1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
|
/*
* linux/arch/arm/mach-pxa/cm-x255.c
*
* Copyright (C) 2007, 2008 CompuLab, Ltd.
* Mike Rapoport <mike@compulab.co.il>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/platform_device.h>
#include <linux/irq.h>
#include <linux/gpio.h>
#include <linux/mtd/partitions.h>
#include <linux/mtd/physmap.h>
#include <linux/mtd/nand-gpio.h>
#include <linux/spi/spi.h>
#include <asm/mach/arch.h>
#include <asm/mach-types.h>
#include <asm/mach/map.h>
#include <mach/pxa25x.h>
#include <mach/pxa2xx_spi.h>
#include "generic.h"
#define GPIO_NAND_CS (5)
#define GPIO_NAND_ALE (4)
#define GPIO_NAND_CLE (3)
#define GPIO_NAND_RB (10)
static unsigned long cmx255_pin_config[] = {
/* AC'97 */
GPIO28_AC97_BITCLK,
GPIO29_AC97_SDATA_IN_0,
GPIO30_AC97_SDATA_OUT,
GPIO31_AC97_SYNC,
/* BTUART */
GPIO42_BTUART_RXD,
GPIO43_BTUART_TXD,
GPIO44_BTUART_CTS,
GPIO45_BTUART_RTS,
/* STUART */
GPIO46_STUART_RXD,
GPIO47_STUART_TXD,
/* LCD */
GPIOxx_LCD_TFT_16BPP,
/* SSP1 */
GPIO23_SSP1_SCLK,
GPIO24_SSP1_SFRM,
GPIO25_SSP1_TXD,
GPIO26_SSP1_RXD,
/* SSP2 */
GPIO81_SSP2_CLK_OUT,
GPIO82_SSP2_FRM_OUT,
GPIO83_SSP2_TXD,
GPIO84_SSP2_RXD,
/* PC Card */
GPIO48_nPOE,
GPIO49_nPWE,
GPIO50_nPIOR,
GPIO51_nPIOW,
GPIO52_nPCE_1,
GPIO53_nPCE_2,
GPIO54_nPSKTSEL,
GPIO55_nPREG,
GPIO56_nPWAIT,
GPIO57_nIOIS16,
/* SDRAM and local bus */
GPIO15_nCS_1,
GPIO78_nCS_2,
GPIO79_nCS_3,
GPIO80_nCS_4,
GPIO33_nCS_5,
GPIO18_RDY,
/* GPIO */
GPIO0_GPIO | WAKEUP_ON_EDGE_BOTH,
GPIO9_GPIO, /* PC card reset */
/* NAND controls */
GPIO5_GPIO | MFP_LPM_DRIVE_HIGH, /* NAND CE# */
GPIO4_GPIO | MFP_LPM_DRIVE_LOW, /* NAND ALE */
GPIO3_GPIO | MFP_LPM_DRIVE_LOW, /* NAND CLE */
GPIO10_GPIO, /* NAND Ready/Busy */
/* interrupts */
GPIO22_GPIO, /* DM9000 interrupt */
};
#if defined(CONFIG_SPI_PXA2XX)
static struct pxa2xx_spi_master pxa_ssp_master_info = {
.num_chipselect = 1,
};
static struct spi_board_info spi_board_info[] __initdata = {
[0] = {
.modalias = "rtc-max6902",
.max_speed_hz = 1000000,
.bus_num = 1,
.chip_select = 0,
},
};
static void __init cmx255_init_rtc(void)
{
pxa2xx_set_spi_info(1, &pxa_ssp_master_info);
spi_register_board_info(ARRAY_AND_SIZE(spi_board_info));
}
#else
static inline void cmx255_init_rtc(void) {}
#endif
#if defined(CONFIG_MTD_PHYSMAP) || defined(CONFIG_MTD_PHYSMAP_MODULE)
static struct mtd_partition cmx255_nor_partitions[] = {
{
.name = "ARMmon",
.size = 0x00030000,
.offset = 0,
.mask_flags = MTD_WRITEABLE /* force read-only */
} , {
.name = "ARMmon setup block",
.size = 0x00010000,
.offset = MTDPART_OFS_APPEND,
.mask_flags = MTD_WRITEABLE /* force read-only */
} , {
.name = "kernel",
.size = 0x00160000,
.offset = MTDPART_OFS_APPEND,
} , {
.name = "ramdisk",
.size = MTDPART_SIZ_FULL,
.offset = MTDPART_OFS_APPEND
}
};
static struct physmap_flash_data cmx255_nor_flash_data[] = {
{
.width = 2, /* bankwidth in bytes */
.parts = cmx255_nor_partitions,
.nr_parts = ARRAY_SIZE(cmx255_nor_partitions)
}
};
static struct resource cmx255_nor_resource = {
.start = PXA_CS0_PHYS,
.end = PXA_CS0_PHYS + SZ_8M - 1,
.flags = IORESOURCE_MEM,
};
static struct platform_device cmx255_nor = {
.name = "physmap-flash",
.id = -1,
.dev = {
.platform_data = cmx255_nor_flash_data,
},
.resource = &cmx255_nor_resource,
.num_resources = 1,
};
static void __init cmx255_init_nor(void)
{
platform_device_register(&cmx255_nor);
}
#else
static inline void cmx255_init_nor(void) {}
#endif
#if defined(CONFIG_MTD_NAND_GPIO) || defined(CONFIG_MTD_NAND_GPIO_MODULE)
static struct resource cmx255_nand_resource[] = {
[0] = {
.start = PXA_CS1_PHYS,
.end = PXA_CS1_PHYS + 11,
.flags = IORESOURCE_MEM,
},
[1] = {
.start = PXA_CS5_PHYS,
.end = PXA_CS5_PHYS + 3,
.flags = IORESOURCE_MEM,
},
};
static struct mtd_partition cmx255_nand_parts[] = {
[0] = {
.name = "cmx255-nand",
.size = MTDPART_SIZ_FULL,
.offset = 0,
},
};
static struct gpio_nand_platdata cmx255_nand_platdata = {
.gpio_nce = GPIO_NAND_CS,
.gpio_cle = GPIO_NAND_CLE,
.gpio_ale = GPIO_NAND_ALE,
.gpio_rdy = GPIO_NAND_RB,
.gpio_nwp = -1,
.parts = cmx255_nand_parts,
.num_parts = ARRAY_SIZE(cmx255_nand_parts),
.chip_delay = 25,
};
static struct platform_device cmx255_nand = {
.name = "gpio-nand",
.num_resources = ARRAY_SIZE(cmx255_nand_resource),
.resource = cmx255_nand_resource,
.id = -1,
.dev = {
.platform_data = &cmx255_nand_platdata,
}
};
static void __init cmx255_init_nand(void)
{
platform_device_register(&cmx255_nand);
}
#else
static inline void cmx255_init_nand(void) {}
#endif
void __init cmx255_init(void)
{
pxa2xx_mfp_config(ARRAY_AND_SIZE(cmx255_pin_config));
cmx255_init_rtc();
cmx255_init_nor();
cmx255_init_nand();
}
|
