Age | Commit message (Expand) | Author |
2008-02-06 | Blackfin RTC driver: use dev_dbg() rather than pr_stamp() | Mike Frysinger |
2008-02-06 | Blackfin RTC driver: cleanup proc handler (we dont need RTC reg dump now that... | Mike Frysinger |
2008-02-06 | Blackfin RTC driver: we pass in a (struct device*) to the irq handler, not a ... | Mike Frysinger |
2008-02-06 | Blackfin RTC driver: the frequency function is in units of Hz, not units of s... | Mike Frysinger |
2008-02-06 | Platform real time clock driver for Dallas 1511 chip | Andrew Sharp |
2008-02-06 | rtc-cmos alarm acts as oneshot | David Brownell |
2008-02-06 | rtc: ds1302 rtc support | Paul Mundt |
2008-02-06 | rtc-cmos: export nvram in sysfs | David Brownell |
2008-02-06 | rtc-s3c: Use is_power_of_2() macro for simplicity. | Robert P. J. Day |
2008-02-06 | rtc-pcf8583: Don't abuse I2C_M_NOSTART | Jean Delvare |
2008-02-06 | Cosmetic fixes to RTC subsystem's Kconfig | Alessandro Zummo |
2008-02-06 | drivers/isdn/hardware/eicon/debug.c: fix uninitialized var warning | Andrew Morton |
2008-02-06 | drivers/isdn/hardware/eicon/message.c fix 'and' typo in eicons' AddInfo() | Roel Kluin |
2008-02-06 | ser_gigaset: convert mutex to completion | Tilman Schmidt |
2008-02-06 | Gigaset: permit module unload | Tilman Schmidt |
2008-02-06 | gigaset: atomic cleanup | Tilman Schmidt |
2008-02-06 | usb_gigaset: suspend support | Tilman Schmidt |
2008-02-06 | bas_gigaset: suspend support | Tilman Schmidt |
2008-02-06 | gigaset: code cleanups | Tilman Schmidt |
2008-02-06 | gigaset: clean up urb->status usage | Tilman Schmidt |
2008-02-06 | spi: remove more dev->power.power_state usage | David Brownell |
2008-02-06 | spi_bfin: headers are not for changelogs | Mike Frysinger |
2008-02-06 | spi_bfin: wait for tx to complete on write paths | Sonic Zhang |
2008-02-06 | spi_bfin: wait for tx to complete on full duplex paths | Bryan Wu |
2008-02-06 | spi_bfin: wait for tx to complete on some cs_chg paths | Bryan Wu |
2008-02-06 | spi_bfin: use more useful GPIO labels | Bryan Wu |
2008-02-06 | spi_bfin: remove useless fault path | Bryan Wu |
2008-02-06 | spi: omap2_mcspi handles omap3 too | Girish |
2008-02-06 | spi: SuperH SPI using SCI | Magnus Damm |
2008-02-06 | spi: s3c drivers shouldn't care about spi_board_info | David Brownell |
2008-02-06 | atmel_spi: fix dmachain oops with DEBUG enabled | Haavard Skinnemoen |
2008-02-06 | atmel_spi: chain DMA transfers | Silvester Erdeg |
2008-02-06 | atmel_spi throughput improvement | Haavard Skinnemoen |
2008-02-06 | spi core: stop updating dev->power.power_state | David Brownell |
2008-02-06 | Atari floppy: Rename disk_type to atari_disk_type | Geert Uytterhoeven |
2008-02-06 | W1: w1_therm.c standardize units to millidegrees C | David Fries |
2008-02-06 | drivers/cdrom/cdrom.c: simplify logic in cdrom_release() | Borislav Petkov |
2008-02-06 | w1: remove unused and confusing variable. | Evgeniy Polyakov |
2008-02-06 | tpm: infineon section mismatch | Randy Dunlap |
2008-02-06 | phantom: don't grab other devices | Jiri Slaby |
2008-02-06 | Claim maintainership for block2mtd and update email addresses | Joern Engel |
2008-02-06 | Fix IXANY and restart after signal (e.g. ctrl-C) in n_tty line discipline | Joe Peterson |
2008-02-06 | calibrate_delay() must be __cpuinit | Adrian Bunk |
2008-02-06 | parport_pc: detection for SuperIO IT87XX POST | Petr Cvek |
2008-02-06 | ik8: add Dell UK 6400 Inspiron model (MM061) | Nick Warne |
2008-02-06 | parport_serial: netmos 9855 fix | Christian Pellegrin |
2008-02-06 | parport: add support for the Quatech SPPXP-100 Parallel port PCI ExpressCard | Luís P Mendes |
2008-02-06 | Amiga serial driver: port_write_mutex fixup | Daniel Walker |
2008-02-06 | drivers/char/ipmi/ipmi_msghandler.c: use LIST_HEAD instead of LIST_HEAD_INIT | Denis Cheng |
2008-02-06 | tty: enable the echoing of ^C in the N_TTY discipline | Joe Peterson |