1 files changed, 276 insertions, 0 deletions
diff --git a/drivers/net/wireless/orinoco_tmd.c b/drivers/net/wireless/orinoco_tmd.c
new file mode 100644
index 00000000000..85893f42445
--- /dev/null
+++ b/drivers/net/wireless/orinoco_tmd.c
@@ -0,0 +1,276 @@
+/* orinoco_tmd.c
+ * 
+ * Driver for Prism II devices which would usually be driven by orinoco_cs,
+ * but are connected to the PCI bus by a TMD7160. 
+ *
+ * Copyright (C) 2003 Joerg Dorchain <joerg AT dorchain.net>
+ * based heavily upon orinoco_plx.c Copyright (C) 2001 Daniel Barlow
+ *
+ * The contents of this file are subject to the Mozilla Public License
+ * Version 1.1 (the "License"); you may not use this file except in
+ * compliance with the License. You may obtain a copy of the License
+ * at http://www.mozilla.org/MPL/
+ *
+ * Software distributed under the License is distributed on an "AS IS"
+ * basis, WITHOUT WARRANTY OF ANY KIND, either express or implied. See
+ * the License for the specific language governing rights and
+ * limitations under the License.
+ *
+ * Alternatively, the contents of this file may be used under the
+ * terms of the GNU General Public License version 2 (the "GPL"), in
+ * which case the provisions of the GPL are applicable instead of the
+ * above.  If you wish to allow the use of your version of this file
+ * only under the terms of the GPL and not to allow others to use your
+ * version of this file under the MPL, indicate your decision by
+ * deleting the provisions above and replace them with the notice and
+ * other provisions required by the GPL.  If you do not delete the
+ * provisions above, a recipient may use your version of this file
+ * under either the MPL or the GPL.
+
+ * Caution: this is experimental and probably buggy.  For success and
+ * failure reports for different cards and adaptors, see
+ * orinoco_tmd_pci_id_table near the end of the file.  If you have a
+ * card we don't have the PCI id for, and looks like it should work,
+ * drop me mail with the id and "it works"/"it doesn't work".
+ *
+ * Note: if everything gets detected fine but it doesn't actually send
+ * or receive packets, your first port of call should probably be to   
+ * try newer firmware in the card.  Especially if you're doing Ad-Hoc
+ * modes
+ *
+ * The actual driving is done by orinoco.c, this is just resource
+ * allocation stuff.
+ *
+ * This driver is modeled after the orinoco_plx driver. The main
+ * difference is that the TMD chip has only IO port ranges and no
+ * memory space, i.e.  no access to the CIS. Compared to the PLX chip,
+ * the io range functionalities are exchanged.
+ *
+ * Pheecom sells cards with the TMD chip as "ASIC version"
+ */
+
+#define DRIVER_NAME "orinoco_tmd"
+#define PFX DRIVER_NAME ": "
+
+#include <linux/config.h>
+
+#include <linux/module.h>
+#include <linux/kernel.h>
+#include <linux/init.h>
+#include <linux/sched.h>
+#include <linux/ptrace.h>
+#include <linux/slab.h>
+#include <linux/string.h>
+#include <linux/timer.h>
+#include <linux/ioport.h>
+#include <asm/uaccess.h>
+#include <asm/io.h>
+#include <asm/system.h>
+#include <linux/netdevice.h>
+#include <linux/if_arp.h>
+#include <linux/etherdevice.h>
+#include <linux/list.h>
+#include <linux/pci.h>
+#include <linux/fcntl.h>
+
+#include <pcmcia/cisreg.h>
+
+#include "hermes.h"
+#include "orinoco.h"
+
+#define COR_VALUE	(COR_LEVEL_REQ | COR_FUNC_ENA) /* Enable PC card with interrupt in level trigger */
+#define COR_RESET     (0x80)	/* reset bit in the COR register */
+#define TMD_RESET_TIME	(500)	/* milliseconds */
+
+/* Orinoco TMD specific data */
+struct orinoco_tmd_card {
+	u32 tmd_io;
+};
+
+
+/*
+ * Do a soft reset of the card using the Configuration Option Register
+ */
+static int orinoco_tmd_cor_reset(struct orinoco_private *priv)
+{
+	hermes_t *hw = &priv->hw;
+	struct orinoco_tmd_card *card = priv->card;
+	u32 addr = card->tmd_io;
+	unsigned long timeout;
+	u16 reg;
+
+	outb(COR_VALUE | COR_RESET, addr);
+	mdelay(1);
+
