1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
|
Device tree bindings for OMAP general purpose memory controllers (GPMC)
The actual devices are instantiated from the child nodes of a GPMC node.
Required properties:
- compatible: Should be set to one of the following:
ti,omap2420-gpmc (omap2420)
ti,omap2430-gpmc (omap2430)
ti,omap3430-gpmc (omap3430 & omap3630)
ti,omap4430-gpmc (omap4430 & omap4460 & omap543x)
ti,am3352-gpmc (am335x devices)
- reg: A resource specifier for the register space
(see the example below)
- ti,hwmods: Should be set to "ti,gpmc" until the DT transition is
completed.
- #address-cells: Must be set to 2 to allow memory address translation
- #size-cells: Must be set to 1 to allow CS address passing
- gpmc,num-cs: The maximum number of chip-select lines that controller
can support.
- gpmc,num-waitpins: The maximum number of wait pins that controller can
support.
- ranges: Must be set up to reflect the memory layout with four
integer values for each chip-select line in use:
<cs-number> 0 <physical address of mapping> <size>
Currently, calculated values derived from the contents
of the per-CS register GPMC_CONFIG7 (as set up by the
bootloader) are used for the physical address decoding.
As this will change in the future, filling correct
values here is a requirement.
Timing properties for child nodes. All are optional and default to 0.
- gpmc,sync-clk: Minimum clock period for synchronous mode, in picoseconds
Chip-select signal timings corresponding to GPMC_CONFIG2:
- gpmc,cs-on: Assertion time
- gpmc,cs-rd-off: Read deassertion time
- gpmc,cs-wr-off: Write deassertion time
ADV signal timings corresponding to GPMC_CONFIG3:
- gpmc,adv-on: Assertion time
- gpmc,adv-rd-off: Read deassertion time
- gpmc,adv-wr-off: Write deassertion time
WE signals timings corresponding to GPMC_CONFIG4:
- gpmc,we-on: Assertion time
- gpmc,we-off: Deassertion time
OE signals timings corresponding to GPMC_CONFIG4:
- gpmc,oe-on: Assertion time
- gpmc,oe-off: Deassertion time
Access time and cycle time timings corresponding to GPMC_CONFIG5:
- gpmc,page-burst-access: Multiple access word delay
- gpmc,access: Start-cycle to first data valid delay
- gpmc,rd-cycle: Total read cycle time
- gpmc,wr-cycle: Total write cycle time
The following are only applicable to OMAP3+ and AM335x:
- gpmc,wr-access
- gpmc,wr-data-mux-bus
Example for an AM33xx board:
gpmc: gpmc@50000000 {
compatible = "ti,am3352-gpmc";
ti,hwmods = "gpmc";
reg = <0x50000000 0x2000>;
interrupts = <100>;
gpmc,num-cs = <8>;
gpmc,num-waitpins = <2>;
#address-cells = <2>;
#size-cells = <1>;
ranges = <0 0 0x08000000 0x10000000>; /* CS0 @addr 0x8000000, size 0x10000000 */
/* child nodes go here */
};
|
