diff options
Diffstat (limited to 'include/net/mac80211.h')
| -rw-r--r-- | include/net/mac80211.h | 106 |
1 files changed, 99 insertions, 7 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 62c0ce2d1dc..cefe1b37c49 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -341,6 +341,9 @@ struct ieee80211_bss_conf { * the off-channel channel when a remain-on-channel offload is done * in hardware -- normal packets still flow and are expected to be * handled properly by the device. + * @IEEE80211_TX_INTFL_TKIP_MIC_FAILURE: Marks this packet to be used for TKIP + * testing. It will be sent out with incorrect Michael MIC key to allow + * TKIP countermeasures to be tested. * * Note: If you have to add new flags to the enumeration, then don't * forget to update %IEEE80211_TX_TEMPORARY_FLAGS when necessary. @@ -370,6 +373,7 @@ enum mac80211_tx_control_flags { IEEE80211_TX_CTL_LDPC = BIT(22), IEEE80211_TX_CTL_STBC = BIT(23) | BIT(24), IEEE80211_TX_CTL_TX_OFFCHAN = BIT(25), + IEEE80211_TX_INTFL_TKIP_MIC_FAILURE = BIT(26), }; #define IEEE80211_TX_CTL_STBC_SHIFT 23 @@ -595,9 +599,10 @@ ieee80211_tx_info_clear_status(struct ieee80211_tx_info *info) * the frame. * @RX_FLAG_FAILED_PLCP_CRC: Set this flag if the PCLP check failed on * the frame. - * @RX_FLAG_TSFT: The timestamp passed in the RX status (@mactime field) - * is valid. This is useful in monitor mode and necessary for beacon frames - * to enable IBSS merging. + * @RX_FLAG_MACTIME_MPDU: The timestamp passed in the RX status (@mactime + * field) is valid and contains the time the first symbol of the MPDU + * was received. This is useful in monitor mode and for proper IBSS + * merging. * @RX_FLAG_SHORTPRE: Short preamble was used for this frame * @RX_FLAG_HT: HT MCS was used and rate_idx is MCS index * @RX_FLAG_40MHZ: HT40 (40 MHz) was used @@ -610,7 +615,7 @@ enum mac80211_rx_flags { RX_FLAG_IV_STRIPPED = 1<<4, RX_FLAG_FAILED_FCS_CRC = 1<<5, RX_FLAG_FAILED_PLCP_CRC = 1<<6, - RX_FLAG_TSFT = 1<<7, + RX_FLAG_MACTIME_MPDU = 1<<7, RX_FLAG_SHORTPRE = 1<<8, RX_FLAG_HT = 1<<9, RX_FLAG_40MHZ = 1<<10, @@ -1069,6 +1074,13 @@ enum ieee80211_tkip_key_type { * to decrypt group addressed frames, then IBSS RSN support is still * possible but software crypto will be used. Advertise the wiphy flag * only in that case. + * + * @IEEE80211_HW_AP_LINK_PS: When operating in AP mode the device + * autonomously manages the PS status of connected stations. When + * this flag is set mac80211 will not trigger PS mode for connected + * stations based on the PM bit of incoming frames. + * Use ieee80211_start_ps()/ieee8021_end_ps() to manually configure + * the PS mode of connected stations. */ enum ieee80211_hw_flags { IEEE80211_HW_HAS_RATE_CONTROL = 1<<0, @@ -1093,6 +1105,7 @@ enum ieee80211_hw_flags { IEEE80211_HW_CONNECTION_MONITOR = 1<<19, IEEE80211_HW_SUPPORTS_CQM_RSSI = 1<<20, IEEE80211_HW_SUPPORTS_PER_STA_GTK = 1<<21, + IEEE80211_HW_AP_LINK_PS = 1<<22, }; /** @@ -1147,6 +1160,17 @@ enum ieee80211_hw_flags { * @napi_weight: weight used for NAPI polling. You must specify an * appropriate value here if a napi_poll operation is provided * by your driver. + * + * @max_rx_aggregation_subframes: maximum buffer size (number of + * sub-frames) to be used for A-MPDU block ack receiver + * aggregation. + * This is only relevant if the device has restrictions on the + * number of subframes, if it relies on mac80211 to do reordering + * it shouldn't be set. + * + * @max_tx_aggregation_subframes: maximum number of subframes in an + * aggregate an HT driver will transmit, used by the peer as a + * hint to size its reorder buffer. */ struct ieee80211_hw { struct ieee80211_conf conf; @@ -1165,6 +1189,8 @@ struct ieee80211_hw { u8 max_rates; u8 max_report_rates; u8 max_rate_tries; + u8 max_rx_aggregation_subframes; + u8 max_tx_aggregation_subframes; }; /** @@ -1688,7 +1714,9 @@ enum ieee80211_ampdu_mlme_action { * station, AP, IBSS/WDS/mesh peer etc. This callback can sleep. * * @sta_notify: Notifies low level driver about power state transition of an - * associated station, AP, IBSS/WDS/mesh peer etc. Must be atomic. + * associated station, AP, IBSS/WDS/mesh peer etc. For a VIF operating + * in