diff options
Diffstat (limited to 'drivers/net/wireless/b43/main.c')
-rw-r--r-- | drivers/net/wireless/b43/main.c | 111 |
1 files changed, 57 insertions, 54 deletions
diff --git a/drivers/net/wireless/b43/main.c b/drivers/net/wireless/b43/main.c index 4c41cfe44f2..1521b1e78d2 100644 --- a/drivers/net/wireless/b43/main.c +++ b/drivers/net/wireless/b43/main.c @@ -67,7 +67,12 @@ MODULE_AUTHOR("Gábor Stefanik"); MODULE_LICENSE("GPL"); MODULE_FIRMWARE(B43_SUPPORTED_FIRMWARE_ID); - +MODULE_FIRMWARE("b43/ucode11.fw"); +MODULE_FIRMWARE("b43/ucode13.fw"); +MODULE_FIRMWARE("b43/ucode14.fw"); +MODULE_FIRMWARE("b43/ucode15.fw"); +MODULE_FIRMWARE("b43/ucode5.fw"); +MODULE_FIRMWARE("b43/ucode9.fw"); static int modparam_bad_frames_preempt; module_param_named(bad_frames_preempt, modparam_bad_frames_preempt, int, 0444); @@ -102,6 +107,9 @@ int b43_modparam_verbose = B43_VERBOSITY_DEFAULT; module_param_named(verbose, b43_modparam_verbose, int, 0644); MODULE_PARM_DESC(verbose, "Log message verbosity: 0=error, 1=warn, 2=info(default), 3=debug"); +int b43_modparam_pio = B43_PIO_DEFAULT; +module_param_named(pio, b43_modparam_pio, int, 0644); +MODULE_PARM_DESC(pio, "Use PIO accesses by default: 0=DMA, 1=PIO"); static const struct ssb_device_id b43_ssb_tbl[] = { SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 5), @@ -110,6 +118,7 @@ static const struct ssb_device_id b43_ssb_tbl[] = { SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 9), SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 10), SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 11), + SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 12), SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 13), SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 15), SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 16), @@ -628,10 +637,17 @@ static void b43_upload_card_macaddress(struct b43_wldev *dev) static void b43_set_slot_time(struct b43_wldev *dev, u16 slot_time) { /* slot_time is in usec. */ - if (dev->phy.type != B43_PHYTYPE_G) + /* This test used to exit for all but a G PHY. */ + if (b43_current_band(dev->wl) == IEEE80211_BAND_5GHZ) return; - b43_write16(dev, 0x684, 510 + slot_time); - b43_shm_write16(dev, B43_SHM_SHARED, 0x0010, slot_time); + b43_write16(dev, B43_MMIO_IFSSLOT, 510 + slot_time); + /* Shared memory location 0x0010 is the slot time and should be + * set to slot_time; however, this register is initially 0 and changing + * the value adversely affects the transmit rate for BCM4311 + * devices. Until this behavior is unterstood, delete this step + * + * b43_shm_write16(dev, B43_SHM_SHARED, 0x0010, slot_time); + */ } static void b43_short_slot_timing_enable(struct b43_wldev *dev) @@ -835,8 +851,10 @@ static void rx_tkip_phase1_write(struct b43_wldev *dev, u8 index, u32 iv32, } static void b43_op_update_tkip_key(struct ieee80211_hw *hw, - struct ieee80211_key_conf *keyconf, const u8 *addr, - u32 iv32, u16 *phase1key) + struct ieee80211_vif *vif, + struct ieee80211_key_conf *keyconf, + struct ieee80211_sta *sta, + u32 iv32, u16 *phase1key) { struct b43_wl *wl = hw_to_b43_wl(hw); struct b43_wldev *dev; @@ -845,19 +863,19 @@ static void b43_op_update_tkip_key(struct ieee80211_hw *hw, if (B43_WARN_ON(!modparam_hwtkip)) return; - mutex_lock(&wl->mutex); - + /* This is only called from the RX path through mac80211, where + * our mutex is already locked. */ + B43_WARN_ON(!mutex_is_locked(&wl->mutex)); dev = wl->current_dev; - if (!dev || b43_status(dev) < B43_STAT_INITIALIZED) - goto out_unlock; + B43_WARN_ON(!dev || b43_status(dev) < B43_STAT_INITIALIZED); keymac_write(dev, index, NULL); /* First zero out mac to avoid race */ rx_tkip_phase1_write(dev, index, iv32, phase1key); - keymac_write(dev, index, addr); - -out_unlock: - mutex_unlock(&wl->mutex); + /* only pairwise TKIP keys are supported right now */ + if (WARN_ON(!sta)) + return; + keymac_write(dev, index, sta->addr); } static void do_key_write(struct b43_wldev *dev, @@ -1786,8 +1804,9 @@ static void b43_do_interrupt_thread(struct b43_wldev *dev) dma_reason[4], dma_reason[5]); b43err(dev->wl, "This device does not support DMA " "on your system. Please use PIO instead.