From b98da4db297bad34a5577df36ff4cb2a8fc90923 Mon Sep 17 00:00:00 2001 From: Linus Walleij Date: Sun, 19 May 2013 00:47:39 +0200 Subject: ARM: nomadik: fix IRQ assignment for SMC ethernet The assignment of IRQ for the SMC91x ethernet adapter had two problems making it non-working: - It was not put into the ethernet device node. Let's do this by using the board-specific overlay, so we can make other overlays on other Nomadik boards. - The IRQ number was actually completely wrong, this was the number for NHK8815, not S8815. After this ethernet starts working on the USB S8815. Signed-off-by: Linus Walleij Signed-off-by: Olof Johansson --- arch/arm/boot/dts/ste-nomadik-s8815.dts | 12 +++++++++--- 1 file changed, 9 insertions(+), 3 deletions(-) (limited to 'arch') diff --git a/arch/arm/boot/dts/ste-nomadik-s8815.dts b/arch/arm/boot/dts/ste-nomadik-s8815.dts index b28fbf3408e..6f82d936894 100644 --- a/arch/arm/boot/dts/ste-nomadik-s8815.dts +++ b/arch/arm/boot/dts/ste-nomadik-s8815.dts @@ -14,13 +14,19 @@ bootargs = "root=/dev/ram0 console=ttyAMA1,115200n8 earlyprintk"; }; + /* This is where the interrupt is routed on the S8815 board */ + external-bus@34000000 { + ethernet@300 { + interrupt-parent = <&gpio3>; + interrupts = <8 0x1>; + }; + }; + /* Custom board node with GPIO pins to active etc */ usb-s8815 { /* The S8815 is using this very GPIO pin for the SMSC91x IRQs */ ethernet-gpio { - gpios = <&gpio3 19 0x1>; - interrupts = <19 0x1>; - interrupt-parent = <&gpio3>; + gpios = <&gpio3 8 0x1>; }; /* This will bias the MMC/SD card detect line */ mmcsd-gpio { -- cgit v1.2.3-18-g5258