diff options
Diffstat (limited to 'drivers/net/wireless/ath/ath5k/ani.c')
| -rw-r--r-- | drivers/net/wireless/ath/ath5k/ani.c | 91 |
1 files changed, 58 insertions, 33 deletions
diff --git a/drivers/net/wireless/ath/ath5k/ani.c b/drivers/net/wireless/ath/ath5k/ani.c index bea90e6be70..bf674161a21 100644 --- a/drivers/net/wireless/ath/ath5k/ani.c +++ b/drivers/net/wireless/ath/ath5k/ani.c @@ -27,15 +27,21 @@ * or reducing sensitivity as necessary. * * The parameters are: + * * - "noise immunity" + * * - "spur immunity" + * * - "firstep level" + * * - "OFDM weak signal detection" + * * - "CCK weak signal detection" * * Basically we look at the amount of ODFM and CCK timing errors we get and then * raise or lower immunity accordingly by setting one or more of these * parameters. + * * Newer chipsets have PHY error counters in hardware which will generate a MIB * interrupt when they overflow. Older hardware has too enable PHY error frames * by setting a RX flag and then count every single PHY error. When a specified @@ -45,11 +51,13 @@ */ -/*** ANI parameter control ***/ +/***********************\ +* ANI parameter control * +\***********************/ /** * ath5k_ani_set_noise_immunity_level() - Set noise immunity level - * + * @ah: The &struct ath5k_hw * @level: level between 0 and @ATH5K_ANI_MAX_NOISE_IMM_LVL */ void @@ -91,12 +99,11 @@ ath5k_ani_set_noise_immunity_level(struct ath5k_hw *ah, int level) ATH5K_DBG_UNLIMIT(ah, ATH5K_DEBUG_ANI, "new level %d", level); } - /** * ath5k_ani_set_spur_immunity_level() - Set spur immunity level - * + * @ah: The &struct ath5k_hw * @level: level between 0 and @max_spur_level (the maximum level is dependent - * on the chip revision). + * on the chip revision). */ void ath5k_ani_set_spur_immunity_level(struct ath5k_hw *ah, int level) @@ -117,10 +124,9 @@ ath5k_ani_set_spur_immunity_level(struct ath5k_hw *ah, int level) ATH5K_DBG_UNLIMIT(ah, ATH5K_DEBUG_ANI, "new level %d", level); } - /** * ath5k_ani_set_firstep_level() - Set "firstep" level - * + * @ah: The &struct ath5k_hw * @level: level between 0 and @ATH5K_ANI_MAX_FIRSTEP_LVL */ void @@ -140,11 +146,9 @@ ath5k_ani_set_firstep_level(struct ath5k_hw *ah, int level) ATH5K_DBG_UNLIMIT(ah, ATH5K_DEBUG_ANI, "new level %d", level); } - /** - * ath5k_ani_set_ofdm_weak_signal_detection() - Control OFDM weak signal - * detection - * + * ath5k_ani_set_ofdm_weak_signal_detection() - Set OFDM weak signal detection + * @ah: The &struct ath5k_hw * @on: turn on or off */ void @@ -182,10 +186,9 @@ ath5k_ani_set_ofdm_weak_signal_detection(struct ath5k_hw *ah, bool on) on ? "on" : "off"); } - /** - * ath5k_ani_set_cck_weak_signal_detection() - control CCK weak signal detection - * + * ath5k_ani_set_cck_weak_signal_detection() - Set CCK weak signal detection + * @ah: The &struct ath5k_hw * @on: turn on or off */ void @@ -200,13 +203,16 @@ ath5k_ani_set_cck_weak_signal_detection(struct ath5k_hw *ah, bool on) } -/*** ANI algorithm ***/ +/***************\ +* ANI algorithm * +\***************/ /** * ath5k_ani_raise_immunity() - Increase noise immunity - * + * @ah: The &struct ath5k_hw + * @as: The &struct ath5k_ani_state * @ofdm_trigger: If this is true we are called because of too many OFDM errors, - * the algorithm will tune more parameters then. + * the algorithm will tune more parameters then. * * Try to raise noise immunity (=decrease sensitivity) in several steps * depending on the average RSSI of the beacons we received. @@ -290,9 +296,10 @@ ath5k_ani_raise_immunity(struct ath5k_hw *ah, struct ath5k_ani_state *as, */ } - /** * ath5k_ani_lower_immunity() - Decrease noise immunity + * @ah: The &struct ath5k_hw + * @as: The &struct ath5k_ani_state * * Try to lower noise immunity (=increase sensitivity) in several steps * depending on the average RSSI of the beacons we received. @@ -352,9 +359,10 @@ ath5k_ani_lower_immunity(struct ath5k_hw *ah, struct ath5k_ani_state *as) } } - /** * ath5k_hw_ani_get_listen_time() - Update counters and return listening time + * @ah: The &struct ath5k_hw + * @as: The &struct ath5k_ani_state * * Return an approximation of