diff options
Diffstat (limited to 'drivers/net/wimax/i2400m/i2400m.h')
| -rw-r--r-- | drivers/net/wimax/i2400m/i2400m.h | 82 |
1 files changed, 73 insertions, 9 deletions
diff --git a/drivers/net/wimax/i2400m/i2400m.h b/drivers/net/wimax/i2400m/i2400m.h index 820b128705e..fa74777fd65 100644 --- a/drivers/net/wimax/i2400m/i2400m.h +++ b/drivers/net/wimax/i2400m/i2400m.h @@ -160,6 +160,16 @@ #include <linux/wimax/i2400m.h> #include <asm/byteorder.h> +enum { +/* netdev interface */ + /* + * Out of NWG spec (R1_v1.2.2), 3.3.3 ASN Bearer Plane MTU Size + * + * The MTU is 1400 or less + */ + I2400M_MAX_MTU = 1400, +}; + /* Misc constants */ enum { /* Size of the Boot Mode Command buffer */ @@ -167,6 +177,11 @@ enum { I2400M_BM_ACK_BUF_SIZE = 256, }; +enum { + /* Maximum number of bus reset can be retried */ + I2400M_BUS_RESET_RETRIES = 3, +}; + /** * struct i2400m_poke_table - Hardware poke table for the Intel 2400m * @@ -227,6 +242,11 @@ struct i2400m_barker_db; * so we have a tx_blk_size variable that the bus layer sets to * tell the engine how much of that we need. * + * @bus_tx_room_min: [fill] Minimum room required while allocating + * TX queue's buffer space for message header. SDIO requires + * 224 bytes and USB 16 bytes. Refer bus specific driver code + * for details. + * * @bus_pl_size_max: [fill] Maximum payload size. * * @bus_setup: [optional fill] Function called by the bus-generic code @@ -397,7 +417,7 @@ struct i2400m_barker_db; * * @tx_size_max: biggest TX message sent. * - * @rx_lock: spinlock to protect RX members + * @rx_lock: spinlock to protect RX members and rx_roq_refcount. * * @rx_pl_num: total number of payloads received * @@ -421,6 +441,10 @@ struct i2400m_barker_db; * delivered. Then the driver can release them to the host. See * drivers/net/i2400m/rx.c for details. * + * @rx_roq_refcount: refcount rx_roq. This refcounts any access to + * rx_roq thus preventing rx_roq being destroyed when rx_roq + * is being accessed. rx_roq_refcount is protected by rx_lock. + * * @rx_reports: reports received from the device that couldn't be * processed because the driver wasn't still ready; when ready, * they are pulled from here and chewed. @@ -507,6 +531,38 @@ struct i2400m_barker_db; * same. * * @pm_notifier: used to register for PM events + * + * @bus_reset_retries: counter for the number of bus resets attempted for + * this boot. It's not for tracking the number of bus resets during + * the whole driver life cycle (from insmod to rmmod) but for the + * number of dev_start() executed until dev_start() returns a success + * (ie: a good boot means a dev_stop() followed by a successful + * dev_start()). dev_reset_handler() increments this counter whenever + * it is triggering a bus reset. It checks this counter to decide if a + * subsequent bus reset should be retried. dev_reset_handler() retries + * the bus reset until dev_start() succeeds or the counter reaches + * I2400M_BUS_RESET_RETRIES. The counter is cleared to 0 in + * dev_reset_handle() when dev_start() returns a success, + * ie: a successul boot is completed. + * + * @alive: flag to denote if the device *should* be alive. This flag is + * everything like @updown (see doc for @updown) except reflecting + * the device state *we expect* rather than the actual state as denoted + * by @updown. It is set 1 whenever @updown is set 1 in dev_start(). + * Then the device is expected to be alive all the time + * (i2400m->alive remains 1) until the driver is removed. Therefore + * all the device reboot events detected can be still handled properly + * by either dev_reset_handle() or .pre_reset/.post_reset as long as + * the driver presents. It is set 0 along with @updown in dev_stop(). + * + * @error_recovery: flag to denote if we are ready to take an error recovery. + * 0 for ready to take an error recovery; 1 for not ready. It is + * initialized to 1 while probe() since we don't tend to take any error + * recovery during probe(). It is decremented by 1 whenever dev_start() + * succeeds to indicate we are ready to take error recovery from now on. + * It is checked every time we wanna schedule an error recovery. If an + * error recovery is already in place (error_recovery was set 1), we + * should not schedule another one until the last one is done. */ struct i2400m { struct wimax_dev wimax_dev; /* FIRST! See doc */ @@ -522,6 +578,7 @@ struct i2400m { wait_queue_head_t state_wq; /* Woken up when on state updates */ size_t bus_tx_block_size; + size_t bus_tx_room_min; size_t bus_pl_size_max; unsigned bus_bm_retries; @@ -550,10 +607,12 @@ struct i2400m { tx_num, tx_size_acc, tx_size_min, tx_size_max; /* RX stuff */ - spinlock_t rx_lock; /* protect RX state */ + /* protect RX state and rx_roq_refcount */ + spinlock_t rx_lock; unsigned rx_pl_num, rx_pl_max, rx_pl_min, rx_num, rx_size_acc, rx_size_min, rx_size_max; - struct i2400m_roq *rx_roq; /* not under rx_lock! */ + struct i2400m_roq *rx_roq; /* access is refcounted */ + struct kref rx_roq_refcount; /* refcount access to rx_roq */ u8 src_mac_addr[ETH_HLEN]; struct list_head rx_reports; /* under rx_lock! */ struct work_struct rx_report_ws; @@ -581,6 +640,16 @@ struct i2400m { struct i2400m_barker_db *barker; struct notifier_block pm_notifier; + + /* counting bus reset retries in this boot */ + atomic_t bus_reset_retries; + + /* if the device is expected to be alive */ + unsigned alive; + + /* 0 if we are ready for error recovery; 1 if not ready */ + atomic_t error_recovery; + }; @@ -803,6 +872,7 @@ void i2400m_put(struct i2400m *i2400m) extern int i2400m_dev_reset_handle(struct i2400m *, const char *); extern int i2400m_pre_reset(struct i2400m *); extern int i2400m_post_reset(struct i2400m *); +extern void i2400m_error_recovery(struct i2400m *); /* * _setup()/_release() are called by the probe/disconnect functions of @@ -815,7 +885,6 @@ extern int i2400m_rx(struct i2400m *, struct sk_buff *); extern struct i2400m_msg_hdr *i2400m_tx_msg_get(struct i2400m *, size_t *); extern void i2400m_tx_msg_sent(struct i2400m *); -extern int i2400m_power_save_disabled; /* * Utility functions @@ -922,10 +991,5 @@ extern int i2400m_barker_db_init(const char *); extern void i2400m_barker_db_exit(void); -/* Module parameters */ - -extern int i2400m_idle_mode_disabled; -extern int i2400m_rx_reorder_disabled; - #endif /* #ifndef __I2400M_H__ */ |