diff options
Diffstat (limited to 'drivers/spi/Kconfig')
| -rw-r--r-- | drivers/spi/Kconfig | 34 |
1 files changed, 34 insertions, 0 deletions
diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig index 7a75faeb052..23334c8bc4c 100644 --- a/drivers/spi/Kconfig +++ b/drivers/spi/Kconfig @@ -75,11 +75,45 @@ config SPI_BUTTERFLY inexpensive battery powered microcontroller evaluation board. This same cable can be used to flash new firmware. +config SPI_MPC83xx + tristate "Freescale MPC83xx SPI controller" + depends on SPI_MASTER && PPC_83xx && EXPERIMENTAL + select SPI_BITBANG + help + This enables using the Freescale MPC83xx SPI controller in master + mode. + + Note, this driver uniquely supports the SPI controller on the MPC83xx + family of PowerPC processors. The MPC83xx uses a simple set of shift + registers for data (opposed to the CPM based descriptor model). + +config SPI_PXA2XX + tristate "PXA2xx SSP SPI master" + depends on SPI_MASTER && ARCH_PXA && EXPERIMENTAL + help + This enables using a PXA2xx SSP port as a SPI master controller. + The driver can be configured to use any SSP port and additional + documentation can be found a Documentation/spi/pxa2xx. + +config SPI_S3C24XX_GPIO + tristate "Samsung S3C24XX series SPI by GPIO" + depends on SPI_MASTER && ARCH_S3C2410 && SPI_BITBANG && EXPERIMENTAL + help + SPI driver for Samsung S3C24XX series ARM SoCs using + GPIO lines to provide the SPI bus. This can be used where + the inbuilt hardware cannot provide the transfer mode, or + where the board is using non hardware connected pins. # # Add new SPI master controllers in alphabetical order above this line # +config SPI_S3C24XX + tristate "Samsung S3C24XX series SPI" + depends on SPI_MASTER && ARCH_S3C2410 && EXPERIMENTAL + help + SPI driver for Samsung S3C24XX series ARM SoCs + # # There are lots of SPI device types, with sensors and memory # being probably the most widely used ones. |