diff options
Diffstat (limited to 'src/tcl/target/aduc702x.cfg')
-rw-r--r-- | src/tcl/target/aduc702x.cfg | 61 |
1 files changed, 0 insertions, 61 deletions
diff --git a/src/tcl/target/aduc702x.cfg b/src/tcl/target/aduc702x.cfg deleted file mode 100644 index ef1beb78..00000000 --- a/src/tcl/target/aduc702x.cfg +++ /dev/null @@ -1,61 +0,0 @@ -## -*- tcl -*- -## - - -if { [info exists CHIPNAME] } { - set _CHIPNAME $CHIPNAME -} else { - set _CHIPNAME s3c2410 -} - -if { [info exists ENDIAN] } { - set _ENDIAN $ENDIAN -} else { - # This config file was defaulting to big endian.. - set _ENDIAN little -} - -if { [info exists CPUTAPID] } { - set _CPUTAPID $CPUTAPID -} else { - set _CPUTAPID 0xffffffff -} - - -jtag_nsrst_delay 200 -jtag_ntrst_delay 200 - -# This is for the case that TRST/SRST is not wired on your JTAG adaptor. -# Don't really need them anyways. -reset_config none - -## JTAG scan chain -#format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE) -jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID - -## -## Target configuration -## -set _TARGETNAME [format "%s.cpu" $_CHIPNAME] -target create $_TARGETNAME arm7tdmi -endian $_ENDIAN -chain-position $_TARGETNAME - -# allocate the entire SRAM as working area -$_TARGETNAME configure -work-area-phys 0x10000 -work-area-size 0x2000 - -## flash configuration -# only target number is needed -flash bank aduc702x 0 0 0 0 0 - -## If you use the watchdog, the following code makes sure that the board -## doesn't reboot when halted via JTAG. Yes, on the older generation -## AdUC702x, timer3 continues running even when the CPU is halted. - -proc watchdog_service {} { - global watchdog_hdl - mww 0xffff036c 0 -# puts "watchdog!!" - set watchdog_hdl [after 500 watchdog_service] -} - -$_TARGETNAME configure -event reset-halt-post { watchdog_service } -$_TARGETNAME configure -event old-pre_resume { global watchdog_hdl; after cancel $watchdog_hdl } |