diff options
Diffstat (limited to 'drivers/net/wireless/iwlwifi/iwl-eeprom.h')
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-eeprom.h | 195 |
1 files changed, 3 insertions, 192 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-eeprom.h b/drivers/net/wireless/iwlwifi/iwl-eeprom.h index 20b66469d68..c960c6fa009 100644 --- a/drivers/net/wireless/iwlwifi/iwl-eeprom.h +++ b/drivers/net/wireless/iwlwifi/iwl-eeprom.h @@ -5,7 +5,7 @@ * * GPL LICENSE SUMMARY * - * Copyright(c) 2008 - 2010 Intel Corporation. All rights reserved. + * Copyright(c) 2008 - 2011 Intel Corporation. All rights reserved. * * This program is free software; you can redistribute it and/or modify * it under the terms of version 2 of the GNU General Public License as @@ -30,7 +30,7 @@ * * BSD LICENSE * - * Copyright(c) 2005 - 2010 Intel Corporation. All rights reserved. + * Copyright(c) 2005 - 2011 Intel Corporation. All rights reserved. * All rights reserved. * * Redistribution and use in source and binary forms, with or without @@ -110,10 +110,6 @@ enum { }; /* SKU Capabilities */ -/* 3945 only */ -#define EEPROM_SKU_CAP_SW_RF_KILL_ENABLE (1 << 0) -#define EEPROM_SKU_CAP_HW_RF_KILL_ENABLE (1 << 1) - /* 5000 and up */ #define EEPROM_SKU_CAP_BAND_POS (4) #define EEPROM_SKU_CAP_BAND_SELECTION \ @@ -168,28 +164,6 @@ struct iwl_eeprom_enhanced_txpwr { s8 mimo3_max; } __packed; -/* 3945 Specific */ -#define EEPROM_3945_EEPROM_VERSION (0x2f) - -/* 4965 has two radio transmitters (and 3 radio receivers) */ -#define EEPROM_TX_POWER_TX_CHAINS (2) - -/* 4965 has room for up to 8 sets of txpower calibration data */ -#define EEPROM_TX_POWER_BANDS (8) - -/* 4965 factory calibration measures txpower gain settings for - * each of 3 target output levels */ -#define EEPROM_TX_POWER_MEASUREMENTS (3) - -/* 4965 Specific */ -/* 4965 driver does not work with txpower calibration version < 5 */ -#define EEPROM_4965_TX_POWER_VERSION (5) -#define EEPROM_4965_EEPROM_VERSION (0x2f) -#define EEPROM_4965_CALIB_VERSION_OFFSET (2*0xB6) /* 2 bytes */ -#define EEPROM_4965_CALIB_TXPOWER_OFFSET (2*0xE8) /* 48 bytes */ -#define EEPROM_4965_BOARD_REVISION (2*0x4F) /* 2 bytes */ -#define EEPROM_4965_BOARD_PBA (2*0x56+1) /* 9 bytes */ - /* 5000 Specific */ #define EEPROM_5000_TX_POWER_VERSION (4) #define EEPROM_5000_EEPROM_VERSION (0x11A) @@ -282,90 +256,6 @@ struct iwl_eeprom_enhanced_txpwr { /* 2.4 GHz */ extern const u8 iwl_eeprom_band_1[14]; -/* - * factory calibration data for one txpower level, on one channel, - * measured on one of the 2 tx chains (radio transmitter and associated - * antenna). EEPROM contains: - * - * 1) Temperature (degrees Celsius) of device when measurement was made. - * - * 2) Gain table index used to achieve the target measurement power. - * This refers to the "well-known" gain tables (see iwl-4965-hw.h). - * - * 3) Actual measured output power, in half-dBm ("34" = 17 dBm). - * - * 4) RF power amplifier detector level measurement (not used). - */ -struct iwl_eeprom_calib_measure { - u8 temperature; /* Device temperature (Celsius) */ - u8 gain_idx; /* Index into gain table */ - u8 actual_pow; /* Measured RF output power, half-dBm */ - s8 pa_det; /* Power amp detector level (not used) */ -} __packed; - - -/* - * measurement set for one channel. EEPROM contains: - * - * 1) Channel number measured - * - * 2) Measurements for each of 3 power levels for each of 2 radio transmitters - * (a.k.a. "tx chains") (6 measurements altogether) - */ -struct iwl_eeprom_calib_ch_info { - u8 ch_num; - struct iwl_eeprom_calib_measure - measurements[EEPROM_TX_POWER_TX_CHAINS] - [EEPROM_TX_POWER_MEASUREMENTS]; -} __packed; - -/* - * txpower subband info. - * - * For each frequency subband, EEPROM contains the following: - * - * 1) First and last channels within range of the subband. "0" values - * indicate that this sample set is not being used. - * - * 2) Sample measurement sets for 2 channels close to the range endpoints. - */ -struct iwl_eeprom_calib_subband_info { - u8 ch_from; /* channel number of lowest channel in subband */ - u8 ch_to; /* channel number of highest channel in subband */ - struct iwl_eeprom_calib_ch_info ch1; - struct iwl_eeprom_calib_ch_info ch2; -} __packed; - - -/* - * txpower calibration info. EEPROM contains: - * - * 1) Factory-measured saturation power levels (maximum levels at which - * tx power amplifier can output a signal without too much distortion). - * There is one level for 2.4 GHz band and one for 5 GHz band. These - * values apply to all channels within each of the bands. - * - * 2) Factory-measured power supply voltage level. This is assumed to be - * constant (i.e. same value applies to all channels/bands) while the - * factory measurements are being made. - * - * 3) Up to 8 sets of factory-measured txpower calibration values. - * These are for different frequency ranges, since txpower gain - * characteristics of the analog radio circuitry vary with frequency. - * - * Not all sets need to be filled with data; - * struct iwl_eeprom_calib_subband_info contains range of channels - * (0 if unused) for each set of data. - */ -struct iwl_eeprom_calib_info { - u8 saturation_power24; /* half-dBm (e.g. "34" = 17 dBm) */ - u8 saturation_power52; /* half-dBm */ - __le16 voltage; /* signed */ - struct iwl_eeprom_calib_subband_info - band_info[EEPROM_TX_POWER_BANDS]; -} __packed; - - #define ADDRESS_MSK 0x0000FFFF #define INDIRECT_TYPE_MSK 0x000F0000 #define INDIRECT_HOST 0x00010000 @@ -398,103 +288,24 @@ struct iwl_eeprom_calib_info { #define EEPROM_RF_CFG_TX_ANT_MSK(x) ((x >> 8) & 0xF) /* bits 8-11 */ #define EEPROM_RF_CFG_RX_ANT_MSK(x) ((x >> 12) & 0xF) /* bits 12-15 */ -#define EEPROM_3945_RF_CFG_TYPE_MAX 0x0 -#define EEPROM_4965_RF_CFG_TYPE_MAX 0x1 - -/* Radio Config for 5000 and up */ -#define EEPROM_RF_CONFIG_TYPE_R3x3 0x0 -#define EEPROM_RF_CONFIG_TYPE_R2x2 0x1 -#define EEPROM_RF_CONFIG_TYPE_R1x2 0x2 #define EEPROM_RF_CONFIG_TYPE_MAX 0x3 -/* - * Per-channel regulatory data. - * - * Each channel that *might* be supported by iwl has a fixed location - * in EEPROM containing EEPROM_CHANNEL_* usage flags (LSB) and max regulatory - * txpower (MSB). - * - * Entries immediately below are for 20 MHz channel width. HT40 (40 MHz) - * channels (only for 4965, not supported by 3945) appear later in the EEPROM. - * - * 2.4 GHz channels 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14 - */ -#define EEPROM_REGULATORY_SKU_ID (2*0x60) /* 4 bytes */ -#define EEPROM_REGULATORY_BAND_1 (2*0x62) /* 2 bytes */ -#define EEPROM_REGULATORY_BAND_1_CHANNELS (2*0x63) /* 28 bytes */ - -/* - * 4.9 GHz channels 183, 184, 185, 187, 188, 189, 192, 196, - * 5.0 GHz channels 7, 8, 11, 12, 16 - * (4915-5080MHz) (none of these is ever supported) - */ -#define EEPROM_REGULATORY_BAND_2 (2*0x71) /* 2 bytes */ -#define EEPROM_REGULATORY_BAND_2_CHANNELS (2*0x72) /* 26 bytes */ - -/* - * 5.2 GHz channels 34, 36, 38, 40, 42, 44, 46, 48, 52, 56, 60, 64 - * (5170-5320MHz) - */ -#define EEPROM_REGULATORY_BAND_3 (2*0x7F) /* 2 bytes */ -#define EEPROM_REGULATORY_BAND_3_CHANNELS (2*0x80) /* 24 bytes */ - -/* - * 5.5 GHz channels 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140 - * (5500-5700MHz) - */ -#define EEPROM_REGULATORY_BAND_4 (2*0x8C) /* 2 bytes */ -#define EEPROM_REGULATORY_BAND_4_CHANNELS (2*0x8D) /* 22 bytes */ - -/* - * 5.7 GHz channels 145, 149, 153, 157, 161, 165 - * (5725-5825MHz) - */ -#define EEPROM_REGULATORY_BAND_5 (2*0x98) /* 2 bytes */ -#define EEPROM_REGULATORY_BAND_5_CHANNELS (2*0x99) /* 12 bytes */ - -/* - * 2.4 GHz HT40 channels 1 (5), 2 (6), 3 (7), 4 (8), 5 (9), 6 (10), 7 (11) - * - * The channel listed is the center of the lower 20 MHz half of the channel. - * The overall center frequency is actually 2 channels (10 MHz) above that, - * and the upper half of each HT40 channel is centered 4 channels (20 MHz) away - * from the lower half; e.g. the upper half of HT40 channel 1 is channel 5, - * and the overall HT40 channel width centers on channel 3. - * - * NOTE: The RXON command uses 20 MHz channel numbers to specify the - * control channel to which to tune. RXON also specifies whether the - * control channel is the upper or lower half of a HT40 channel. - * - * NOTE: 4965 does not support HT40 channels on 2.4 GHz. - */ -#define EEPROM_4965_REGULATORY_BAND_24_HT40_CHANNELS (2*0xA0) /* 14 bytes */ - -/* - * 5.2 GHz HT40 channels 36 (40), 44 (48), 52 (56), 60 (64), - * 100 (104), 108 (112), 116 (120), 124 (128), 132 (136), 149 (153), 157 (161) - */ -#define EEPROM_4965_REGULATORY_BAND_52_HT40_CHANNELS (2*0xA8) /* 22 bytes */ - #define EEPROM_REGULATORY_BAND_NO_HT40 (0) struct iwl_eeprom_ops { const u32 regulatory_bands[7]; - int (*acquire_semaphore) (struct iwl_priv *priv); - void (*release_semaphore) (struct iwl_priv *priv); - u16 (*calib_version) (struct iwl_priv *priv); const u8* (*query_addr) (const struct iwl_priv *priv, size_t offset); void (*update_enhanced_txpower) (struct iwl_priv *priv); }; -int iwl_eeprom_init(struct iwl_priv *priv); +int iwl_eeprom_init(struct iwl_priv *priv, u32 hw_rev); void iwl_eeprom_free(struct iwl_priv *priv); int iwl_eeprom_check_version(struct iwl_priv *priv); int iwl_eeprom_check_sku(struct iwl_priv *priv); const u8 *iwl_eeprom_query_addr(const struct iwl_priv *priv, size_t offset); int iwlcore_eeprom_verify_signature(struct iwl_priv *priv); u16 iwl_eeprom_query16(const struct iwl_priv *priv, size_t offset); -const u8 *iwlcore_eeprom_query_addr(const struct iwl_priv *priv, size_t offset); int iwl_init_channel_map(struct iwl_priv *priv); void iwl_free_channel_map(struct iwl_priv *priv); const struct iwl_channel_info *iwl_get_channel_info( |