diff options
Diffstat (limited to 'drivers/isdn/hardware/mISDN/hfc_multi.h')
| -rw-r--r-- | drivers/isdn/hardware/mISDN/hfc_multi.h | 45 |
1 files changed, 35 insertions, 10 deletions
diff --git a/drivers/isdn/hardware/mISDN/hfc_multi.h b/drivers/isdn/hardware/mISDN/hfc_multi.h index c4878cc712c..0c773866efc 100644 --- a/drivers/isdn/hardware/mISDN/hfc_multi.h +++ b/drivers/isdn/hardware/mISDN/hfc_multi.h @@ -17,6 +17,16 @@ #define PCI_ENA_REGIO 0x01 #define PCI_ENA_MEMIO 0x02 +#define XHFC_IRQ 4 /* SIU_IRQ2 */ +#define XHFC_MEMBASE 0xFE000000 +#define XHFC_MEMSIZE 0x00001000 +#define XHFC_OFFSET 0x00001000 +#define PA_XHFC_A0 0x0020 /* PA10 */ +#define PB_XHFC_IRQ1 0x00000100 /* PB23 */ +#define PB_XHFC_IRQ2 0x00000200 /* PB22 */ +#define PB_XHFC_IRQ3 0x00000400 /* PB21 */ +#define PB_XHFC_IRQ4 0x00000800 /* PB20 */ + /* * NOTE: some registers are assigned multiple times due to different modes * also registers are assigned differen for HFC-4s/8s and HFC-E1 @@ -81,6 +91,11 @@ struct hfcm_hw { #define HFC_CFG_CRC4 10 /* disable CRC-4 Multiframe mode, */ /* use double frame instead. */ +#define HFC_TYPE_E1 1 /* controller is HFC-E1 */ +#define HFC_TYPE_4S 4 /* controller is HFC-4S */ +#define HFC_TYPE_8S 8 /* controller is HFC-8S */ +#define HFC_TYPE_XHFC 5 /* controller is XHFC */ + #define HFC_CHIP_EXRAM_128 0 /* external ram 128k */ #define HFC_CHIP_EXRAM_512 1 /* external ram 256k */ #define HFC_CHIP_REVISION0 2 /* old fifo handling */ @@ -88,19 +103,22 @@ struct hfcm_hw { #define HFC_CHIP_PCM_MASTER 4 /* PCM is master */ #define HFC_CHIP_RX_SYNC 5 /* disable pll sync for pcm */ #define HFC_CHIP_DTMF 6 /* DTMF decoding is enabled */ -#define HFC_CHIP_ULAW 7 /* ULAW mode */ -#define HFC_CHIP_CLOCK2 8 /* double clock mode */ -#define HFC_CHIP_E1CLOCK_GET 9 /* always get clock from E1 interface */ -#define HFC_CHIP_E1CLOCK_PUT 10 /* always put clock from E1 interface */ -#define HFC_CHIP_WATCHDOG 11 /* whether we should send signals */ +#define HFC_CHIP_CONF 7 /* conference handling is enabled */ +#define HFC_CHIP_ULAW 8 /* ULAW mode */ +#define HFC_CHIP_CLOCK2 9 /* double clock mode */ +#define HFC_CHIP_E1CLOCK_GET 10 /* always get clock from E1 interface */ +#define HFC_CHIP_E1CLOCK_PUT 11 /* always put clock from E1 interface */ +#define HFC_CHIP_WATCHDOG 12 /* whether we should send signals */ /* to the watchdog */ -#define HFC_CHIP_B410P 12 /* whether we have a b410p with echocan in */ +#define HFC_CHIP_B410P 13 /* whether we have a b410p with echocan in */ /* hw */ -#define HFC_CHIP_PLXSD 13 /* whether we have a Speech-Design PLX */ +#define HFC_CHIP_PLXSD 14 /* whether we have a Speech-Design PLX */ +#define HFC_CHIP_EMBSD 15 /* whether we have a SD Embedded board */ #define HFC_IO_MODE_PCIMEM 0x00 /* normal memory mapped IO */ #define HFC_IO_MODE_REGIO 0x01 /* PCI io access */ #define HFC_IO_MODE_PLXSD 0x02 /* access HFC via PLX9030 */ +#define HFC_IO_MODE_EMBSD 0x03 /* direct access */ /* table entry in the PCI devices list */ struct hm_map { @@ -113,6 +131,7 @@ struct hm_map { int opticalsupport; int dip_type; int io_mode; + int irq; }; struct hfc_multi { @@ -120,7 +139,7 @@ struct hfc_multi { struct hm_map *mtyp; int id; int pcm; /* id of pcm bus */ - int type; + int ctype; /* controller type */ int ports; u_int irq; /* irq used by card */ @@ -160,10 +179,16 @@ struct hfc_multi { int len); void (*write_fifo)(struct hfc_multi *hc, u_char *data, int len); - u_long pci_origmembase, plx_origmembase, dsp_origmembase; + u_long pci_origmembase, plx_origmembase; void __iomem *pci_membase; /* PCI memory */ void __iomem *plx_membase; /* PLX memory */ - u_char *dsp_membase; /* DSP on PLX */ + u_long xhfc_origmembase; + u_char *xhfc_membase; + u_long *xhfc_memaddr, *xhfc_memdata; +#ifdef CONFIG_MISDN_HFCMULTI_8xx + struct immap *immap; +#endif + u_long pb_irqmsk; /* Portbit mask to check the IRQ line */ u_long pci_iobase; /* PCI IO */ struct hfcm_hw hw; /* remember data of write-only-registers */ |