aboutsummaryrefslogtreecommitdiff
path: root/drivers/net/ethernet/realtek/8139cp.c
AgeCommit message (Collapse)Author
2012-12-018139cp: fix coherent mapping leak in error path.françois romieu
cp_open [...] rc = cp_alloc_rings(cp); if (rc) return rc; cp_alloc_rings [...] mem = dma_alloc_coherent(&cp->pdev->dev, CP_RING_BYTES, &cp->ring_dma, GFP_KERNEL); - cp_alloc_rings never frees the coherent mapping it allocates - neither do cp_open when cp_alloc_rings fails Signed-off-by: Francois Romieu <romieu@fr.zoreil.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-11-238139cp: revert "set ring address before enabling receiver"françois romieu
This patch reverts b01af4579ec41f48e9b9c774e70bd6474ad210db. The original patch was tested with emulated hardware. Real hardware chokes. Fixes https://bugzilla.kernel.org/show_bug.cgi?id=47041 Signed-off-by: Francois Romieu <romieu@fr.zoreil.com> Acked-by: Jeff Garzik <jgarzik@redhat.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-10-08net: gro: selective flush of packetsEric Dumazet
Current GRO can hold packets in gro_list for almost unlimited time, in case napi->poll() handler consumes its budget over and over. In this case, napi_complete()/napi_gro_flush() are not called. Another problem is that gro_list is flushed in non friendly way : We scan the list and complete packets in the reverse order. (youngest packets first, oldest packets last) This defeats priorities that sender could have cooked. Since GRO currently only store TCP packets, we dont really notice the bug because of retransmits, but this behavior can add unexpected latencies, particularly on mice flows clamped by elephant flows. This patch makes sure no packet can stay more than 1 ms in queue, and only in stress situations. It also complete packets in the right order to minimize latencies. Signed-off-by: Eric Dumazet <edumazet@google.com> Cc: Herbert Xu <herbert@gondor.apana.org.au> Cc: Jesse Gross <jesse@nicira.com> Cc: Tom Herbert <therbert@google.com> Cc: Yuchung Cheng <ycheng@google.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-06-018139cp/8139too: terminate the eeprom access with the right opmodeJason Wang
Currently, we terminate the eeprom access through clearing the CS by: RTL_W8 (Cfg9346, ~EE_CS); or writeb (~EE_CS, ee_addr); This would left the eeprom into "Config. Register Write Enable:" state which is not expcted as the highest two bits were set to 0x11 ( expected is the "Normal" mode (0x00)). Solving this by write 0x0 instead of ~EE_CS when terminating the eeprom access. Signed-off-by: Jason Wang <jasowang@redhat.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-06-018139cp: set ring address before enabling receiverJason Wang
Currently, we enable the receiver before setting the ring address which could lead the card DMA into unexpected areas. Solving this by set the ring address before enabling the receiver. btw. I find and test this in qemu as I didn't have a 8139cp card in hand. please review it carefully. Signed-off-by: Jason Wang <jasowang@redhat.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-15Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/netDavid S. Miller
Conflicts: drivers/net/ethernet/atheros/atlx/atl1.c drivers/net/ethernet/atheros/atlx/atl1.h Resolved a conflict between a DMA error bug fix and NAPI support changes in the atl1 driver. Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-138139cp: set intr mask after its handler is registeredJason Wang
We set intr mask before its handler is registered, this does not work well when 8139cp is sharing irq line with other devices. As the irq could be enabled by the device before 8139cp's hander is registered which may lead unhandled irq. Fix this by introducing an helper cp_irq_enable() and call it after request_irq(). Signed-off-by: Jason Wang <jasowang@redhat.com> Reviewed-by: Flavio Leitner <fbl@redhat.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-04-078139cp: stop using net_device.{base_addr, irq}.Francois Romieu
Signed-off-by: Francois Romieu <romieu@fr.zoreil.com>
2012-01-088139cp: fix missing napi_gro_flush.françois romieu
The driver uses __napi_complete and napi_gro_receive. Without it, the driver hits the BUG_ON(n->gro_list) assertion hard in __napi_complete. Signed-off-by: Francois Romieu <romieu@fr.zoreil.com> Tested-by: Marin Glibic <zhilla2@gmail.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-01-038139cp: properly config rx mode after resumingJason Wang
Rx mode should be reset after resming, so unconditionally updating rx mode rather than conditionally updating based on the value we remembered, otherwise unexpected value may be used by the nic after resuming. btw. I find and test this when debugging guest hibernation in qemu, as I did not have a 8139cp card in hand, this patch is untested in a physical 8139cp card, plase review it carefully. Signed-off-by: Jason Wang <jasowang@redhat.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2012-01-038139cp/8139too: do not read into reserved registersJason Wang
delay_eeprom() use long read for Cfg9346 register(offset 0x50) which may read into the area of reserved register(offset 0x53). Use byte read instead. Signed-off-by: Jason Wang <jasowang@redhat.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-11-16net: introduce and use netdev_features_t for device features setsMichał Mirosław
v2: add couple missing conversions in drivers split unexporting netdev_fix_features() implemented %pNF convert sock::sk_route_(no?)caps Signed-off-by: Michał Mirosław <mirq-linux@rere.qmqm.pl> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-11-08sweep the floors and convert some .get_drvinfo routines to strlcpyRick Jones
Per the mention made by Ben Hutchings that strlcpy is now the preferred string copy routine for a .get_drvinfo routine, do a bit of floor sweeping and convert some of the as-yet unconverted ethernet drivers to it. Signed-off-by: Rick Jones <rick.jones2@hp.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-10-19net: add skb frag size accessorsEric Dumazet
To ease skb->truesize sanitization, its better to be able to localize all references to skb frags size. Define accessors : skb_frag_size() to fetch frag size, and skb_frag_size_{set|add|sub}() to manipulate it. Signed-off-by: Eric Dumazet <eric.dumazet@gmail.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-10-07Add ethtool -g support to 8139cpRick Jones
Add support for reporting ring sizes via ethtool -g to the 8139cp driver. Signed-off-by: Rick Jones <rick.jones2@hp.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-08-308139cp: convert to SKB paged frag API.Ian Campbell
Signed-off-by: Ian Campbell <ian.campbell@citrix.com> Cc: netdev@vger.kernel.org Signed-off-by: David S. Miller <davem@davemloft.net>
2011-08-17net: remove use of ndo_set_multicast_list in driversJiri Pirko
replace it by ndo_set_rx_mode Signed-off-by: Jiri Pirko <jpirko@redhat.com> Signed-off-by: David S. Miller <davem@davemloft.net>
2011-08-118139*/atp/r8169/sc92031: Move the Realtek driversJeff Kirsher
Move the Realtek drivers into drivers/net/ethernet/realtek/ and make the necessary Kconfig and Makefile changes. CC: Realtek linux nic maintainers <nic_swsd@realtek.com> CC: Francois Romieu <romieu@fr.zoreil.com> CC: Jeff Garzik <jgarzik@pobox.com> CC: Donald Becker <becker@scyld.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
generated by cgit v1.2.3-18-g5258 (git 2.32.0) at 2025-03-25 18:40:06 +0000