From ecc8635608342a05ded722f0e30e6ccd682f84a6 Mon Sep 17 00:00:00 2001 From: Stephen Hemminger Date: Fri, 10 Jan 2014 14:01:05 -0700 Subject: PCI: Remove unused Optimized Buffer Flush/Fill support My philosophy is unused code is dead code. And dead code is subject to bit rot and is a likely source of bugs. Use it or lose it. This reverts 48a92a8179b3 ("PCI: add OBFF enable/disable support"), removing these interfaces: pci_enable_obff() pci_disable_obff() [bhelgaas: split to separate patch, also remove prototypes from pci.h] Signed-off-by: Stephen Hemminger Signed-off-by: Bjorn Helgaas CC: Jesse Barnes --- drivers/pci/pci.c | 73 ------------------------------------------------------- 1 file changed, 73 deletions(-) (limited to 'drivers/pci/pci.c') diff --git a/drivers/pci/pci.c b/drivers/pci/pci.c index 020f672deab..84a24d16778 100644 --- a/drivers/pci/pci.c +++ b/drivers/pci/pci.c @@ -2150,79 +2150,6 @@ void pci_disable_ido(struct pci_dev *dev, unsigned long type) } EXPORT_SYMBOL(pci_disable_ido); -/** - * pci_enable_obff - enable optimized buffer flush/fill - * @dev: PCI device - * @type: type of signaling to use - * - * Try to enable @type OBFF signaling on @dev. It will try using WAKE# - * signaling if possible, falling back to message signaling only if - * WAKE# isn't supported. @type should indicate whether the PCIe link - * be brought out of L0s or L1 to send the message. It should be either - * %PCI_EXP_OBFF_SIGNAL_ALWAYS or %PCI_OBFF_SIGNAL_L0. - * - * If your device can benefit from receiving all messages, even at the - * power cost of bringing the link back up from a low power state, use - * %PCI_EXP_OBFF_SIGNAL_ALWAYS. Otherwise, use %PCI_OBFF_SIGNAL_L0 (the - * preferred type). - * - * RETURNS: - * Zero on success, appropriate error number on failure. - */ -int pci_enable_obff(struct pci_dev *dev, enum pci_obff_signal_type type) -{ - u32 cap; - u16 ctrl; - int ret; - - pcie_capability_read_dword(dev, PCI_EXP_DEVCAP2, &cap); - if (!(cap & PCI_EXP_DEVCAP2_OBFF_MASK)) - return -ENOTSUPP; /* no OBFF support at all */ - - /* Make sure the topology supports OBFF as well */ - if (dev->bus->self) { - ret = pci_enable_obff(dev->bus->self, type); - if (ret) - return ret; - } - - pcie_capability_read_word(dev, PCI_EXP_DEVCTL2, &ctrl); - if (cap & PCI_EXP_DEVCAP2_OBFF_WAKE) - ctrl |= PCI_EXP_DEVCTL2_OBFF_WAKE_EN; - else { - switch (type) { - case PCI_EXP_OBFF_SIGNAL_L0: - if (!(ctrl & PCI_EXP_DEVCTL2_OBFF_WAKE_EN)) - ctrl |= PCI_EXP_DEVCTL2_OBFF_MSGA_EN; - break; - case PCI_EXP_OBFF_SIGNAL_ALWAYS: - ctrl &= ~PCI_EXP_DEVCTL2_OBFF_WAKE_EN; - ctrl |= PCI_EXP_DEVCTL2_OBFF_MSGB_EN; - break; - default: - WARN(1, "bad OBFF signal type\n"); - return -ENOTSUPP; - } - } - pcie_capability_write_word(dev, PCI_EXP_DEVCTL2, ctrl); - - return 0; -} -EXPORT_SYMBOL(pci_enable_obff); - -/** - * pci_disable_obff - disable optimized buffer flush/fill - * @dev: PCI device - * - * Disable OBFF on @dev. - */ -void pci_disable_obff(struct pci_dev *dev) -{ - pcie_capability_clear_word(dev, PCI_EXP_DEVCTL2, - PCI_EXP_DEVCTL2_OBFF_WAKE_EN); -} -EXPORT_SYMBOL(pci_disable_obff); - static int pci_acs_enable; /** -- cgit v1.2.3-18-g5258