blob: 6a4cfe2d33679692117308c5ab0d0395f0ec2091 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
|
/*
* Blackfin Secure Digital Host (SDH) definitions
*
* Copyright 2008-2010 Analog Devices Inc.
*
* Licensed under the GPL-2 or later.
*/
#ifndef __BFIN_SDH_H__
#define __BFIN_SDH_H__
/* Platform resources */
struct bfin_sd_host {
int dma_chan;
int irq_int0;
int irq_int1;
u16 pin_req[7];
};
/* SDH_COMMAND bitmasks */
#define CMD_IDX 0x3f /* Command Index */
#define CMD_RSP (1 << 6) /* Response */
#define CMD_L_RSP (1 << 7) /* Long Response */
#define CMD_INT_E (1 << 8) /* Command Interrupt */
#define CMD_PEND_E (1 << 9) /* Command Pending */
#define CMD_E (1 << 10) /* Command Enable */
/* SDH_PWR_CTL bitmasks */
#define PWR_ON 0x3 /* Power On */
#define SD_CMD_OD (1 << 6) /* Open Drain Output */
#define ROD_CTL (1 << 7) /* Rod Control */
/* SDH_CLK_CTL bitmasks */
#define CLKDIV 0xff /* MC_CLK Divisor */
#define CLK_E (1 << 8) /* MC_CLK Bus Clock Enable */
#define PWR_SV_E (1 << 9) /* Power Save Enable */
#define CLKDIV_BYPASS (1 << 10) /* Bypass Divisor */
#define WIDE_BUS (1 << 11) /* Wide Bus Mode Enable */
/* SDH_RESP_CMD bitmasks */
#define RESP_CMD 0x3f /* Response Command */
/* SDH_DATA_CTL bitmasks */
#define DTX_E (1 << 0) /* Data Transfer Enable */
#define DTX_DIR (1 << 1) /* Data Transfer Direction */
#define DTX_MODE (1 << 2) /* Data Transfer Mode */
#define DTX_DMA_E (1 << 3) /* Data Transfer DMA Enable */
#define DTX_BLK_LGTH (0xf << 4) /* Data Transfer Block Length */
/* SDH_STATUS bitmasks */
#define CMD_CRC_FAIL (1 << 0) /* CMD CRC Fail */
#define DAT_CRC_FAIL (1 << 1) /* Data CRC Fail */
#define CMD_TIME_OUT (1 << 2) /* CMD Time Out */
#define DAT_TIME_OUT (1 << 3) /* Data Time Out */
#define TX_UNDERRUN (1 << 4) /* Transmit Underrun */
#define RX_OVERRUN (1 << 5) /* Receive Overrun */
#define CMD_RESP_END (1 << 6) /* CMD Response End */
#define CMD_SENT (1 << 7) /* CMD Sent */
#define DAT_END (1 << 8) /* Data End */
#define START_BIT_ERR (1 << 9) /* Start Bit Error */
#define DAT_BLK_END (1 << 10) /* Data Block End */
#define CMD_ACT (1 << 11) /* CMD Active */
#define TX_ACT (1 << 12) /* Transmit Active */
#define RX_ACT (1 << 13) /* Receive Active */
#define TX_FIFO_STAT (1 << 14) /* Transmit FIFO Status */
#define RX_FIFO_STAT (1 << 15) /* Receive FIFO Status */
#define TX_FIFO_FULL (1 << 16) /* Transmit FIFO Full */
#define RX_FIFO_FULL (1 << 17) /* Receive FIFO Full */
#define TX_FIFO_ZERO (1 << 18) /* Transmit FIFO Empty */
#define RX_DAT_ZERO (1 << 19) /* Receive FIFO Empty */
#define TX_DAT_RDY (1 << 20) /* Transmit Data Available */
#define RX_FIFO_RDY (1 << 21) /* Receive Data Available */
/* SDH_STATUS_CLR bitmasks */
#define CMD_CRC_FAIL_STAT (1 << 0) /* CMD CRC Fail Status */
