1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
295
296
297
298
299
300
301
|
/*======================================================================
A driver for PCMCIA parallel port adapters
(specifically, for the Quatech SPP-100 EPP card: other cards will
probably require driver tweaks)
parport_cs.c 1.29 2002/10/11 06:57:41
The contents of this file are subject to the Mozilla Public
License Version 1.1 (the "License"); you may not use this file
except in compliance with the License. You may obtain a copy of
the License at http://www.mozilla.org/MPL/
Software distributed under the License is distributed on an "AS
IS" basis, WITHOUT WARRANTY OF ANY KIND, either express or
implied. See the License for the specific language governing
rights and limitations under the License.
The initial developer of the original code is David A. Hinds
<dahinds@users.sourceforge.net>. Portions created by David A. Hinds
are Copyright (C) 1999 David A. Hinds. All Rights Reserved.
Alternatively, the contents of this file may be used under the
terms of the GNU General Public License version 2 (the "GPL"), in
which case the provisions of the GPL are applicable instead of the
above. If you wish to allow the use of your version of this file
only under the terms of the GPL and not to allow others to use
your version of this file under the MPL, indicate your decision
by deleting the provisions above and replace them with the notice
and other provisions required by the GPL. If you do not delete
the provisions above, a recipient may use your version of this
file under either the MPL or the GPL.
======================================================================*/
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/init.h>
#include <linux/sched.h>
#include <linux/ptrace.h>
#include <linux/slab.h>
#include <linux/string.h>
#include <linux/timer.h>
#include <linux/ioport.h>
#include <linux/major.h>
#include <linux/parport.h>
#include <linux/parport_pc.h>
#include <pcmcia/cs_types.h>
#include <pcmcia/cs.h>
#include <pcmcia/cistpl.h>
#include <pcmcia/ds.h>
#include <pcmcia/cisreg.h>
#include <pcmcia/ciscode.h>
/*====================================================================*/
/* Module parameters */
MODULE_AUTHOR("David Hinds <dahinds@users.sourceforge.net>");
MODULE_DESCRIPTION("PCMCIA parallel port card driver");
MODULE_LICENSE("Dual MPL/GPL");
#define INT_MODULE_PARM(n, v) static int n = v; module_param(n, int, 0)
INT_MODULE_PARM(epp_mode, 1);
#ifdef PCMCIA_DEBUG
INT_MODULE_PARM(pc_debug, PCMCIA_DEBUG);
#define DEBUG(n, args...) if (pc_debug>(n)) printk(KERN_DEBUG args)
static char *version =
"parport_cs.c 1.29 2002/10/11 06:57:41 (David Hinds)";
#else
#define DEBUG(n, args...)
#endif
/*====================================================================*/
#define FORCE_EPP_MODE 0x08
typedef struct parport_info_t {
struct pcmcia_device *p_dev;
int ndev;
dev_node_t node;
struct parport *port;
} parport_info_t;
static void parport_detach(struct pcmcia_device *p_dev);
static void parport_config(struct pcmcia_device *link);
static void parport_cs_release(struct pcmcia_device *);
/*======================================================================
parport_attach() creates an "instance" of the driver, allocating
local data structures for one device. The device is registered
with Card Services.
======================================================================*/
static int parport_attach(struct pcmcia_device *link)
{
parport_info_t *info;
DEBUG(0, "parport_attach()\n");
/* Create new parport device */
info = kmalloc(sizeof(*info), GFP_KERNEL);
if (!info) return -ENOMEM;
memset(info, 0, sizeof(*info));
link->priv = info;
info->p_dev = link;
link->io.Attributes1 = IO_DATA_PATH_WIDTH_8;
link->io.Attributes2 = IO_DATA_PATH_WIDTH_8;
link->irq.Attributes = IRQ_TYPE_EXCLUSIVE;
link->irq.IRQInfo1 = IRQ_LEVEL_ID;
link->conf.Attributes = CONF_ENABLE_IRQ;
link->conf.IntType = INT_MEMORY_AND_IO;
link->state |= DEV_PRESENT | DEV_CONFIG_PENDING;
parport_config(link);
return 0;
} /* parport_attach */
/*======================================================================
This deletes a driver "instance". The device is de-registered
with Card Services. If it has been released, all local data
structures are freed. Otherwise, the structures will be freed
when the device is released.
======================================================================*/
static void parport_detach(struct pcmcia_device *link)
{
DEBUG(0, "parport_detach(0x%p)\n", link);
if (link->state & DEV_CONFIG)
parport_cs_release(link);
kfree(link->priv);
} /* parport_detach */
/*======================================================================
parport_config() is scheduled to run after a CARD_INSERTION event
is received, to configure the PCMCIA socket, and to make the
parport device available to the system.