\n"); - b43err(dev->wl, "CONFIG_B43_FORCE_PIO must be set in " - "your kernel configuration.\n"); + /* Fall back to PIO transfers if we get fatal DMA errors! */ + dev->use_pio = 1; + b43_controller_restart(dev, "DMA error"); return; } if (merged_dma_reason & B43_DMAIRQ_NONFATALMASK) { @@ -3338,27 +3357,6 @@ out_unlock: return err; } -static int b43_op_get_tx_stats(struct ieee80211_hw *hw, - struct ieee80211_tx_queue_stats *stats) -{ - struct b43_wl *wl = hw_to_b43_wl(hw); - struct b43_wldev *dev; - int err = -ENODEV; - - mutex_lock(&wl->mutex); - dev = wl->current_dev; - if (dev && b43_status(dev) >= B43_STAT_STARTED) { - if (b43_using_pio_transfers(dev)) - b43_pio_get_tx_stats(dev, stats); - else - b43_dma_get_tx_stats(dev, stats); - err = 0; - } - mutex_unlock(&wl->mutex); - - return err; -} - static int b43_op_get_stats(struct ieee80211_hw *hw, struct ieee80211_low_level_stats *stats) { @@ -3562,6 +3560,12 @@ static int b43_op_config(struct ieee80211_hw *hw, u32 changed) dev = wl->current_dev; phy = &dev->phy; + if (conf_is_ht(conf)) + phy->is_40mhz = + (conf_is_ht40_minus(conf) || conf_is_ht40_plus(conf)); + else + phy->is_40mhz = false; + b43_mac_suspend(dev); if (changed & IEEE80211_CONF_CHANGE_RETRY_LIMITS) @@ -3963,6 +3967,7 @@ static int b43_wireless_core_start(struct b43_wldev *dev) } /* We are ready to run. */ + ieee80211_wake_queues(dev->wl->hw); b43_set_status(dev, B43_STAT_STARTED); /* Start data flow (TX/RX). */ @@ -4353,7 +4358,7 @@ static int b43_wireless_core_init(struct b43_wldev *dev) if ((dev->dev->bus->bustype == SSB_BUSTYPE_PCMCIA) || (dev->dev->bus->bustype == SSB_BUSTYPE_SDIO) || - B43_FORCE_PIO) { + dev->use_pio) { dev->__using_pio_transfers = 1; err = b43_pio_init(dev); } else { @@ -4372,8 +4377,6 @@ static int b43_wireless_core_init(struct b43_wldev *dev) ieee80211_wake_queues(dev->wl->hw); - ieee80211_wake_queues(dev->wl->hw); - b43_set_status(dev, B43_STAT_INITIALIZED); out: @@ -4388,7 +4391,7 @@ err_busdown: } static int b43_op_add_interface(struct ieee80211_hw *hw, - struct ieee80211_if_init_conf *conf) + struct ieee80211_vif *vif) { struct b43_wl *wl = hw_to_b43_wl(hw); struct b43_wldev *dev; @@ -4396,24 +4399,24 @@ static int b43_op_add_interface(struct ieee80211_hw *hw, /* TODO: allow WDS/AP devices to coexist */ - if (conf->type != NL80211_IFTYPE_AP && - conf->type != NL80211_IFTYPE_MESH_POINT && - conf->type != NL80211_IFTYPE_STATION && - conf->type != NL80211_IFTYPE_WDS && - conf->type != NL80211_IFTYPE_ADHOC) + if (vif->type != NL80211_IFTYPE_AP && + vif->type != NL80211_IFTYPE_MESH_POINT && + vif->type != NL80211_IFTYPE_STATION && + vif->type != NL80211_IFTYPE_WDS && + vif->type != NL80211_IFTYPE_ADHOC) return -EOPNOTSUPP; mutex_lock(&wl->mutex); if (wl->operating) goto out_mutex_unlock; - b43dbg(wl, "Adding Interface type %d\n", conf->type); + b43dbg(wl, "Adding Interface type %d\n", vif->type); dev = wl->current_dev; wl->operating = 1; - wl->vif = conf->vif; - wl->if_type = conf->type; - memcpy(wl->mac_addr, conf->mac_addr, ETH_ALEN); + wl->vif = vif; + wl->if_type = vif->type; + memcpy(wl->mac_addr, vif->addr, ETH_ALEN); b43_adjust_opmode(dev); b43_set_pretbtt(dev); @@ -4428,17 +4431,17 @@ static int b43_op_add_interface(struct ieee80211_hw *hw, } static void b43_op_remove_interface(struct ieee80211_hw *hw, - struct ieee80211_if_init_conf *conf) + struct ieee80211_vif *vif) { struct b43_wl *wl = hw_to_b43_wl(hw); struct b43_wldev *dev = wl->current_dev; - b43dbg(wl, "Removing Interface type %d\n", conf->type); + b43dbg(wl, "Removing Interface type %d\n", vif->type); mutex_lock(&wl->mutex); B43_WARN_ON(!wl->operating); - B43_WARN_ON(wl->vif != conf->vif); + B43_WARN_ON(wl->vif != vif); wl->vif = NULL; wl->operating = 0; @@ -4579,7 +4582,6 @@ static const struct ieee80211_ops b43_hw_ops = { .set_key = b43_op_set_key, .update_tkip_key = b43_op_update_tkip_key, .get_stats = b43_op_get_stats, - .get_tx_stats = b43_op_get_tx_stats, .get_tsf = b43_op_get_tsf, .set_tsf = b43_op_set_tsf, .start = b43_op_start, @@ -4823,6 +4825,7 @@ static int b43_one_core_attach(struct ssb_device *dev, struct b43_wl *wl) if (!wldev) goto out; + wldev->use_pio = b43_modparam_pio; wldev->dev = dev; wldev->wl = wl; b43_set_status(wldev, B43_STAT_UNINIT); |