AP mode, this callback will not be called when the flag + * %IEEE80211_HW_AP_LINK_PS is set. Must be atomic. * * @conf_tx: Configure TX queue parameters (EDCF (aifs, cw_min, cw_max), * bursting) for a hardware TX queue. @@ -1723,6 +1751,10 @@ enum ieee80211_ampdu_mlme_action { * ieee80211_ampdu_mlme_action. Starting sequence number (@ssn) * is the first frame we expect to perform the action on. Notice * that TX/RX_STOP can pass NULL for this parameter. + * The @buf_size parameter is only valid when the action is set to + * %IEEE80211_AMPDU_TX_OPERATIONAL and indicates the peer's reorder + * buffer size (number of subframes) for this session -- aggregates + * containing more subframes than this may not be transmitted to the peer. * Returns a negative error code on failure. * The callback can sleep. * @@ -1767,9 +1799,18 @@ enum ieee80211_ampdu_mlme_action { * ieee80211_remain_on_channel_expired(). This callback may sleep. * @cancel_remain_on_channel: Requests that an ongoing off-channel period is * aborted before it expires. This callback may sleep. + * @offchannel_tx: Transmit frame on another channel, wait for a response + * and return. Reliable TX status must be reported for the frame. If the + * return value is 1, then the @remain_on_channel will be used with a + * regular transmission (if supported.) + * @offchannel_tx_cancel_wait: cancel wait associated with offchannel TX + * + * @set_ringparam: Set tx and rx ring sizes. + * + * @get_ringparam: Get tx and rx ring current and maximum sizes. */ struct ieee80211_ops { - int (*tx)(struct ieee80211_hw *hw, struct sk_buff *skb); + void (*tx)(struct ieee80211_hw *hw, struct sk_buff *skb); int (*start)(struct ieee80211_hw *hw); void (*stop)(struct ieee80211_hw *hw); int (*add_interface)(struct ieee80211_hw *hw, @@ -1825,7 +1866,8 @@ struct ieee80211_ops { int (*ampdu_action)(struct ieee80211_hw *hw, struct ieee80211_vif *vif, enum ieee80211_ampdu_mlme_action action, - struct ieee80211_sta *sta, u16 tid, u16 *ssn); + struct ieee80211_sta *sta, u16 tid, u16 *ssn, + u8 buf_size); int (*get_survey)(struct ieee80211_hw *hw, int idx, struct survey_info *survey); void (*rfkill_poll)(struct ieee80211_hw *hw); @@ -1845,6 +1887,14 @@ struct ieee80211_ops { enum nl80211_channel_type channel_type, int duration); int (*cancel_remain_on_channel)(struct ieee80211_hw *hw); + int (*offchannel_tx)(struct ieee80211_hw *hw, struct sk_buff *skb, + struct ieee80211_channel *chan, + enum nl80211_channel_type channel_type, + unsigned int wait); + int (*offchannel_tx_cancel_wait)(struct ieee80211_hw *hw); + int (*set_ringparam)(struct ieee80211_hw *hw, u32 tx, u32 rx); + void (*get_ringparam)(struct ieee80211_hw *hw, + u32 *tx, u32 *tx_max, u32 *rx, u32 *rx_max); }; /** @@ -2113,6 +2163,48 @@ static inline void ieee80211_rx_ni(struct ieee80211_hw *hw, local_bh_enable(); } +/** + * ieee80211_sta_ps_transition - PS transition for connected sta + * + * When operating in AP mode with the %IEEE80211_HW_AP_LINK_PS + * flag set, use this function to inform mac80211 about a connected station + * entering/leaving PS mode. + * + * This function may not be called in IRQ context or with softirqs enabled. + * + * Calls to this function for a single hardware must be synchronized against + * each other. + * + * The function returns -EINVAL when the requested PS mode is already set. + * + * @sta: currently connected sta + * @start: start or stop PS + */ +int ieee80211_sta_ps_transition(struct ieee80211_sta *sta, bool start); + +/** + * ieee80211_sta_ps_transition_ni - PS transition for connected sta + * (in process context) + * + * Like ieee80211_sta_ps_transition() but can be called in process context + * (internally disables bottom halves). Concurrent call restriction still + * applies. + * + * @sta: currently connected sta + * @start: start or stop PS + */ +static inline int ieee80211_sta_ps_transition_ni(struct ieee80211_sta *sta, + bool start) +{ + int ret; + + local_bh_disable(); + ret = ieee80211_sta_ps_transition(sta, start); + local_bh_enable(); + + return ret; +} + /* * The TX headroom reserved by mac80211 for its own tx_status functions. * This is enough for the radiotap header. |