From abb4a2390737867353ebafc012d45f2b03f3f944 Mon Sep 17 00:00:00 2001 From: David Gibson Date: Sun, 6 May 2007 14:48:49 -0700 Subject: serial: define FIXED_PORT flag for serial_core At present, the serial core always allows setserial in userspace to change the port address, irq and base clock of any serial port. That makes sense for legacy ISA ports, but not for (say) embedded ns16550 compatible serial ports at peculiar addresses. In these cases, the kernel code configuring the ports must know exactly where they are, and their clocking arrangements (which can be unusual on embedded boards). It doesn't make sense for userspace to change these settings. Therefore, this patch defines a UPF_FIXED_PORT flag for the uart_port structure. If this flag is set when the serial port is configured, any attempts to alter the port's type, io address, irq or base clock with setserial are ignored. In addition this patch uses the new flag for on-chip serial ports probed in arch/powerpc/kernel/legacy_serial.c, and for other hard-wired serial ports probed by drivers/serial/of_serial.c. Signed-off-by: David Gibson Cc: Russell King Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- drivers/serial/of_serial.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) (limited to 'drivers/serial/of_serial.c') diff --git a/drivers/serial/of_serial.c b/drivers/serial/of_serial.c index 09b0b736a75..336d0f4580d 100644 --- a/drivers/serial/of_serial.c +++ b/drivers/serial/of_serial.c @@ -48,7 +48,8 @@ static int __devinit of_platform_serial_setup(struct of_device *ofdev, port->iotype = UPIO_MEM; port->type = type; port->uartclk = *clk; - port->flags = UPF_SHARE_IRQ | UPF_BOOT_AUTOCONF | UPF_IOREMAP; + port->flags = UPF_SHARE_IRQ | UPF_BOOT_AUTOCONF | UPF_IOREMAP + | UPF_FIXED_PORT; port->dev = &ofdev->dev; port->custom_divisor = *clk / (16 * (*spd)); -- cgit v1.2.3-18-g5258