From 96dcc08b0c6b730474469b10ed5eeda06e617deb Mon Sep 17 00:00:00 2001 From: Sergei Shtylyov Date: Tue, 3 Jul 2007 22:28:35 +0200 Subject: hpt366: use correct enablebits for HPT36x The HPT36x chips finally turned out to have the channel enable bits -- however, badly implemented. Make use of them despite it's probably only going to burden the driver's code -- assuming both channels are always enabled by the HighPoint BIOS anyway... Signed-off-by: Sergei Shtylyov Acked-by: Linas Vepstas Cc: michal.kepien@poczta.onet.pl Signed-off-by: Bartlomiej Zolnierkiewicz --- drivers/ide/pci/hpt366.c | 20 +++++++++++++++----- 1 file changed, 15 insertions(+), 5 deletions(-) (limited to 'drivers/ide/pci/hpt366.c') diff --git a/drivers/ide/pci/hpt366.c b/drivers/ide/pci/hpt366.c index 4f8017ac990..c33d0b0f11c 100644 --- a/drivers/ide/pci/hpt366.c +++ b/drivers/ide/pci/hpt366.c @@ -1,5 +1,5 @@ /* - * linux/drivers/ide/pci/hpt366.c Version 1.05 Jun 26, 2007 + * linux/drivers/ide/pci/hpt366.c Version 1.06 Jun 27, 2007 * * Copyright (C) 1999-2003 Andre Hedrick * Portions Copyright (C) 2001 Sun Microsystems, Inc. @@ -1514,18 +1514,28 @@ static int __devinit init_setup_hpt366(struct pci_dev *dev, ide_pci_device_t *d) goto init_single; /* - * HPT36x chips are single channel and - * do not seem to have the channel enable bit... + * HPT36x chips have one channel per function and have + * both channel enable bits located differently and visible + * to both functions -- really stupid design decision... :-( + * Bit 4 is for the primary channel, bit 5 for the secondary. */ d->channels = 1; - d->enablebits[0].reg = 0; + d->enablebits[0].mask = d->enablebits[0].val = 0x10; if ((dev2 = pci_get_slot(dev->bus, dev->devfn + 1)) != NULL) { - u8 pin1 = 0, pin2 = 0; + u8 mcr1 = 0, pin1 = 0, pin2 = 0; int ret; pci_set_drvdata(dev2, info[rev]); + /* + * Now we'll have to force both channels enabled if + * at least one of them has been enabled by BIOS... + */ + pci_read_config_byte(dev, 0x50, &mcr1); + if (mcr1 & 0x30) + pci_write_config_byte(dev, 0x50, mcr1 | 0x30); + pci_read_config_byte(dev, PCI_INTERRUPT_PIN, &pin1); pci_read_config_byte(dev2, PCI_INTERRUPT_PIN, &pin2); if (pin1 != pin2 && dev->irq == dev2->irq) { -- cgit v1.2.3-18-g5258