linux - Linux kernel source tree

Age	Commit message (Collapse)	Author
2010-06-30	ARM: imx: dynamically register imx-uart devices (imx31)	Uwe Kleine-König
	Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
2010-06-30	ARM: mx3: remove paragraphs with old address of the FSF	Uwe Kleine-König
	As the kernel contains a copy of the GPL anyhow just get rid of the address specification instead of fixing it. Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
2010-05-17	mx31moboard: OTG host support for smartbot board	Philippe Rétornaz
	The Eyebot robot needs the OTG port in host mode on the smartbot. Add a new board definition so we can select the usb host/device mode at boot with the mx31moboard_baseboard boot parameter. Signed-off-by: Philippe Rétornaz <philippe.retornaz@epfl.ch> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
2010-05-17	mx31moboard: Move usb OTG device registration	Philippe Rétornaz
	In preparation for a new robot which needs the OTG port as host. This moves the OTG device registration into board initialisation. Signed-off-by: Philippe Rétornaz <philippe.retornaz@epfl.ch> Acked-by: Valentin Longchamp <valentin.longchamp@epfl.ch> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
2010-05-06	mx31smartbot: change the config of a gpio	Valentin Longchamp
	Since it is finally used on the handbot as a configuration input for the translator. Signed-off-by: Valentin Longchamp <valentin.longchamp@epfl.ch> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
2010-02-10	mx31moboard: support for the smartbot baseboard	Valentin Longchamp
	This baseboard is used on the handbot and eybot robots. The sel gpios are used as enables and rst signals on smartbot, thus the sel init is moved from mx31moboard file to board files. Signed-off-by: Valentin Longchamp <valentin.longchamp@epfl.ch> Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>