From b4084bcf5ae833e049b0c428868de7e4efae2e4f Mon Sep 17 00:00:00 2001 From: Richard Genoud Date: Fri, 22 Jun 2012 15:29:28 +0200 Subject: ARM: at91/defconfig: Remove unaffected config option The commit bf4289cba02b8cf770ecd7959ca70839f0dd9d3c removed the use of CONFIG_MTD_NAND_ATMEL_ECC_NONE and CONFIG_MTD_NAND_ATMEL_ECC_HW but the Kconfig file was forgotten. This patch remove those inoperative options. Signed-off-by: Richard Genoud Signed-off-by: Nicolas Ferre --- drivers/mtd/nand/Kconfig | 40 ---------------------------------------- 1 file changed, 40 deletions(-) (limited to 'drivers/mtd') diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig index 31bb7e5b504..0d934079895 100644 --- a/drivers/mtd/nand/Kconfig +++ b/drivers/mtd/nand/Kconfig @@ -406,46 +406,6 @@ config MTD_NAND_ATMEL help Enables support for NAND Flash / Smart Media Card interface on Atmel AT91 and AVR32 processors. -choice - prompt "ECC management for NAND Flash / SmartMedia on AT91 / AVR32" - depends on MTD_NAND_ATMEL - -config MTD_NAND_ATMEL_ECC_HW - bool "Hardware ECC" - depends on ARCH_AT91SAM9263 || ARCH_AT91SAM9260 || AVR32 - help - Use hardware ECC instead of software ECC when the chip - supports it. - - The hardware ECC controller is capable of single bit error - correction and 2-bit random detection per page. - - NB : hardware and software ECC schemes are incompatible. - If you switch from one to another, you'll have to erase your - mtd partition. - - If unsure, say Y - -config MTD_NAND_ATMEL_ECC_SOFT - bool "Software ECC" - help - Use software ECC. - - NB : hardware and software ECC schemes are incompatible. - If you switch from one to another, you'll have to erase your - mtd partition. - -config MTD_NAND_ATMEL_ECC_NONE - bool "No ECC (testing only, DANGEROUS)" - depends on DEBUG_KERNEL - help - No ECC will be used. - It's not a good idea and it should be reserved for testing - purpose only. - - If unsure, say N - -endchoice config MTD_NAND_PXA3xx tristate "Support for NAND flash devices on PXA3xx" -- cgit v1.2.3-18-g5258