#define DAT_CRC_FAIL_STAT (1 << 1) /* Data CRC Fail Status */
#define CMD_TIMEOUT_STAT (1 << 2) /* CMD Time Out Status */
#define DAT_TIMEOUT_STAT (1 << 3) /* Data Time Out status */
#define TX_UNDERRUN_STAT (1 << 4) /* Transmit Underrun Status */
#define RX_OVERRUN_STAT (1 << 5) /* Receive Overrun Status */
#define CMD_RESP_END_STAT (1 << 6) /* CMD Response End Status */
#define CMD_SENT_STAT (1 << 7) /* CMD Sent Status */
#define DAT_END_STAT (1 << 8) /* Data End Status */
#define START_BIT_ERR_STAT (1 << 9) /* Start Bit Error Status */
#define DAT_BLK_END_STAT (1 << 10) /* Data Block End Status */
/* SDH_MASK0 bitmasks */
#define CMD_CRC_FAIL_MASK (1 << 0) /* CMD CRC Fail Mask */
#define DAT_CRC_FAIL_MASK (1 << 1) /* Data CRC Fail Mask */
#define CMD_TIMEOUT_MASK (1 << 2) /* CMD Time Out Mask */
#define DAT_TIMEOUT_MASK (1 << 3) /* Data Time Out Mask */
#define TX_UNDERRUN_MASK (1 << 4) /* Transmit Underrun Mask */
#define RX_OVERRUN_MASK (1 << 5) /* Receive Overrun Mask */
#define CMD_RESP_END_MASK (1 << 6) /* CMD Response End Mask */
#define CMD_SENT_MASK (1 << 7) /* CMD Sent Mask */
#define DAT_END_MASK (1 << 8) /* Data End Mask */
#define START_BIT_ERR_MASK (1 << 9) /* Start Bit Error Mask */
#define DAT_BLK_END_MASK (1 << 10) /* Data Block End Mask */
#define CMD_ACT_MASK (1 << 11) /* CMD Active Mask */
#define TX_ACT_MASK (1 << 12) /* Transmit Active Mask */
#define RX_ACT_MASK (1 << 13) /* Receive Active Mask */
#define TX_FIFO_STAT_MASK (1 << 14) /* Transmit FIFO Status Mask */
#define RX_FIFO_STAT_MASK (1 << 15) /* Receive FIFO Status Mask */
#define TX_FIFO_FULL_MASK (1 << 16) /* Transmit FIFO Full Mask */
#define RX_FIFO_FULL_MASK (1 << 17) /* Receive FIFO Full Mask */
#define TX_FIFO_ZERO_MASK (1 << 18) /* Transmit FIFO Empty Mask */
#define RX_DAT_ZERO_MASK (1 << 19) /* Receive FIFO Empty Mask */
#define TX_DAT_RDY_MASK (1 << 20) /* Transmit Data Available Mask */
#define RX_FIFO_RDY_MASK (1 << 21) /* Receive Data Available Mask */
/* SDH_FIFO_CNT bitmasks */
#define FIFO_COUNT 0x7fff /* FIFO Count */
/* SDH_E_STATUS bitmasks */
#define SDIO_INT_DET (1 << 1) /* SDIO Int Detected */
#define SD_CARD_DET (1 << 4) /* SD Card Detect */
/* SDH_E_MASK bitmasks */
#define SDIO_MSK (1 << 1) /* Mask SDIO Int Detected */
#define SCD_MSK (1 << 6) /* Mask Card Detect */
/* SDH_CFG bitmasks */
#define CLKS_EN (1 << 0) /* Clocks Enable */
#define SD4E (1 << 2) /* SDIO 4-Bit Enable */
#define MWE (1 << 3) /* Moving Window Enable */
#define SD_RST (1 << 4) /* SDMMC Reset */
#define PUP_SDDAT (1 << 5) /* Pull-up SD_DAT */
#define PUP_SDDAT3 (1 << 6) /* Pull-up SD_DAT3 */
#define PD_SDDAT3 (1 << 7) /* Pull-down SD_DAT3 */
/* SDH_RD_WAIT_EN bitmasks */
#define RWR (1 << 0) /* Read Wait Request */
#endif
|
