diff options
| -rw-r--r-- | src/jtag/drivers/buspirate.c | 18 |
1 files changed, 9 insertions, 9 deletions
diff --git a/src/jtag/drivers/buspirate.c b/src/jtag/drivers/buspirate.c index a360d230..62ab008a 100644 --- a/src/jtag/drivers/buspirate.c +++ b/src/jtag/drivers/buspirate.c @@ -217,13 +217,13 @@ static int buspirate_execute_queue(void) static int buspirate_init(void) { if (buspirate_port == NULL) { - LOG_ERROR("You need to specify port !"); + LOG_ERROR("You need to specify the serial port!"); return ERROR_JTAG_INIT_FAILED; } buspirate_fd = buspirate_serial_open(buspirate_port); if (buspirate_fd == -1) { - LOG_ERROR("Could not open serial port."); + LOG_ERROR("Could not open serial port"); return ERROR_JTAG_INIT_FAILED; } @@ -249,7 +249,7 @@ static int buspirate_init(void) static int buspirate_quit(void) { - LOG_INFO("Shuting down buspirate "); + LOG_INFO("Shutting down buspirate."); buspirate_jtag_set_mode(buspirate_fd, MODE_HIZ); buspirate_jtag_set_speed(buspirate_fd, SERIAL_NORMAL); @@ -665,7 +665,7 @@ static void buspirate_tap_append(int tms, int tdi) tap_chain_index++; } else - LOG_ERROR("tap_chain overflow, Bad things will happen"); + LOG_ERROR("tap_chain overflow, bad things will happen"); } @@ -724,19 +724,19 @@ static void buspirate_jtag_enable(int fd) while (!done) { ret = buspirate_serial_read(fd, tmp, 4); if (ret != 4) { - LOG_ERROR("Buspirate error. Is is binary/" + LOG_ERROR("Buspirate error. Is binary" "/OpenOCD support enabled?"); exit(-1); } if (strncmp(tmp, "BBIO", 4) == 0) { ret = buspirate_serial_read(fd, tmp, 1); if (ret != 1) { - LOG_ERROR("Buspirate did not correctly! " + LOG_ERROR("Buspirate did not answer correctly! " "Do you have correct firmware?"); exit(-1); } if (tmp[0] != '1') { - LOG_ERROR("Unsupported binary protocol "); + LOG_ERROR("Unsupported binary protocol"); exit(-1); } if (cmd_sent == 0) { @@ -747,7 +747,7 @@ static void buspirate_jtag_enable(int fd) } else if (strncmp(tmp, "OCD1", 4) == 0) done = 1; else { - LOG_ERROR("Buspirate did not correctly! " + LOG_ERROR("Buspirate did not answer correctly! " "Do you have correct firmware?"); exit(-1); } @@ -794,7 +794,7 @@ static void buspirate_jtag_set_speed(int fd, char speed) exit(-1); } if ((tmp[0] != CMD_UART_SPEED) || (tmp[1] != speed)) { - LOG_ERROR("Buspirate didn't reply as expected"); + LOG_ERROR("Buspirate did not reply as expected"); exit(-1); } LOG_INFO("Buspirate switched to %s mode", |