the time spent "listening" in milliseconds (ms) * since the last call of this function. @@ -379,9 +387,10 @@ ath5k_hw_ani_get_listen_time(struct ath5k_hw *ah, struct ath5k_ani_state *as) return listen; } - /** * ath5k_ani_save_and_clear_phy_errors() - Clear and save PHY error counters + * @ah: The &struct ath5k_hw + * @as: The &struct ath5k_ani_state * * Clear the PHY error counters as soon as possible, since this might be called * from a MIB interrupt and we want to make sure we don't get interrupted again. @@ -429,14 +438,14 @@ ath5k_ani_save_and_clear_phy_errors(struct ath5k_hw *ah, return 1; } - /** * ath5k_ani_period_restart() - Restart ANI period + * @as: The &struct ath5k_ani_state * * Just reset counters, so they are clear for the next "ani period". */ static void -ath5k_ani_period_restart(struct ath5k_hw *ah, struct ath5k_ani_state *as) +ath5k_ani_period_restart(struct ath5k_ani_state *as) { /* keep last values for debugging */ as->last_ofdm_errors = as->ofdm_errors; @@ -448,9 +457,9 @@ ath5k_ani_period_restart(struct ath5k_hw *ah, struct ath5k_ani_state *as) as->listen_time = 0; } - /** * ath5k_ani_calibration() - The main ANI calibration function + * @ah: The &struct ath5k_hw * * We count OFDM and CCK errors relative to the time where we did not send or * receive ("listen" time) and raise or lower immunity accordingly. @@ -492,7 +501,7 @@ ath5k_ani_calibration(struct ath5k_hw *ah) /* too many PHY errors - we have to raise immunity */ bool ofdm_flag = as->ofdm_errors > ofdm_high ? true : false; ath5k_ani_raise_immunity(ah, as, ofdm_flag); - ath5k_ani_period_restart(ah, as); + ath5k_ani_period_restart(as); } else if (as->listen_time > 5 * ATH5K_ANI_LISTEN_PERIOD) { /* If more than 5 (TODO: why 5?) periods have passed and we got @@ -504,15 +513,18 @@ ath5k_ani_calibration(struct ath5k_hw *ah) if (as->ofdm_errors <= ofdm_low && as->cck_errors <= cck_low) ath5k_ani_lower_immunity(ah, as); - ath5k_ani_period_restart(ah, as); + ath5k_ani_period_restart(as); } } -/*** INTERRUPT HANDLER ***/ +/*******************\ +* Interrupt handler * +\*******************/ /** * ath5k_ani_mib_intr() - Interrupt handler for ANI MIB counters + * @ah: The &struct ath5k_hw * * Just read & reset the registers quickly, so they don't generate more * interrupts, save the counters and schedule the tasklet to decide whether @@ -549,9 +561,11 @@ ath5k_ani_mib_intr(struct ath5k_hw *ah) tasklet_schedule(&ah->ani_tasklet); } - /** - * ath5k_ani_phy_error_report() - Used by older HW to report PHY errors + * ath5k_ani_phy_error_report - Used by older HW to report PHY errors + * + * @ah: The &struct ath5k_hw + * @phyerr: One of enum ath5k_phy_error_code * * This is used by hardware without PHY error counters to report PHY errors * on a frame-by-frame basis, instead of the interrupt. @@ -574,10 +588,13 @@ ath5k_ani_phy_error_report(struct ath5k_hw *ah, } -/*** INIT ***/ +/****************\ +* Initialization * +\****************/ /** * ath5k_enable_phy_err_counters() - Enable PHY error counters + * @ah: The &struct ath5k_hw * * Enable PHY error counters for OFDM and CCK timing errors. */ @@ -596,9 +613,9 @@ ath5k_enable_phy_err_counters(struct ath5k_hw *ah) ath5k_hw_reg_write(ah, 0, AR5K_CCK_FIL_CNT); } - /** * ath5k_disable_phy_err_counters() - Disable PHY error counters + * @ah: The &struct ath5k_hw * * Disable PHY error counters for OFDM and CCK timing errors. */ @@ -615,10 +632,10 @@ ath5k_disable_phy_err_counters(struct ath5k_hw *ah) ath5k_hw_reg_write(ah, 0, AR5K_CCK_FIL_CNT); } - /** * ath5k_ani_init() - Initialize ANI - * @mode: Which mode to use (auto, manual high, manual low, off) + * @ah: The &struct ath5k_hw + * @mode: One of enum ath5k_ani_mode * * Initialize ANI according to mode. */ @@ -695,10 +712,18 @@ ath5k_ani_init(struct ath5k_hw *ah, enum ath5k_ani_mode mode) } -/*** DEBUG ***/ +/**************\ +* Debug output * +\**************/ #ifdef CONFIG_ATH5K_DEBUG +/** + * ath5k_ani_print_counters() - Print ANI counters + * @ah: The &struct ath5k_hw + * + * Used for debugging ANI + */ void ath5k_ani_print_counters(struct ath5k_hw *ah) { |