======================================================================*/
#define CS_CHECK(fn, ret) \
do { last_fn = (fn); if ((last_ret = (ret)) != 0) goto cs_failed; } while (0)
void parport_config(struct pcmcia_device *link)
{
parport_info_t *info = link->priv;
tuple_t tuple;
u_short buf[128];
cisparse_t parse;
cistpl_cftable_entry_t *cfg = &parse.cftable_entry;
cistpl_cftable_entry_t dflt = { 0 };
struct parport *p;
int last_ret, last_fn;
DEBUG(0, "parport_config(0x%p)\n", link);
tuple.TupleData = (cisdata_t *)buf;
tuple.TupleOffset = 0; tuple.TupleDataMax = 255;
tuple.Attributes = 0;
tuple.DesiredTuple = CISTPL_CONFIG;
CS_CHECK(GetFirstTuple, pcmcia_get_first_tuple(link, &tuple));
CS_CHECK(GetTupleData, pcmcia_get_tuple_data(link, &tuple));
CS_CHECK(ParseTuple, pcmcia_parse_tuple(link, &tuple, &parse));
link->conf.ConfigBase = parse.config.base;
link->conf.Present = parse.config.rmask[0];
/* Configure card */
link->state |= DEV_CONFIG;
tuple.DesiredTuple = CISTPL_CFTABLE_ENTRY;
tuple.Attributes = 0;
CS_CHECK(GetFirstTuple, pcmcia_get_first_tuple(link, &tuple));
while (1) {
if (pcmcia_get_tuple_data(link, &tuple) != 0 ||
pcmcia_parse_tuple(link, &tuple, &parse) != 0)
goto next_entry;
if ((cfg->io.nwin > 0) || (dflt.io.nwin > 0)) {
cistpl_io_t *io = (cfg->io.nwin) ? &cfg->io : &dflt.io;
link->conf.ConfigIndex = cfg->index;
if (epp_mode)
link->conf.ConfigIndex |= FORCE_EPP_MODE;
link->io.BasePort1 = io->win[0].base;
link->io.NumPorts1 = io->win[0].len;
link->io.IOAddrLines = io->flags & CISTPL_IO_LINES_MASK;
if (io->nwin == 2) {
link->io.BasePort2 = io->win[1].base;
link->io.NumPorts2 = io->win[1].len;
}
if (pcmcia_request_io(link, &link->io) != 0)
goto next_entry;
/* If we've got this far, we're done */
break;
}
next_entry:
if (cfg->flags & CISTPL_CFTABLE_DEFAULT) dflt = *cfg;
CS_CHECK(GetNextTuple, pcmcia_get_next_tuple(link, &tuple));
}
CS_CHECK(RequestIRQ, pcmcia_request_irq(link, &link->irq));
CS_CHECK(RequestConfiguration, pcmcia_request_configuration(link, &link->conf));
p = parport_pc_probe_port(link->io.BasePort1, link->io.BasePort2,
link->irq.AssignedIRQ, PARPORT_DMA_NONE,
NULL);
if (p == NULL) {
printk(KERN_NOTICE "parport_cs: parport_pc_probe_port() at "
"0x%3x, irq %u failed\n", link->io.BasePort1,
link->irq.AssignedIRQ);
goto failed;
}
p->modes |= PARPORT_MODE_PCSPP;
if (epp_mode)
p->modes |= PARPORT_MODE_TRISTATE | PARPORT_MODE_EPP;
info->ndev = 1;
info->node.major = LP_MAJOR;
info->node.minor = p->number;
info->port = p;
strcpy(info->node.dev_name, p->name);
link->dev_node = &info->node;
link->state &= ~DEV_CONFIG_PENDING;
return;
cs_failed:
cs_error(link, last_fn, last_ret);
failed:
parport_cs_release(link);
link->state &= ~DEV_CONFIG_PENDING;
} /* parport_config */
/*======================================================================
After a card is removed, parport_cs_release() will unregister the
device, and release the PCMCIA configuration. If the device is
still open, this will be postponed until it is closed.
======================================================================*/
void parport_cs_release(struct pcmcia_device *link)
{
parport_info_t *info = link->priv;
DEBUG(0, "parport_release(0x%p)\n", link);
if (info->ndev) {
struct parport *p = info->port;
parport_pc_unregister_port(p);
}
info->ndev = 0;
pcmcia_disable_device(link);
} /* parport_cs_release */
static struct pcmcia_device_id parport_ids[] = {
PCMCIA_DEVICE_FUNC_ID(3),
PCMCIA_DEVICE_MANF_CARD(0x0137, 0x0003),
PCMCIA_DEVICE_NULL
};
MODULE_DEVICE_TABLE(pcmcia, parport_ids);
static struct pcmcia_driver parport_cs_driver = {
.owner = THIS_MODULE,
.drv = {
.name = "parport_cs",
},
.probe = parport_attach,
.remove = parport_detach,
.id_table = parport_ids,
};
static int __init init_parport_cs(void)
{
return pcmcia_register_driver(&parport_cs_driver);
}
static void __exit exit_parport_cs(void)
{
pcmcia_unregister_driver(&parport_cs_driver);
}
module_init(init_parport_cs);
module_exit(exit_parport_cs);
|
