From fe7ca2e1e847b65c12d245cbf402af89da96888a Mon Sep 17 00:00:00 2001 From: Brian Haley Date: Wed, 4 Mar 2009 03:18:11 -0800 Subject: IPv6: add "disable" module parameter support to ipv6.ko Add "disable" module parameter support to ipv6.ko by specifying "disable=1" on module load. We just do the minimum of initializing inetsw6[] so calls from other modules to inet6_register_protosw() won't OOPs, then bail out. No IPv6 addresses or sockets can be created as a result, and a reboot is required to enable IPv6. Signed-off-by: Brian Haley Signed-off-by: David S. Miller --- Documentation/networking/ipv6.txt | 35 +++++++++++++++++++++++++++++++++++ 1 file changed, 35 insertions(+) create mode 100644 Documentation/networking/ipv6.txt (limited to 'Documentation') diff --git a/Documentation/networking/ipv6.txt b/Documentation/networking/ipv6.txt new file mode 100644 index 00000000000..268e5c103dd --- /dev/null +++ b/Documentation/networking/ipv6.txt @@ -0,0 +1,35 @@ + +Options for the ipv6 module are supplied as parameters at load time. + +Module options may be given as command line arguments to the insmod +or modprobe command, but are usually specified in either the +/etc/modules.conf or /etc/modprobe.conf configuration file, or in a +distro-specific configuration file. + +The available ipv6 module parameters are listed below. If a parameter +is not specified the default value is used. + +The parameters are as follows: + +disable + + Specifies whether to load the IPv6 module, but disable all + its functionality. This might be used when another module + has a dependency on the IPv6 module being loaded, but no + IPv6 addresses or operations are desired. + + The possible values and their effects are: + + 0 + IPv6 is enabled. + + This is the default value. + + 1 + IPv6 is disabled. + + No IPv6 addresses will be added to interfaces, and + it will not be possible to open an IPv6 socket. + + A reboot is required to enable IPv6. + -- cgit v1.2.3-18-g5258