source [find target/atheros_ar9331.cfg] + +$_TARGETNAME configure -event reset-init { + ar9331_25mhz_pll_init + sleep 1 + ar9331_ddr2_init +} + +set ram_boot_address 0xa0000000 +$_TARGETNAME configure -work-area-phys 0xa1FFE000 -work-area-size 0x1000 + +flash bank flash0 ath79 0 0 0 0 $_TARGETNAME cs0 |