+	outb(COR_VALUE, addr);
+	mdelay(1);
+
+	/* Just in case, wait more until the card is no longer busy */
+	timeout = jiffies + (TMD_RESET_TIME * HZ / 1000);
+	reg = hermes_read_regn(hw, CMD);
+	while (time_before(jiffies, timeout) && (reg & HERMES_CMD_BUSY)) {
+		mdelay(1);
+		reg = hermes_read_regn(hw, CMD);
+	}
+
+	/* Did we timeout ? */
+	if (reg & HERMES_CMD_BUSY) {
+		printk(KERN_ERR PFX "Busy timeout\n");
+		return -ETIMEDOUT;
+	}
+
+	return 0;
+}
+
+
+static int orinoco_tmd_init_one(struct pci_dev *pdev,
+				const struct pci_device_id *ent)
+{
+	int err = 0;
+	struct orinoco_private *priv = NULL;
+	struct orinoco_tmd_card *card;
+	struct net_device *dev = NULL;
+	void __iomem *mem;
+
+	err = pci_enable_device(pdev);
+	if (err) {
+		printk(KERN_ERR PFX "Cannot enable PCI device\n");
+		return err;
+	}
+
+	err = pci_request_regions(pdev, DRIVER_NAME);
+	if (err != 0) {
+		printk(KERN_ERR PFX "Cannot obtain PCI resources\n");
+		goto fail_resources;
+	}
+
+	mem = pci_iomap(pdev, 2, 0);
+	if (! mem) {
+		err = -ENOMEM;
+		goto fail_iomap;
+	}
+
+	/* Allocate network device */
+	dev = alloc_orinocodev(sizeof(*card), orinoco_tmd_cor_reset);
+	if (! dev) {
+		printk(KERN_ERR PFX "Cannot allocate network device\n");
+		err = -ENOMEM;
+		goto fail_alloc;
+	}
+
+	priv = netdev_priv(dev);
+	card = priv->card;
+	card->tmd_io = pci_resource_start(pdev, 1);
+	dev->base_addr = pci_resource_start(pdev, 2);
+	SET_MODULE_OWNER(dev);
+	SET_NETDEV_DEV(dev, &pdev->dev);
+
+	hermes_struct_init(&priv->hw, mem, HERMES_16BIT_REGSPACING);
+
+	printk(KERN_DEBUG PFX "Detected Orinoco/Prism2 TMD device "
+	       "at %s irq:%d, io addr:0x%lx\n", pci_name(pdev), pdev->irq,
+	       dev->base_addr);
+
+	err = request_irq(pdev->irq, orinoco_interrupt, SA_SHIRQ,
+			  dev->name, dev);
+	if (err) {
+		printk(KERN_ERR PFX "Cannot allocate IRQ %d\n", pdev->irq);
+		err = -EBUSY;
+		goto fail_irq;
+	}
+	dev->irq = pdev->irq;
+
+	err = orinoco_tmd_cor_reset(priv);
+	if (err) {
+		printk(KERN_ERR PFX "Initial reset failed\n");
+		goto fail;
+	}
+
+	err = register_netdev(dev);
+	if (err) {
+		printk(KERN_ERR PFX "Cannot register network device\n");
+		goto fail;
+	}
+
+	pci_set_drvdata(pdev, dev);
+
+	return 0;
+
+ fail:
+	free_irq(pdev->irq, dev);
+
+ fail_irq:
+	pci_set_drvdata(pdev, NULL);
+	free_orinocodev(dev);
+
+ fail_alloc:
+	pci_iounmap(pdev, mem);
+
+ fail_iomap:
+	pci_release_regions(pdev);
+
+ fail_resources:
+	pci_disable_device(pdev);
+
+	return err;
+}
+
+static void __devexit orinoco_tmd_remove_one(struct pci_dev *pdev)
+{
+	struct net_device *dev = pci_get_drvdata(pdev);
+	struct orinoco_private *priv = dev->priv;
+
+	BUG_ON(! dev);
+
+	unregister_netdev(dev);
+	free_irq(dev->irq, dev);
+	pci_set_drvdata(pdev, NULL);
+	free_orinocodev(dev);
+	pci_iounmap(pdev, priv->hw.iobase);
+	pci_release_regions(pdev);
+	pci_disable_device(pdev);
+}
+
+
+static struct pci_device_id orinoco_tmd_pci_id_table[] = {
+	{0x15e8, 0x0131, PCI_ANY_ID, PCI_ANY_ID,},      /* NDC and OEMs, e.g. pheecom */
+	{0,},
+};
+
+MODULE_DEVICE_TABLE(pci, orinoco_tmd_pci_id_table);
+
+static struct pci_driver orinoco_tmd_driver = {
+	.name		= DRIVER_NAME,
+	.id_table	= orinoco_tmd_pci_id_table,
+	.probe		= orinoco_tmd_init_one,
+	.remove		= __devexit_p(orinoco_tmd_remove_one),
+};
+
+static char version[] __initdata = DRIVER_NAME " " DRIVER_VERSION
+	" (Joerg Dorchain <joerg@dorchain.net>)";
+MODULE_AUTHOR("Joerg Dorchain <joerg@dorchain.net>");
+MODULE_DESCRIPTION("Driver for wireless LAN cards using the TMD7160 PCI bridge");
+MODULE_LICENSE("Dual MPL/GPL");
+
+static int __init orinoco_tmd_init(void)
+{
+	printk(KERN_DEBUG "%s\n", version);
+	return pci_module_init(&orinoco_tmd_driver);
+}
+
+static void __exit orinoco_tmd_exit(void)
+{
+	pci_unregister_driver(&orinoco_tmd_driver);
+	ssleep(1);
+}
+
+module_init(orinoco_tmd_init);
+module_exit(orinoco_tmd_exit);
+
+/*
+ * Local variables:
+ *  c-indent-level: 8
+ *  c-basic-offset: 8
+ *  tab-width: 8
+ * End:
+ */