| Age | Commit message (Collapse) | Author |
|---|
|
The driver now supports full 64 bit device address spaces.
So this check is not longer required.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This change allows to remove these old macros later.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch changes the alloc_pte function to be able to map
pages into the whole 64 bit address space supported by AMD
IOMMU hardware from the old limit of 2**39 bytes.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This function will be used to increase the address space
size of a protection domain.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
Thist patch introduces the update_domain function which
propagates the larger address space of a protection domain
to the device table and flushes all relevant DTEs and the
domain TLB.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This function factors out some logic of attach_device to a
seperate function. This new function will be used to update
device table entries when necessary.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch adds a generic variant of
amd_iommu_flush_all_devices function which flushes only the
DTEs for a given protection domain.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
Don't reimplement the page table walker in this function.
Use the generic one.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
Instead of reimplementing existing logic use fetch_pte to
walk the page table in iommu_unmap_page.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch changes the fetch_pte function in the AMD IOMMU
driver to support dynamic mapping levels.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
Instead of a panic on an comletion wait loop failure, try to
recover from that event from resetting the command buffer.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
To prevent the driver from doing recursive command buffer
resets, just panic when that recursion happens.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
On an ILLEGAL_COMMAND_ERROR the IOMMU stops executing
further commands. This patch changes the code to handle this
case better by resetting the command buffer in the IOMMU.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This function flushes all DTE entries on one IOMMU for all
devices behind this IOMMU. This is required for command
buffer resetting later.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
The amd_iommu_pd_table is indexed by protection domain
number and not by device id. So this check is broken and
must be removed.
Cc: stable@kernel.org
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch replaces the "AMD IOMMU" printk strings with the
official name for the hardware: "AMD-Vi".
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch removes some left-overs which where put into the code to
simplify merging code which also depends on changes in other trees.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch introduces a function to flush all domain tlbs
for on one given IOMMU. This is required later to reset the
command buffer on one IOMMU.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch adds code to dump the command which caused an
ILLEGAL_COMMAND_ERROR raised by the IOMMU hardware.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch adds code to dump the content of the device table
entry which caused an ILLEGAL_DEV_TABLE_ENTRY error from the
IOMMU hardware.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This sparse warning:
arch/x86/kernel/amd_iommu.c:1195:23: warning: symbol 'device_nb' was not declared. Should it be static?
triggers because device_nb is global but is only used in a
single .c file. change device_nb to static to fix that - this
also addresses the sparse warning.
This sparse warning:
arch/x86/kernel/amd_iommu.c:1766:10: warning: Using plain integer as NULL pointer
triggers because plain integer 0 is used in place of a NULL
pointer. change 0 to NULL to fix that - this also address the
sparse warning.
Signed-off-by: Jaswinder Singh Rajput <jaswinderrajput@gmail.com>
Cc: Joerg Roedel <joerg.roedel@amd.com>
LKML-Reference: <1246458194.6940.20.camel@hpdv5.satnam>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
|
|
When kexec'ing to a new kernel (for example, when crashing and launching
a kdump session), the AMD IOMMU may have cached translations. The kexec'd
kernel, during initialization, will invalidate the IOMMU device table
entries, but not the domain translations. These stale entries can cause
a device's DMA to fail, makes it rough to write a dump to disk when the
disk controller can't DMA ;-)
Signed-off-by: Chris Wright <chrisw@sous-sol.org>
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
That prefix is already included in the DUMP_printk macro. So there is no
need to repeat it in the format string.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This fixes a bug with a device that could not be assigned to a KVM guest
because it is still assigned to a dma_ops protection domain.
[chrisw: simply remove WARN_ON(), will always fire since dev->driver
will be pci-sub]
Signed-off-by: Chris Wright <chrisw@sous-sol.org>
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
Handling this event causes device assignment in KVM to fail because the
device gets re-attached as soon as the pci-stub registers as the driver
for the device.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
|
|
In alloc_coherent there is an omitted unlock on the path where mapping
fails. Add the unlock.
[ Impact: fix lock imbalance in alloc_coherent ]
Signed-off-by: Jiri Slaby <jirislaby@gmail.com>
Cc: Joerg Roedel <joerg.roedel@amd.com>
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
'amd-iommu/suspend-resume' and 'amd-iommu/extended-allocator' into amd-iommu/2.6.31
Conflicts:
arch/x86/kernel/amd_iommu.c
arch/x86/kernel/amd_iommu_init.c
|
|
This will test the automatic aperture enlargement code. This is
important because only very few devices will ever trigger this code
path. So force it under CONFIG_IOMMU_STRESS.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This forces testing of on-demand page table allocation code.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
Disabling the round-robin allocator results in reusing the same
dma-addresses again very fast. This is a good test if the iotlb flushing
is working correctly.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This parameter is not longer necessary when aperture increases
dynamically.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
By dynamically increasing the aperture the extended allocator is now
ready for use.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch makes sure no reserved addresses are allocated in an dma_ops
domain when the aperture is increased dynamically.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch prepares the dynamic increasement of dma_ops domain
apertures.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
Simplify the code a little bit by using the same unit for all address
space related state in the dma_ops domain structure.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch changes the AMD IOMMU address allocator to allow up to 32
aperture ranges per dma_ops domain.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
The code will be required when the aperture size increases dynamically
in the extended address allocator.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch makes page table allocation usable for dma_ops code.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This is a preperation for extended address allocator.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This function is required for suspend/resume support with AMD IOMMU
enabled.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This function is required for suspend/resume support with AMD IOMMU
enabled.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This patch introduces the for_each_iommu and for_each_iommu_safe macros
to simplify the developers life when having to iterate over all AMD
IOMMUs in the system.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
Some drivers may use the dma api during ->remove which will
cause a protection domain to get reattached to a device. Delay the
detach until after the driver is completely unbound.
[ joro: added a little merge helper ]
[ Impact: fix too early device<->domain removal ]
Signed-off-by: Chris Wright <chrisw@redhat.com>
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This information is only helpful for debugging. Don't print it anymore
unless explicitly requested.
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
* git://git.infradead.org/iommu-2.6:
intel-iommu: Fix address wrap on 32-bit kernel.
intel-iommu: Enable DMAR on 32-bit kernel.
intel-iommu: fix PCI device detach from virtual machine
intel-iommu: VT-d page table to support snooping control bit
iommu: Add domain_has_cap iommu_ops
intel-iommu: Snooping control support
Fixed trivial conflicts in arch/x86/Kconfig and drivers/pci/intel-iommu.c
|
|
This iommu_op can tell if domain have a specific capability, like snooping
control for Intel IOMMU, which can be used by other components of kernel to
adjust the behaviour.
Signed-off-by: Sheng Yang <sheng@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
|
|
git://git.kernel.org/pub/scm/linux/kernel/git/joro/linux-2.6-iommu into core/iommu
|
|
We try to avoid this type of ifdef and we can safely remove this
ifdef.
Signed-off-by: FUJITA Tomonori <fujita.tomonori@lab.ntt.co.jp>
Signed-off-by: Joerg Roedel <joerg.roedel@amd.com>
|
|
This converts X86 and IA64 to use include/linux/dma-mapping.h.
It's a bit large but pretty boring. The major change for X86 is
converting 'int dir' to 'enum dma_data_direction dir' in DMA mapping
operations. The major changes for IA64 is using map_page and
unmap_page instead of map_single and unmap_single.
Signed-off-by: FUJITA Tomonori <fujita.tomonori@lab.ntt.co.jp>
Acked-by: Tony Luck <tony.luck@intel.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
|
