diff options
Diffstat (limited to 'drivers/net/bnx2.c')
-rw-r--r-- | drivers/net/bnx2.c | 75 |
1 files changed, 45 insertions, 30 deletions
diff --git a/drivers/net/bnx2.c b/drivers/net/bnx2.c index a1a3d0e5d2b..0e2218dadb3 100644 --- a/drivers/net/bnx2.c +++ b/drivers/net/bnx2.c @@ -57,8 +57,8 @@ #define DRV_MODULE_NAME "bnx2" #define PFX DRV_MODULE_NAME ": " -#define DRV_MODULE_VERSION "1.8.1" -#define DRV_MODULE_RELDATE "Oct 7, 2008" +#define DRV_MODULE_VERSION "1.8.2" +#define DRV_MODULE_RELDATE "Nov 10, 2008" #define RUN_AT(x) (jiffies + (x)) @@ -89,6 +89,7 @@ typedef enum { BCM5709, BCM5709S, BCM5716, + BCM5716S, } board_t; /* indexed by board_t, above */ @@ -105,6 +106,7 @@ static struct { { "Broadcom NetXtreme II BCM5709 1000Base-T" }, { "Broadcom NetXtreme II BCM5709 1000Base-SX" }, { "Broadcom NetXtreme II BCM5716 1000Base-T" }, + { "Broadcom NetXtreme II BCM5716 1000Base-SX" }, }; static DEFINE_PCI_DEVICE_TABLE(bnx2_pci_tbl) = { @@ -128,6 +130,8 @@ static DEFINE_PCI_DEVICE_TABLE(bnx2_pci_tbl) = { PCI_ANY_ID, PCI_ANY_ID, 0, 0, BCM5709S }, { PCI_VENDOR_ID_BROADCOM, 0x163b, PCI_ANY_ID, PCI_ANY_ID, 0, 0, BCM5716 }, + { PCI_VENDOR_ID_BROADCOM, 0x163c, + PCI_ANY_ID, PCI_ANY_ID, 0, 0, BCM5716 }, { 0, } }; @@ -1652,7 +1656,7 @@ bnx2_setup_serdes_phy(struct bnx2 *bp, u8 port) * exchanging base pages plus 3 next pages and * normally completes in about 120 msec. */ - bp->current_interval = SERDES_AN_TIMEOUT; + bp->current_interval = BNX2_SERDES_AN_TIMEOUT; bp->serdes_an_pending = 1; mod_timer(&bp->timer, jiffies + bp->current_interval); } else { @@ -2274,7 +2278,7 @@ bnx2_fw_sync(struct bnx2 *bp, u32 msg_data, int ack, int silent) return 0; /* wait for an acknowledgement. */ - for (i = 0; i < (FW_ACK_TIME_OUT_MS / 10); i++) { + for (i = 0; i < (BNX2_FW_ACK_TIME_OUT_MS / 10); i++) { msleep(10); val = bnx2_shmem_rd(bp, BNX2_FW_MB); @@ -3000,7 +3004,6 @@ bnx2_rx_int(struct bnx2 *bp, struct bnx2_napi *bnapi, int budget) #endif netif_receive_skb(skb); - bp->dev->last_rx = jiffies; rx_pkt++; next_rx: @@ -4493,7 +4496,7 @@ bnx2_reset_chip(struct bnx2 *bp, u32 reset_code) static int bnx2_init_chip(struct bnx2 *bp) { - u32 val; + u32 val, mtu; int rc, i; /* Make sure the interrupt is not active. */ @@ -4585,11 +4588,19 @@ bnx2_init_chip(struct bnx2 *bp) REG_WR(bp, BNX2_EMAC_BACKOFF_SEED, val); /* Program the MTU. Also include 4 bytes for CRC32. */ - val = bp->dev->mtu + ETH_HLEN + 4; + mtu = bp->dev->mtu; + val = mtu + ETH_HLEN + ETH_FCS_LEN; if (val > (MAX_ETHERNET_PACKET_SIZE + 4)) val |= BNX2_EMAC_RX_MTU_SIZE_JUMBO_ENA; REG_WR(bp, BNX2_EMAC_RX_MTU_SIZE, val); + if (mtu < 1500) + mtu = 1500; + + bnx2_reg_wr_ind(bp, BNX2_RBUF_CONFIG, BNX2_RBUF_CONFIG_VAL(mtu)); + bnx2_reg_wr_ind(bp, BNX2_RBUF_CONFIG2, BNX2_RBUF_CONFIG2_VAL(mtu)); + bnx2_reg_wr_ind(bp, BNX2_RBUF_CONFIG3, BNX2_RBUF_CONFIG3_VAL(mtu)); + for (i = 0; i < BNX2_MAX_MSIX_VEC; i++) bp->bnx2_napi[i].last_status_idx = 0; @@ -5719,7 +5730,7 @@ bnx2_5708_serdes_timer(struct bnx2 *bp) bnx2_read_phy(bp, bp->mii_bmcr, &bmcr); if (bmcr & BMCR_ANENABLE) { bnx2_enable_forced_2g5(bp); - bp->current_interval = SERDES_FORCED_TIMEOUT; + bp->current_interval = BNX2_SERDES_FORCED_TIMEOUT; } else { bnx2_disable_forced_2g5(bp); bp->serdes_an_pending = 2; @@ -6173,7 +6184,7 @@ bnx2_get_stats(struct net_device *dev) { struct bnx2 *bp = netdev_priv(dev); struct statistics_block *stats_blk = bp->stats_blk; - struct net_device_stats *net_stats = &bp->net_stats; + struct net_device_stats *net_stats = &dev->stats; if (bp->stats_blk == NULL) { return net_stats; @@ -6540,7 +6551,7 @@ bnx2_nway_reset(struct net_device *dev) spin_lock_bh(&bp->phy_lock); - bp->current_interval = SERDES_AN_TIMEOUT; + bp->current_interval = BNX2_SERDES_AN_TIMEOUT; bp->serdes_an_pending = 1; mod_timer(&bp->timer, jiffies + bp->current_interval); } @@ -7615,7 +7626,8 @@ bnx2_init_board(struct pci_dev *pdev, struct net_device *dev) if ((CHIP_ID(bp) == CHIP_ID_5708_A0) || (CHIP_ID(bp) == CHIP_ID_5708_B0) || - (CHIP_ID(bp) == CHIP_ID_5708_B1)) { + (CHIP_ID(bp) == CHIP_ID_5708_B1) || + !(REG_RD(bp, BNX2_PCI_CONFIG_3) & BNX2_PCI_CONFIG_3_VAUX_PRESET)) { bp->flags |= BNX2_FLAG_NO_WOL; bp->wol = 0; } @@ -7724,6 +7736,25 @@ bnx2_init_napi(struct bnx2 *bp) } } +static const struct net_device_ops bnx2_netdev_ops = { + .ndo_open = bnx2_open, + .ndo_start_xmit = bnx2_start_xmit, + .ndo_stop = bnx2_close, + .ndo_get_stats = bnx2_get_stats, + .ndo_set_rx_mode = bnx2_set_rx_mode, + .ndo_do_ioctl = bnx2_ioctl, + .ndo_validate_addr = eth_validate_addr, + .ndo_set_mac_address = bnx2_change_mac_addr, + .ndo_change_mtu = bnx2_change_mtu, + .ndo_tx_timeout = bnx2_tx_timeout, +#ifdef BCM_VLAN + .ndo_vlan_rx_register = bnx2_vlan_rx_register, +#endif +#if defined(HAVE_POLL_CONTROLLER) || defined(CONFIG_NET_POLL_CONTROLLER) + .ndo_poll_controller = poll_bnx2, +#endif +}; + static int __devinit bnx2_init_one(struct pci_dev *pdev, const struct pci_device_id *ent) { @@ -7732,7 +7763,6 @@ bnx2_init_one(struct pci_dev *pdev, const struct pci_device_id *ent) struct bnx2 *bp; int rc; char str[40]; - DECLARE_MAC_BUF(mac); if (version_printed++ == 0) printk(KERN_INFO "%s", version); @@ -7749,28 +7779,13 @@ bnx2_init_one(struct pci_dev *pdev, const struct pci_device_id *ent) return rc; } - dev->open = bnx2_open; - dev->hard_start_xmit = bnx2_start_xmit; - dev->stop = bnx2_close; - dev->get_stats = bnx2_get_stats; - dev->set_rx_mode = bnx2_set_rx_mode; - dev->do_ioctl = bnx2_ioctl; - dev->set_mac_address = bnx2_change_mac_addr; - dev->change_mtu = bnx2_change_mtu; - dev->tx_timeout = bnx2_tx_timeout; + dev->netdev_ops = &bnx2_netdev_ops; dev->watchdog_timeo = TX_TIMEOUT; -#ifdef BCM_VLAN - dev->vlan_rx_register = bnx2_vlan_rx_register; -#endif dev->ethtool_ops = &bnx2_ethtool_ops; bp = netdev_priv(dev); bnx2_init_napi(bp); -#if defined(HAVE_POLL_CONTROLLER) || defined(CONFIG_NET_POLL_CONTROLLER) - dev->poll_controller = poll_bnx2; -#endif - pci_set_drvdata(pdev, dev); memcpy(dev->dev_addr, bp->mac_addr, 6); @@ -7799,14 +7814,14 @@ bnx2_init_one(struct pci_dev *pdev, const struct pci_device_id *ent) } printk(KERN_INFO "%s: %s (%c%d) %s found at mem %lx, " - "IRQ %d, node addr %s\n", + "IRQ %d, node addr %pM\n", dev->name, board_info[ent->driver_data].name, ((CHIP_ID(bp) & 0xf000) >> 12) + 'A', ((CHIP_ID(bp) & 0x0ff0) >> 4), bnx2_bus_string(bp, str), dev->base_addr, - bp->pdev->irq, print_mac(mac, dev->dev_addr)); + bp->pdev->irq, dev->dev_addr); return 0; } |