aboutsummaryrefslogtreecommitdiff
path: root/drivers/net/ne.c
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/net/ne.c')
-rw-r--r--drivers/net/ne.c33
1 files changed, 20 insertions, 13 deletions
diff --git a/drivers/net/ne.c b/drivers/net/ne.c
index 08b218c5bfb..b32765215f7 100644
--- a/drivers/net/ne.c
+++ b/drivers/net/ne.c
@@ -139,8 +139,9 @@ bad_clone_list[] __initdata = {
#if defined(CONFIG_PLAT_MAPPI)
# define DCR_VAL 0x4b
-#elif defined(CONFIG_PLAT_OAKS32R)
-# define DCR_VAL 0x48
+#elif defined(CONFIG_PLAT_OAKS32R) || \
+ defined(CONFIG_TOSHIBA_RBTX4927) || defined(CONFIG_TOSHIBA_RBTX4938)
+# define DCR_VAL 0x48 /* 8-bit mode */
#else
# define DCR_VAL 0x49
#endif
@@ -226,7 +227,7 @@ struct net_device * __init ne_probe(int unit)
netdev_boot_setup_check(dev);
#ifdef CONFIG_TOSHIBA_RBTX4938
- dev->base_addr = 0x07f20280;
+ dev->base_addr = RBTX4938_RTL_8019_BASE;
dev->irq = RBTX4938_RTL_8019_IRQ;
#endif
err = do_ne_probe(dev);
@@ -396,10 +397,22 @@ static int __init ne_probe1(struct net_device *dev, int ioaddr)
/* We must set the 8390 for word mode. */
outb_p(DCR_VAL, ioaddr + EN0_DCFG);
start_page = NESM_START_PG;
- stop_page = NESM_STOP_PG;
+
+ /*
+ * Realtek RTL8019AS datasheet says that the PSTOP register
+ * shouldn't exceed 0x60 in 8-bit mode.
+ * This chip can be identified by reading the signature from
+ * the remote byte count registers (otherwise write-only)...
+ */
+ if ((DCR_VAL & 0x01) == 0 && /* 8-bit mode */
+ inb(ioaddr + EN0_RCNTLO) == 0x50 &&
+ inb(ioaddr + EN0_RCNTHI) == 0x70)
+ stop_page = 0x60;
+ else
+ stop_page = NESM_STOP_PG;
} else {
start_page = NE1SM_START_PG;
- stop_page = NE1SM_STOP_PG;
+ stop_page = NE1SM_STOP_PG;
}
#if defined(CONFIG_PLAT_MAPPI) || defined(CONFIG_PLAT_OAKS32R)
@@ -509,15 +522,9 @@ static int __init ne_probe1(struct net_device *dev, int ioaddr)
ei_status.name = name;
ei_status.tx_start_page = start_page;
ei_status.stop_page = stop_page;
-#if defined(CONFIG_TOSHIBA_RBTX4927) || defined(CONFIG_TOSHIBA_RBTX4938)
- wordlength = 1;
-#endif
-#ifdef CONFIG_PLAT_OAKS32R
- ei_status.word16 = 0;
-#else
- ei_status.word16 = (wordlength == 2);
-#endif
+ /* Use 16-bit mode only if this wasn't overridden by DCR_VAL */
+ ei_status.word16 = (wordlength == 2 && (DCR_VAL & 0x01));
ei_status.rx_start_page = start_page + TX_PAGES;
#ifdef PACKETBUF_MEMSIZE