diff options
Diffstat (limited to 'drivers/net/igb/igb_main.c')
| -rw-r--r-- | drivers/net/igb/igb_main.c | 91 |
1 files changed, 50 insertions, 41 deletions
diff --git a/drivers/net/igb/igb_main.c b/drivers/net/igb/igb_main.c index 0dfd1b93829..18fccf91363 100644 --- a/drivers/net/igb/igb_main.c +++ b/drivers/net/igb/igb_main.c @@ -45,6 +45,7 @@ #include <linux/interrupt.h> #include <linux/if_ether.h> #include <linux/aer.h> +#include <linux/prefetch.h> #ifdef CONFIG_IGB_DCA #include <linux/dca.h> #endif @@ -3532,6 +3533,25 @@ bool igb_has_link(struct igb_adapter *adapter) return link_active; } +static bool igb_thermal_sensor_event(struct e1000_hw *hw, u32 event) +{ + bool ret = false; + u32 ctrl_ext, thstat; + + /* check for thermal sensor event on i350, copper only */ + if (hw->mac.type == e1000_i350) { + thstat = rd32(E1000_THSTAT); + ctrl_ext = rd32(E1000_CTRL_EXT); + + if ((hw->phy.media_type == e1000_media_type_copper) && + !(ctrl_ext & E1000_CTRL_EXT_LINK_MODE_SGMII)) { + ret = !!(thstat & event); + } + } + + return ret; +} + /** * igb_watchdog - Timer Call-back * @data: pointer to adapter cast into an unsigned long @@ -3550,7 +3570,7 @@ static void igb_watchdog_task(struct work_struct *work) watchdog_task); struct e1000_hw *hw = &adapter->hw; struct net_device *netdev = adapter->netdev; - u32 link, ctrl_ext, thstat; + u32 link; int i; link = igb_has_link(adapter); @@ -3574,25 +3594,14 @@ static void igb_watchdog_task(struct work_struct *work) ((ctrl & E1000_CTRL_RFCE) ? "RX" : ((ctrl & E1000_CTRL_TFCE) ? "TX" : "None"))); - /* check for thermal sensor event on i350, - * copper only */ - if (hw->mac.type == e1000_i350) { - thstat = rd32(E1000_THSTAT); - ctrl_ext = rd32(E1000_CTRL_EXT); - if ((hw->phy.media_type == - e1000_media_type_copper) && !(ctrl_ext & - E1000_CTRL_EXT_LINK_MODE_SGMII)) { - if (thstat & - E1000_THSTAT_LINK_THROTTLE) { - printk(KERN_INFO "igb: %s The " - "network adapter link " - "speed was downshifted " - "because it " - "overheated.\n", - netdev->name); - } - } + /* check for thermal sensor event */ + if (igb_thermal_sensor_event(hw, E1000_THSTAT_LINK_THROTTLE)) { + printk(KERN_INFO "igb: %s The network adapter " + "link speed was downshifted " + "because it overheated.\n", + netdev->name); } + /* adjust timeout factor according to speed/duplex */ adapter->tx_timeout_factor = 1; switch (adapter->link_speed) { @@ -3618,22 +3627,15 @@ static void igb_watchdog_task(struct work_struct *work) if (netif_carrier_ok(netdev)) { adapter->link_speed = 0; adapter->link_duplex = 0; - /* check for thermal sensor event on i350 - * copper only*/ - if (hw->mac.type == e1000_i350) { - thstat = rd32(E1000_THSTAT); - ctrl_ext = rd32(E1000_CTRL_EXT); - if ((hw->phy.media_type == - e1000_media_type_copper) && !(ctrl_ext & - E1000_CTRL_EXT_LINK_MODE_SGMII)) { - if (thstat & E1000_THSTAT_PWR_DOWN) { - printk(KERN_ERR "igb: %s The " - "network adapter was stopped " - "because it overheated.\n", + + /* check for thermal sensor event */ + if (igb_thermal_sensor_event(hw, E1000_THSTAT_PWR_DOWN)) { + printk(KERN_ERR "igb: %s The network adapter " + "was stopped because it " + "overheated.\n", netdev->name); - } - } } + /* Links status message must follow this format */ printk(KERN_INFO "igb: %s NIC Link is Down\n", netdev->name); @@ -6348,21 +6350,25 @@ static void igb_restore_vlan(struct igb_adapter *adapter) } } -int igb_set_spd_dplx(struct igb_adapter *adapter, u16 spddplx) +int igb_set_spd_dplx(struct igb_adapter *adapter, u32 spd, u8 dplx) { struct pci_dev *pdev = adapter->pdev; struct e1000_mac_info *mac = &adapter->hw.mac; mac->autoneg = 0; + /* Make sure dplx is at most 1 bit and lsb of speed is not set + * for the switch() below to work */ + if ((spd & 1) || (dplx & ~1)) + goto err_inval; + /* Fiber NIC's only allow 1000 Gbps Full duplex */ if ((adapter->hw.phy.media_type == e1000_media_type_internal_serdes) && - spddplx != (SPEED_1000 + DUPLEX_FULL)) { - dev_err(&pdev->dev, "Unsupported Speed/Duplex configuration\n"); - return -EINVAL; - } + spd != SPEED_1000 && + dplx != DUPLEX_FULL) + goto err_inval; - switch (spddplx) { + switch (spd + dplx) { case SPEED_10 + DUPLEX_HALF: mac->forced_speed_duplex = ADVERTISE_10_HALF; break; @@ -6381,10 +6387,13 @@ int igb_set_spd_dplx(struct igb_adapter *adapter, u16 spddplx) break; case SPEED_1000 + DUPLEX_HALF: /* not supported */ default: - dev_err(&pdev->dev, "Unsupported Speed/Duplex configuration\n"); - return -EINVAL; + goto err_inval; } return 0; + +err_inval: + dev_err(&pdev->dev, "Unsupported Speed/Duplex configuration\n"); + return -EINVAL; } static int __igb_shutdown(struct pci_dev *pdev, bool *enable_wake) |